A stochastic model of turbulent mixing with chemical reaction: Nitric oxide formulation in a plug-flow burner

A stochastic model of turbulent mixing was developed for a reactor in which mixing is represented by n-body fluid particle interactions. The model was used to justify the assumption (made in previous investigations of the role of turbulent mixing on burner generated thermal nitric oxide and carbon monoxide emissions) that for a simple plug flow reactor, composition nonuniformities can be described by a Gaussian distribution function in the local fuel:air equivalence ratio. Recent extensions of this stochastic model to include the combined effects of turbulent mixing and secondary air entrainment on thermal generation of nitric oxide in gas turbine combustors are discussed. Finally, rate limited upper and lower bounds of the nitric oxide produced by thermal fixation of molecular nitrogen and oxidation of organically bound fuel nitrogen are estimated on the basis of the stochastic model for a plug flow burner; these are compared with experimental measurements obtained using a laboratory burner operated over a wide range of test conditions; good agreement is obtained

Silicon production in an aerosol reactor

An aerosol reactor system was developed in which large particles of silicon can be grown by silane pyrolysis. To grow particles to sizes larger than one micron, vapor deposition must be used to grow a relatively small number of seed particles. Suppression of nucleation is achieved by limiting the rate of gas phase chemical reactions such that the condensible products of the gas phase chemical reactions diffuse to the surface of the seed particles as rapidly as they are produced. This prevents high degrees of supersaturation and runaway nucleation during the growth process. Particles on the order of 10 microns were grown repeatedly with the present aersol reactor. The nucleation controlled aerosol reactor is, therefore, a suitable system for the production of powders that can readily be separated from the gas by aerodynamic means

Thermally induced structural changes in coal combustion. Final report

The effects of the temperature-time history during coal devolitization and oxidation on the physical properties and the reactivity of resulting char were studied experimentally for temperatures and residence times typical of pulverized combustion. Experiments were also carried out at somewhat lower temperatures and correspondingly longer residence times. An electrically heated laminar flow reactor was used to generate char and measure the rates of oxidation at gas temperatures about 1600K. Partially oxidized chars were extracted and characterized by gas adsorption and mercury porosimetry, optical and scanning electron microscopy, and oxidation in a thermogravimetric analysis system (TGA). A different series of experiments was conducted using a quadrople electrodynamic balance. Single particles were suspended electrodynamically and heated by an infrared laser in an inert or oxygen-containing atmosphere. During the laser heating, measurements were taken of particle mass, size/shape, and temperature

Thermodynamics of the formation of sulfuric acid dimers in the binary (H_2SO_4–H_2O) and ternary (H_2SO_4–H_2O–NH_3) system

Sulfuric acid is an important gas influencing atmospheric new particle formation (NPF). Both the binary (H_2SO_4–H_2O) system and the ternary system involving ammonia (H_2SO_4–H_2O–NH_3) may be important in the free troposphere. An essential step in the nucleation of aerosol particles from gas-phase precursors is the formation of a dimer, so an understanding of the thermodynamics of dimer formation over a wide range of atmospheric conditions is essential to describe NPF. We have used the CLOUD chamber to conduct nucleation experiments for these systems at temperatures from 208 to 248 K. Neutral monomer and dimer concentrations of sulfuric acid were measured using a chemical ionization mass spectrometer (CIMS). From these measurements, dimer evaporation rates in the binary system were derived for temperatures of 208 and 223 K. We compare these results to literature data from a previous study that was conducted at higher temperatures but is in good agreement with the present study. For the ternary system the formation of H_2SO_4·NH_3 is very likely an essential step in the formation of sulfuric acid dimers, which were measured at 210, 223, and 248 K. We estimate the thermodynamic properties (dH and dS) of the H_2SO_4·NH_3 cluster using a simple heuristic model and the measured data. Furthermore, we report the first measurements of large neutral sulfuric acid clusters containing as many as 10 sulfuric acid molecules for the binary system using chemical ionization–atmospheric pressure interface time-of-flight (CI-APi-TOF) mass spectrometry

Binary nucleation in acid–water systems. II. Sulfuric acid–water and a comparison with methanesulfonic acid–water

