46,626 research outputs found
Effects of state recovery on creep buckling under variable loading
Structural alloys embody internal mechanisms that allow recovery of state with varying stress and elevated temperature, i.e., they can return to a softer state following periods of hardening. Such material behavior is known to strongly influence structural response under some important thermomechanical loadings, for example, that involving thermal ratchetting. The influence of dynamic and thermal recovery on the creep buckling of a column under variable loading is investigated. The column is taken as the idealized (Shanley) sandwich column. The constitutive model, unlike the commonly employed Norton creep model, incorporates a representation of both dynamic and thermal (state) recovery. The material parameters of the constitutive model are chosen to characterize Narloy Z, a representative copper alloy used in thrust nozzle liners of reusable rocket engines. Variable loading histories include rapid cyclic unloading/reloading sequences and intermittent reductions of load for extended periods of time; these are superimposed on a constant load. The calculated results show that state recovery significantly affects creep buckling under variable loading. Structural alloys embody internal mechanisms that allow recovery of state with varying stress and time
The expected background spectrum in NaI dark matter detectors and the DAMA result
Detailed Monte Carlo simulations of the expected radioactive background rates
and spectra in NaI crystals are presented. The obtained spectra are then
compared to those measured in the DAMA/NaI and DAMA/LIBRA experiments. The
simulations can be made consistent with the measured DAMA spectrum only by
assuming higher than reported concentrations of some isotopes and even so leave
very little room for the dark matter signal. We conclude that any
interpretation of the annual modulation of the event rate observed by DAMA as a
dark matter signal, should include full consideration of the background
spectrum. This would significantly restrict the range of dark matter models
capable of explaining the modulation effect.Comment: 17 pages, 6 figure
Designing a Green Roof for Ireland
A model is presented for the gravity-driven flow of rainwater descending through the soil layer of a green roof, treated as a porous medium on a at permeable surface representing an efficient drainage layer. A fully saturated zone is shown to occur. It is typically a thin layer, relative to the total soil thickness, and lies at the bottom of the soil layer. This provides a bottom boundary condition for the partially saturated upper zone. It is shown that after the onset of rainfall, well-defined fronts of water can descend through the soil layer. Also the rainwater flow is relatively quick compared with the moisture uptake by the roots of the plants in the roof. In a separate model the exchanges of water are described between the (smaller-scale) porous granules of soil, the roots and the rainwater in the inter-granule pores
Age and Dust Degeneracy for Starburst Galaxies Solved?
A spectral evolution model of galaxies that includes both stellar and dust
effects is newly built. xApplying the model to 22 nearby starburst galaxies, we
have shown that far infrared luminosity of galaxies helps to break the
age-dustiness degeneracy. We have derived a unique solution of age and the
dustiness for each starburst galaxy. The resulting starburst ages and optical
depths are in the range and , respectively. The result is robust and is almost independent of model
assumptions such as dust distributions, extinction curves, and burst strengths.
