Effect of stoichiometry on oxygen incorporation in MgB2 thin films

The amount of oxygen incorporated into MgB2 thin films upon exposure to atmospheric gasses is found to depend strongly on the material's stoichiometry. Rutherford backscattering spectroscopy was used to monitor changes in oxygen incorporation resulting from exposure to: (a) ambient atmosphere, (b) humid atmospheres, (c) anneals in air and (d) anneals in oxygen. The study investigated thin-film samples with compositions that were systematically varied from Mg0.9B2 to Mg1.1B2. A significant surface oxygen contamination was observed in all of these films. The oxygen content in the bulk of the film, on the other hand, increased significantly only in Mg rich films and in films exposed to humid atmospheres.Comment: 10 pages, 6 figures, 1 tabl

The Reactivity of MgB2 with Common Substrate and Electronic Materials

The reactivity of MgB2 with powdered forms of common substrate and electronic materials is reported. Reaction temperatures between 600 C and 800 C, encompassing the range commonly employed in thin-film fabrication, were studied. The materials tested for reactivity were ZrO2, yttria stabilized zirconia (YSZ), MgO, Al2O3, SiO2, SrTiO3, TiN, TaN, AlN, Si, and SiC. At 600 C, MgB2 reacted only with SiO2 and Si. At 800 C, however, reactions were observed for MgB2 with Al2O3, SiO2, Si, SiC, and SrTiO3. The Tc of MgB2 decreased in the reactions with SiC and Al2O3.Comment: 5 figure

MgB2 tunnel junctions with native or thermal oxide barriers

MgB2 tunnel junctions (MgB2/barrier/MgB2) were fabricated using a native oxide grown on the bottom MgB2 film as the tunnel barrier. Such barriers therefore survive the deposition of the second electrode at 300oC, even over junction areas of ~1 mm2. Studies of such junctions, and those of the type MgB2/native or thermal oxide/metal (Pb, Au, or Ag) show that tunnel barriers grown on MgB2 exhibit a wide range of barrier heights and widths.Comment: 9 pages, 3 figure

Swelling of acetylated wood in organic liquids

To investigate the affinity of acetylated wood for organic liquids, Yezo spruce wood specimens were acetylated with acetic anhydride, and their swelling in various liquids were compared to those of untreated specimens. The acetylated wood was rapidly and remarkably swollen in aprotic organic liquids such as benzene and toluene in which the untreated wood was swollen only slightly and/or very slowly. On the other hand, the swelling of wood in water, ethylene glycol and alcohols remained unchanged or decreased by the acetylation. Consequently the maximum volume of wood swollen in organic liquids was always larger than that in water. The effect of acetylation on the maximum swollen volume of wood was greater in liquids having smaller solubility parameters. The easier penetration of aprotic organic liquids into the acetylated wood was considered to be due to the scission of hydrogen bonds among the amorphous wood constituents by the substitution of hydroxyl groups with hydrophobic acetyl groups.Comment: to be published in J Wood Science (Japanese wood research society

Flame-Retardant Treatment Of Wood With A Diisocyanate and An Oligomer Phosphonate

An oligomer phosphonate and isophorone diisocyanate, in a chloroform or dichloromethane solution, were impregnated into wood and cured at 105 C. The leach resistance and thermal degradation of treated wood specimens were evaluated. Leaching milled specimens removed up to 49% of the phosphorus and 12% of the nitrogen. The average weight percent gain of solid specimens leached with three 4-day cycles of running water was reduced from 23% to 17% during the first cycle and from 17% to 16% during the second and third cycles. Toluene: ethanol extraction did not remove the reacted chemicals from the wood. Acetone extraction resulted in a 1% to 2% reduction of the weight percent gain values. Thermal analysis showed that the flame-retardant treatment reduced the temperature at maximum rate of pyrolysis approximately 80 C and increased the amount of residual char to about 30%. Leaching raised the temperature on the average 8 C at the maximum rate of pyrolysis and decreased the amount of residual char an average of 3%. The temperature at maximum rate of pyrolysis and amount of residual char indicate the potential effectiveness of this treatment as a leach-resistant, flame-retardant treatment for wood

Dynamic Spin-Polarized Resonant Tunneling in Magnetic Tunnel Junctions

Precisely engineered tunnel junctions exhibit a long sought effect that occurs when the energy of the electron is comparable to the potential energy of the tunneling barrier. The resistance of metal-insulator-metal tunnel junctions oscillates with an applied voltage when electrons that tunnel directly into the barrier's conduction band interfere upon reflection at the classical turning points: the insulator-metal interface, and the dynamic point where the incident electron energy equals the potential barrier inside the insulator. A model of tunneling between free electron bands using the exact solution of the Schroedinger equation for a trapezoidal tunnel barrier qualitatively agrees with experiment.Comment: 4pgs, 3 fig

Spontaneous Fluxon Production in Annular Josephson Tunnel Junctions in the Presence of a Magnetic Field

We report on the spontaneous production of fluxons in the presence of a symmetry-breaking magnetic field for annular Josephson tunnel junctions during a thermal quench. The dependence on field intensity $B$ of the probability $\bar{f_1}$ to trap a single defect during the N-S phase transition drastically depends on the sample circumferences. We show that the data can be understood in the framework of the Kibble-Zurek picture of spontaneous defect formation controlled by causal bounds.Comment: Submitted to Phys. Rev. B with 5 figures on Nov. 15, 200

Zurek-Kibble Mechanism for the Spontaneous Vortex Formation in Nb−Al/Alox/NbNb-Al/Al_{ox}/Nb Josephson Tunnel Junctions: New Theory and Experiment

New scaling behavior has been both predicted and observed in the spontaneous production of fluxons in quenched $Nb-Al/Al_{ox}/Nb$ annular Josephson tunnel junctions as a function of the quench time, $\tau_{Q}$. The probability $f_{1}$ to trap a single defect during the N-S phase transition clearly follows an allometric dependence on $\tau_{Q}$ with a scaling exponent $\sigma = 0.5$, as predicted from the Zurek-Kibble mechanism for {\it realistic} JTJs formed by strongly coupled superconductors. This definitive experiment replaces one reported by us earlier, in which an idealised model was used that predicted $\sigma = 0.25$, commensurate with the then much poorer data. Our experiment remains the only condensed matter experiment to date to have measured a scaling exponent with any reliability.Comment: Four pages, one figur