Ce–Metal–Organic Framework-Derived CeO₂–GO: An Efficient Electrocatalyst for Oxygen Evolution Reaction

The oxygen evolution reaction (OER) is a crucial half-reaction in water splitting. However, this reaction is kinetically sluggish owing to the four-electron (4 e−) transfer process. Therefore, the development of low-cost, stable, highly efficient, and earth-abundant electrocatalysts for the OER is highly desirable. Metal oxides derived from metal–organic frameworks (MOFs) are among the most efficient electrocatalysts for the OER. Herein, Ce–MOF-derived CeO2/graphene oxide (GO) composites were successfully prepared using a facile method. The composites with 0, 25, 50, and 100 mg GO were named CeO2, CeO2–GO-1, CeO2–GO-2, and CeO2–GO-3, respectively. The physicochemical characteristics of the electrocatalysts were assessed using several analytical techniques, including X-ray diffraction (XRD), scanning electron microscopy (SEM), high-resolution transmission electron microscopy (HR-TEM), X-ray photoelectron spectroscopy (XPS), and Brunauer–Emmett–Teller (BET) analysis. The TEM results revealed that the CeO2 had a sheet-like morphology and that a GO layer was noticeable in the synthesized CeO2–GO-3 composite. The characterization results confirmed the formation of impurity-free CeO2–GO composites. The OER activity and stability were measured using cyclic voltammetry (CV), linear sweep voltammetry (LSV), chronoamperometry (CA), and electrochemical impedance spectroscopy (EIS). The CeO2–GO-3 electrocatalyst has a smaller Tafel slope (176 mV·dec−1) and lower overpotential (240 mV) than the other electrocatalysts. In addition, it exhibited high cyclic stability for up to 10 h. Therefore, the inexpensive CeO2–GO-3 electrocatalyst is a promising OER candidate

Hydrothermal Synthesis of MnWO4@GO Composite as Non-Precious Electrocatalyst for Urea Oxidation

In this study, manganese tungstate (MW) and MW/graphene oxide (GO) composites were prepared by a facile hydrothermal synthesis at pH values of 7 and 12. X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and Raman spectroscopy were used for the structural, compositional, and morphological characterization of the nanoparticles (NPs). The XRD analysis revealed that the formation of monoclinic MnWO4 did not have impurities. The SEM and TEM analyses showed that the synthesized NPs were rod-shaped and well-distributed on the GO. The as-synthesized samples can be used as electrocatalysts for the urea oxidation reaction (UOR). The MW@GO-12 electrocatalyst exhibited higher current density values compared to other electrocatalysts. This study provides a new platform for synthesizing inexpensive nanocomposites as promising electrocatalysts for energy storage and conversion applications

In Situ Synthesis of β-Na₁.₅Y₁.₅F₆: Er³⁺ Crystals in Oxyfluoride Silicate Glass for Temperature Sensors and Their Spectral Conversion and Optical Thermometry Analysis

Transparent oxyfluoride glass-ceramics (GCs) with embedded β-Na1.5Y1.5F6 crystals doped with Er3+ ions were fabricated by a melt-quenching method with subsequent heat-treatment. The structural characterizations and spectroscopic techniques were performed to verify the precipitation of β-Na1.5Y1.5F6 crystals and partition of the Er3+ dopant into the crystals. Bright green up-conversion (UC) emission was achieved in Er3+-doped glass-ceramic (Er-GC). Furthermore, the temperature-dependent visible UC behavior based on thermally coupled energy levels (TCLs) and non-thermally coupled energy levels (NTCLs) was also examined in the temperature range 298 k to 823 K with maximum relative sensitivity (Sr) of 1.1% K−1 at 298 K for TCLs in Er-G and Er-GC samples

In Situ Synthesis of β-Na1.5Y1.5F6: Er3+ Crystals in Oxyfluoride Silicate Glass for Temperature Sensors and Their Spectral Conversion and Optical Thermometry Analysis

Transparent oxyfluoride glass-ceramics (GCs) with embedded β-Na1.5Y1.5F6 crystals doped with Er3+ ions were fabricated by a melt-quenching method with subsequent heat-treatment. The structural characterizations and spectroscopic techniques were performed to verify the precipitation of β-Na1.5Y1.5F6 crystals and partition of the Er3+ dopant into the crystals. Bright green up-conversion (UC) emission was achieved in Er3+-doped glass-ceramic (Er-GC). Furthermore, the temperature-dependent visible UC behavior based on thermally coupled energy levels (TCLs) and non-thermally coupled energy levels (NTCLs) was also examined in the temperature range 298 k to 823 K with maximum relative sensitivity (Sr) of 1.1% K−1 at 298 K for TCLs in Er-G and Er-GC samples

High-Throughput Strategies for the Design, Discovery, and Analysis of Bismuth-Based Photocatalysts

Bismuth-based nanostructures (BBNs) have attracted extensive research attention due to their tremendous development in the fields of photocatalysis and electro-catalysis. BBNs are considered potential photocatalysts because of their easily tuned electronic properties by changing their chemical composition, surface morphology, crystal structure, and band energies. However, their photocatalytic performance is not satisfactory yet, which limits their use in practical applications. To date, the charge carrier behavior of surface-engineered bismuth-based nanostructured photocatalysts has been under study to harness abundant solar energy for pollutant degradation and water splitting. Therefore, in this review, photocatalytic concepts and surface engineering for improving charge transport and the separation of available photocatalysts are first introduced. Afterward, the different strategies mainly implemented for the improvement of the photocatalytic activity are considered, including different synthetic approaches, the engineering of nanostructures, the influence of phase structure, and the active species produced from heterojunctions. Photocatalytic enhancement via the surface plasmon resonance effect is also examined and the photocatalytic performance of the bismuth-based photocatalytic mechanism is elucidated and discussed in detail, considering the different semiconductor junctions. Based on recent reports, current challenges and future directions for designing and developing bismuth-based nanostructured photocatalysts for enhanced photoactivity and stability are summarized

Umbc at trec 12

Abstract. We present the results of UMBC’s participation in the Web and Novelty tracks. We explored various heuristics-based link analysis approaches to the Topic Distillation task. For the novelty task we tried several methods for exploiting semantic information of sentences based on the SVD technique. We used SVD to expand the query and to filter redundant sentences. We also used a clustering algorithm that is also based on SVD