Influencia de la longitud de la biela en la eficiencia y biomecánica del pedaleo submáximo

El principal objetivo de este estudio es analizar el efecto de pequeños cambios en la longitud de la biela en el gasto energético y la técnica de pedaleo submáximo. Participaron 12 ciclistas de fondo en carretera bien entrenados, que realizaron pruebas de pedaleo a tres potencias con cadencia estable, utilizando tres longitudes de biela (en orden aleatorio). Sus bicicletas fueron exactamente reproducidas en un ergómetro que medía el torque ejercido sobre la biela izquierda y derecha de forma independiente. Simultáneamente se registró cinemática 2D de la pierna derecha y el gasto energético al pedalear (eficiencia gruesa). Los resultados muestran que los cambios en la longitud de la biela no tuvieron efecto en la eficiencia gruesa, pero sí en las variables biomecánicas. Una biela de mayor longitud provocó una pérdida de eficiencia mecánica y un aumento en la flexión y el rango de movimiento de la cadera y la rodilla, sin cambios en el tobillo. Aunque estos cambios no fueron lo suficientemente importantes para alterar la eficiencia gruesa, sí que podrían tener implicaciones negativas a largo plazo (peor técnica de pedaleo y riesgo de lesión). En conclusión, el efecto de pequeños cambios en la longitud de la biela, que serían asumibles por ciclistas de competición, producen alteraciones en la biomecánica de pedaleo, pero no en su eficiencia gruesa. Futuros estudios deben abordar los efectos a largo plazo de estos cambios.The main purpose of this study was to analyze the effects of small changes in crank length on gross efficiency and pedaling technique during submaximal cycling. Twelve well-trained road cyclists participated. They pedaled at three power outputs and steady cadence with three crank lengths (in a randomized order). Their bicycles were exactly reproduced on an ergometer where crank torque of the left and right legs were independently registered. 2D kinematic of the right leg and energy cost (gross efficiency) were recorded. The results showed that changes in crank length had no effect on the gross efficiency, but had effect on the biomechanical variables. A longer crank caused a decreased in mechanical efficiency and an increase in the flexion and range of movement of the hip and the knee, without changes in the ankle. These alterations were not significant enough to alter the gross efficiency, but they could have negative long-term implications (worse pedaling technique and possible injuries). In conclusion, the small changes in crank arm length which are feasible for competitive cyclists affected cycling biomechanics, but not gross efficiency. Future studies should study long-term effects of these changes.Peer Reviewe

Constraints on the χ_(c1) versus χ_(c2) polarizations in proton-proton collisions at √s = 8 TeV

The polarizations of promptly produced χ_(c1) and χ_(c2) mesons are studied using data collected by the CMS experiment at the LHC, in proton-proton collisions at √s=8  TeV. The χ_c states are reconstructed via their radiative decays χ_c → J/ψγ, with the photons being measured through conversions to e⁺e⁻, which allows the two states to be well resolved. The polarizations are measured in the helicity frame, through the analysis of the χ_(c2) to χ_(c1) yield ratio as a function of the polar or azimuthal angle of the positive muon emitted in the J/ψ → μ⁺μ⁻ decay, in three bins of J/ψ transverse momentum. While no differences are seen between the two states in terms of azimuthal decay angle distributions, they are observed to have significantly different polar anisotropies. The measurement favors a scenario where at least one of the two states is strongly polarized along the helicity quantization axis, in agreement with nonrelativistic quantum chromodynamics predictions. This is the first measurement of significantly polarized quarkonia produced at high transverse momentum