With the rapidly growing sensitivity of submillimeter detectors, it should
become possible in the near future to determine the age and of
star-forming galaxies at redshifts and beyond. Accurate estimates
of for Lyman-break galaxies and high-z galaxies might require a
substantial revision of the previously claimed picture of star formation
history over the Hubble time.Comment: Latex (aas2pp4) 15 pages, 1 table, 6 figures. Accepted for Ap
Unified Viscoplastic Behavior of Metal Matrix Composites
The need for unified constitutive models was recognized more than a decade ago in the results of phenomenological tests on monolithic metals that exhibited strong creep-plasticity interaction. Recently, metallic alloys have been combined to form high-temperature ductile/ductile composite materials, raising the natural question of whether these metallic composites exhibit the same phenomenological features as their monolithic constituents. This question is addressed in the context of a limited, yet definite (to illustrate creep/plasticity interaction) set of experimental data on the model metal matrix composite (MMC) system W/Kanthal. Furthermore, it is demonstrated that a unified viscoplastic representation, extended for unidirectional composites and correlated to W/Kanthal, can accurately predict the observed longitudinal composite creep/plasticity interaction response and strain rate dependency. Finally, the predicted influence of fiber orientation on the creep response of W/Kanthal is illustrated
Creep and creep rupture of strongly reinforced metallic composites
A creep and creep damage theory is presented for metallic composites with strong fibers. Application is to reinforced structures in which the fiber orientation may vary throughout but a distinct fiber direction can be identified locally (local transverse isotropy). The creep deformation model follows earlier work and is based on a flow potential function that depends on invariants reflecting stress and the material symmetry. As the focus is on the interaction of creep and damage, primary creep is ignored. The creep rupture model is an extension of continuum damage mechanics and includes an isochronous damage function that depends on invariants specifying the local maximum transverse tension and the maximum longitudinal shear stress. It is posited that at high temperature and low stress, appropriate to engineering practice, these stress components damage the fiber/matrix interface through diffusion controlled void growth, eventually causing creep rupture. Experiments are outlined for characterizing a composite through creep rupture tests under transverse tension and longitudinal shear. Application is made to a thin-walled pressure vessel with reinforcing fibers at an arbitrary helical angle. The results illustrate the usefulness of the model as a means of achieving optimal designs of composite structures where creep and creep rupture are life limiting
A middleware for a large array of cameras
Large arrays of cameras are increasingly being employed for producing high quality image sequences needed for motion analysis research. This leads to the logistical problem with coordination and control of a large number of cameras. In this paper, we used a lightweight multi-agent system for coordinating such camera arrays. The agent framework provides more than a remote sensor access API. It allows reconfigurable and transparent access to cameras, as well as software agents capable of intelligent processing. Furthermore, it eases maintenance by encouraging code reuse. Additionally, our agent system includes an automatic discovery mechanism at startup, and multiple language bindings. Performance tests showed the lightweight nature of the framework while validating its correctness and scalability. Two different camera agents were implemented to provide access to a large array of distributed cameras. Correct operation of these camera agents was confirmed via several image processing agents
The star-formation history of the universe - an infrared perspective
A simple and versatile parameterized approach to the star formation history
allows a quantitative investigation of the constraints from far infrared and
submillimetre counts and background intensity measurements.
The models include four spectral components: infrared cirrus (emission from
interstellar dust), an M82-like starburst, an Arp220-like starburst and an AGN
dust torus. The 60 m luminosity function is determined for each chosen
rate of evolution using the PSCz redshift data for 15000 galaxies. The
proportions of each spectral type as a function of 60 m luminosity are
chosen for consistency with IRAS and SCUBA colour-luminosity relations, and
with the fraction of AGN as a function of luminosity found in 12 m
samples. The luminosity function for each component at any wavelength can then
be calculated from the assumed spectral energy distributions. With assumptions
about the optical seds corresponding to each component and, for the AGN
component, the optical and near infrared counts can be accurately modelled.
A good fit to the observed counts at 0.44, 2.2, 15, 60, 90, 175 and 850
m can be found with pure luminosity evolution in all 3 cosmological models
investigated: = 1, = 0.3 ( = 0), and
= 0.3, = 0.7.
All 3 models also give an acceptable fit to the integrated background
spectrum. Selected predictions of the models, for example redshift
distributions for each component at selected wavelengths and fluxes, are shown.
The total mass-density of stars generated is consistent with that observed,
in all 3 cosmological models.Comment: 20 pages, 25 figures. Accepted for publication in ApJ. Full details
of models can be found at http://astro.ic.ac.uk/~mrr/countmodel
Lagrange Model for the Chiral Optical Properties of Stereometamaterials
We employ a general Lagrange model to describe the chiral optical properties
of stereometamaterials. We derive the elliptical eigenstates of a twisted
stacked split-ring resonator, taking phase retardation into account. Through
this approach, we obtain a powerful Jones matrix formalism which can be used to
calculate the polarization rotation, ellipticity, and circular dichroism of
transmitted waves through stereometamaterials at any incident polarization. Our
experimental measurements agree well with our model.Comment: 10 pages, 3 figures, Theory and experimen
- …