Effect of ammonia load on efficiency of nitrogen removal in an SBBR with liquid-phase circulation

The removal of biological nitrogen from a synthetic wastewater with different ammonium nitrogen concentrations (50 and 100 mgN-NH4+/L) by a nitrification and denitrification process using a sequencing batch biofilm reactor (SBBR) with liquid-phase circulation was studied. The system with a total working volume of 4.6 L (3.7 L in the reactor and 0.9 L in the reservoir) treated 2.1 L of synthetic wastewater in 12-h cycles. As inoculum two types of biomass were used: an anaerobic/anoxic one from an up-flow anaerobic sludge blanket reactor (UASB) and an aerobic one from a prolonged aeration activated sludge system. The system, maintained at 30 ± 1 ºC, operated in batch mode followed by fed-batch mode and was aerated intermittently. During fed-batch operation the reactor was fed with an external carbon source as electron donor in the denitrifying step and with no aeration. When the reactor was fed with 50 mgN-NH4+/L, efficiencies of removal of ammonium nitrogen and total nitrogen from the effluent were 93.8 and 72.2%, respectively, and nitrite, nitrate and organic nitrogen concentrations were 0.07, 6.4 and 0.5 mg/L, respectively. On the other hand, when the influent ammonium nitrogen concentration was 100 mgN-NH4+/L, residual nitrite and nitrate were 0.17 and 20.4, respectively, and no N-Org was found in the effluent. It should be mentioned that residual nitrate remained unaltered at the different C/N ratios used. Consequently, efficiency of total nitrogen removal was reduced to 66.7%, despite efficiency of ammonium nitrogen removal exceeding 90%. These results show the potential of the proposed system in removing ammonium nitrogen from liquid effluents with a moderate ammonium nitrogen concentration.Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP

Effect of mixing mode on the behavior of an ASBBR with immobilized biomass in the treatment of cheese whey

A hydrodynamic study of a mechanically stirred anaerobic sequencing batch biofilm reactor (ASBBR) containing immobilized biomass on polyurethane foam was performed with the aim to determine homogeneity of the reactor based on total mixing time. Turbine or helix propellers were used for stirring at rotor speeds of 100, 200, 300 and 500 rpm. Experimental values obtained were fitted to a Boltzmann sigmoid. Homogenization times of the reactor were negligible when compared to the 8-h cycle time for all conditions studied. At low propeller rotations the turbine propeller showed the best performance. For higher rotations total mixing times were similar for both propellers; however the helix propeller had better homogeneity conditions. At a subsequent stage the system was operated in batch mode treating cheese whey at concentrations of 500, 1000 and 2000 mgCOD/L and rotations of 200, 300 and 500 rpm. In these assays the importance of the propeller became evident not only for mixing, but also for substrate flow across the bed containing immobilized biomass. Due to axial flow, the helix propeller offered better mass transfer conditions, evidenced by improved organic matter conversion and lower production of total volatile acids

Nitrogen removal in a sequencing batch biofilm reactor with liquid circulation: Effect of feed strategy and carbon source in the denitrifying step

Ammonium nitrogen removal from a synthetic wastewater by nitrification and denitrification processes were performed in a sequencing batch biofilm reactor containing immobilized biomass on polyurethane foam with circulation of the liquid-phase. It was analyzed the effect of four external carbon sources (ethanol, acetate, carbon synthetic medium and methanol) acting as electron donors in the denitrifying process. The experiments were conducted with intermittent aeration and operated at 30+/-1 degrees C in 8-h cycles. The synthetic wastewater (100 mgCOD/L and 50 mgNH(4)(+)-N/L) was added batch-wise, while the external carbon sources were added fed-batch-wise during the periods where aeration was suspended. Ammonium nitrogen removal efficiencies obtained were 95.7, 94.3 and 97.5% for ethanol, acetate and carbon synthetic medium, respectively. As to nitrite, nitrate and ammonium nitrogen effluent concentrations, the results obtained were, respectively: 0.1, 5.7 and 1.4 mg/L for ethanol; 0.2, 4.1 and 1.8 mg/L for acetate and 0.2, 6.7 and 0.8 for carbon synthetic medium. On the other hand using methanol, even at low concentrations (50% of the stoichiometric value calculated for complete denitrification), resulted in increasing accumulation of nitrate and ammonium nitrogen in the effluent over time.Fundacao de Amparo a Pesquisa do Estado de Sao Paulo - FAPESP[01/05489-0]Fundacao de Amparo a Pesquisa do Estado de Sao Paulo - FAPESP[02/07504-0

Temperature and feed strategy effects on sulfate and organic matter removal in an AnSBB

The objective of this work was to analyze the interaction effects between temperature, feed strategy and COD/[SO(4)(2-)] levels, maintaining the same ratio, on sulfate and organic matter removal efficiency from a synthetic wastewater. This work is thus a continuation of Archilha et al. (2010) who studied the effect of feed strategy at 30 degrees C using different COD/[SO] ratios and levels. A 3.7-L anaerobic sequencing batch reactor with recirculation of the liquid phase and which contained immobilized biomass on polyurethane foam (AnSBBR) was used to treat 2.0 L synthetic wastewater in 8 h cycles. The temperatures of 15, 22.5 and 30 degrees C with two feed strategies were assessed: (a) batch and (b) batch followed by fed-batch. In strategy (a) the reactor was fed in 10 min with 2 L wastewater containing sulfate and carbon sources. In strategy (b) 1.2 L wastewater (containing only the sulfate source) was fed during the first 10 min of the cycle and the remaining 0.8 L (containing only the carbon source) in 240 min. Based on COD/[SO(4)(2-)] = 1 and on the organic matter (0.5 and 1.5 gCOD/L) and sulfate (0.5 and 1.5 gSO(4)(2-)/L) concentrations, the sulfate and organic matter loading rates applied were 1.5 and 4.5 g/L.d, i.e., same COD/[SO(4)(2-)] ratio (=1) but different levels (1.5/1.5 and 4.5/4.5 gCOD/gSO(4)(2-)). When reactor feed was 1.5 gCOD/L.d and 1.5 gSO(4)(2-)/L.d, gradual feeding (strategy b) showed to favor sulfate and organic matter removal in the investigated temperature range, indicating improved utilization of the electron donor for sulfate reduction. Sulfate removal efficiencies were 87.9; 86.3 and 84.4%, and organic matter removal efficiencies 95.2; 86.5 and 80.8% at operation temperatures of 30; 22.5 and 15 degrees C, respectively. On the other hand, when feeding was 4.5 gCOD/L.d and 4.5 gSO(4)(2-)/L.d, gradual feeding did not favor sulfate removal, indicating that gradual feeding of the electron donor did not improve sulfate reduction. (C) 2011 Elsevier Ltd. All rights reserved.Fundacao de Amparo a Pesquisa do Estado de Sao Paulo - FAPESP[05/51.702-9]Fundacao de Amparo a Pesquisa do Estado de Sao Paulo - FAPESP[08/58.483-9