12,204 research outputs found
Skin friction measuring device for aircraft
A skin friction measuring device for measuring the resistance of an aerodynamic surface to an airstream is described. It was adapted to be mounted on an aircraft and is characterized by a friction plate adapted to be disposed in a flush relationship with the external surface of the aircraft and be displaced in response to skin friction drag. As an airstream is caused to flow over the surface, a potentiometer connected to the plate for providing an electrical output indicates the magnitude of the drag
F-8 supercritical wing flight pressure, Boundary layer, and wake measurements and comparisons with wind tunnel data
Data for speeds from Mach 0.50 to Mach 0.99 are presented for configurations with and without fuselage area-rule additions, with and without leading-edge vortex generators, and with and without boundary-layer trips on the wing. The wing pressure coefficients are tabulated. Comparisons between the airplane and model data show that higher second velocity peaks occurred on the airplane wing than on the model wing. The differences were attributed to wind tunnel wall interference effects that caused too much rear camber to be designed into the wing. Optimum flow conditions on the outboard wing section occurred at Mach 0.98 at an angle of attack near 4 deg. The measured differences in section drag with and without boundary-layer trips on the wing suggested that a region of laminar flow existed on the outboard wing without trips
A fast acting electrical servo for the actuation of full span, Fowler-type wing flaps in DLC applications: A detail design study
The philosophy and detail design of an electro-mechanical actuator for Fowler-type wing flaps which have a response time constant of 0.025 seconds are described. A conventional electrical servomotor with a power rating twice the maximum power delivered to the load is employed along with adaptive, gain-scheduled feedback and various logic circuits, including one to remove electrical excitation from the motor during extended periods when no motion of the flap is desired
Display system software for the integration of an ADAGE 3000 programmable display generator into the solid modeling package C.A.D. software
A software system that integrates an ADAGE 3000 Programmable Display Generator into a C.A.D. software package known as the Solid Modeling Program is described. The Solid Modeling Program (SMP) is an interactive program that is used to model complex solid object through the composition of primitive geomeentities. In addition, SMP provides extensive facilities for model editing and display. The ADAGE 3000 Programmable Display Generator (PDG) is a color, raster scan, programmable display generator with a 32-bit bit-slice, bipolar microprocessor (BPS). The modularity of the system architecture and the width and speed of the system bus allow for additional co-processors in the system. These co-processors combine to provide efficient operations on and rendering of graphics entities. The resulting software system takes advantage of the graphics capabilities of the PDG in the operation of SMP by distributing its processing modules between the host and the PDG. Initially, the target host computer was a PRIME 850, which was later substituted with a VAX-11/785. Two versions of the software system were developed, a phase 1 and a phase 2. In phase 1, the ADAGE 3000 is used as a frame buffer. In phase II, SMP was functionally partitioned and some of its functions were implemented in the ADAGE 3000 by means of ADAGE's SOLID 3000 software package
Systems development of a stall/spin research facility using remotely controlled/augmented aircraft models. Volume 1: Systems overview
A ground based, general purpose, real time, digital control system simulator (CSS) is specified, developed, and integrated with the existing instrumentation van of the testing facility. This CSS is built around a PDP-11/55, and its operational software was developed to meet the dual goal of providing the immediate capability to represent the F-18 drop model control laws and the flexibility for expansion to represent more complex control laws typical of control configured vehicles. Overviews of the two CSS's developed are reviewed as well as the overall system after their integration with the existing facility. Also the latest version of the F-18 drop model control laws (REV D) is described and the changes needed for its incorporation in the digital and analog CSS's are discussed
- …