This work presents a systematic investigation of binary nucleation rates for sulfuric acid and water and the effect of temperature on these rates at isothermal, subsaturated conditions. The results from nucleation rate measurements for the sulfuric acid (H2SO4)–water system are discussed and compared to those previously presented for methanesulfonic acid (MSA)–water [B. E. Wyslouzil, J. H. Seinfeld, R. C. Flagan, and K. Okuyama, J. Chem. Phys. (submitted)]. Experiments were conducted at relative humidities (Rh) ranging from 0.006<Rh<0.65, relative acidities (Ra) in the range of 0.04<Ra<0.46, and at three temperatures, T=20, 25, and 30 °C, in the continuous flow mixing-type apparatus described in Paper I. Particles were formed by binary nucleation and grew by condensation as the mixed stream flowed through an isothermal glass tube. Number concentrations observed at the exit of the nucleation and growth tube as a function of Rh and Ra are extremely sensitive to the binary nucleation rate, and from these data the nucleation rate was estimated as a function of saturation level and temperature. Particle size distributions were also measured using a specially constructed differential mobility analyzer. As anticipated, the H2SO4 particles formed by nucleation and growth are much smaller than those formed in the MSA–water experiments, but particle size distribution measurements confirm that most of the particles formed are being observed. The ratio of experimental to theoretical nucleation rates, Jexpt/Jtheor, was found to be a strong function of the predicted number of acid molecules in the critical nucleus for both the H2SO4–water and MSA–water systems

Effect of ions on sulfuric acid-water binary particle formation: 2. Experimental data and comparison

We report comprehensive, demonstrably contaminant-free measurements of binary particle formation rates by sulfuric acid and water for neutral and ion-induced pathways conducted in the European Organization for Nuclear Research Cosmics Leaving Outdoor Droplets chamber. The recently developed Atmospheric Pressure interface-time of flight-mass spectrometer was used to detect contaminants in charged clusters and to identify runs free of any contaminants. Four parameters were varied to cover ambient conditions: sulfuric acid concentration (10^5 to 10^9  mol cm^(−3)), relative humidity (11% to 58%), temperature (207 K to 299 K), and total ion concentration (0 to 6800 ions cm^(−3)). Formation rates were directly measured with novel instruments at sizes close to the critical cluster size (mobility size of 1.3 nm to 3.2 nm). We compare our results with predictions from Classical Nucleation Theory normalized by Quantum Chemical calculation (QC-normalized CNT), which is described in a companion paper. The formation rates predicted by the QC-normalized CNT were extended from critical cluster sizes to measured sizes using the UHMA2 sectional particle microphysics model. Our results show, for the first time, good agreement between predicted and measured particle formation rates for the binary (neutral and ion-induced) sulfuric acid-water system. Formation rates increase with RH, sulfuric acid, and ion concentrations and decrease with temperature at fixed RH and sulfuric acid concentration. Under atmospheric conditions, neutral particle formation dominates at low temperatures, while ion-induced particle formation dominates at higher temperatures. The good agreement between the theory and our comprehensive data set gives confidence in using the QC-normalized CNT as a powerful tool to study neutral and ion-induced binary particle formation in atmospheric modeling

Hygroscopicity of nanoparticles produced from homogeneous nucleation in the CLOUD experiments

Sulfuric acid, amines and oxidized organics have been found to be important compounds in the nucleation and initial growth of atmospheric particles. Because of the challenges involved in determining the chemical composition of objects with very small mass, however, the properties of the freshly nucleated particles and the detailed pathways of their formation processes are still not clear. In this study, we focus on a challenging size range, i.e., particles that have grown to diameters of 10 and 15 nm following nucleation, and measure their water uptake. Water uptake is useful information for indirectly obtaining chemical composition of aerosol particles. We use a nanometer-hygroscopicity tandem differential mobility analyzer (nano-HTDMA) at subsaturated conditions (ca. 90% relative humidity at 293 K) to measure the hygroscopicity of particles during the seventh Cosmics Leaving OUtdoor Droplets (CLOUD7) campaign performed at CERN in 2012. In CLOUD7, the hygroscopicity of nucleated nanoparticles was measured in the presence of sulfuric acid, sulfuric acid-dimethylamine, and sulfuric acid-organics derived from α-pinene oxidation. The hygroscopicity parameter κ decreased with increasing particle size, indicating decreasing acidity of particles. No clear effect of the sulfuric acid concentration on the hygroscopicity of 10 nm particles produced from sulfuric acid and dimethylamine was observed, whereas the hygroscopicity of 15 nm particles sharply decreased with decreasing sulfuric acid concentrations. In particular, when the concentration of sulfuric acid was 5:1 x 10^6 molecules cm^(-3) in the gas phase, and the dimethylamine mixing ratio was 11.8 ppt, the measured κ of 15 nm particles was 0.31 ± 0.01: close to the value reported for dimethylaminium sulfate (DMAS) (κ_(DMAS) ~0:28). Furthermore, the difference in κ between sulfuric acid and sulfuric acid-dimethylamine experiments increased with increasing particle size. The κ values of particles in the presence of sulfuric acid and organics were much smaller than those of particles in the presence of sulfuric acid and dimethylamine. This suggests that the organics produced from α-pinene ozonolysis play a significant role in particle growth even at 10 nm sizes

Ash Vaporization and Condensation During Combustion of a Suspended Coal Particle

The results of a theoretical study of the formation and growth of the submicron flyash aerosol around a single burning coal particle are presented. The vaporization of ash and subsequent aerosol formation near the coal particle are studied because the local combustion environment influences these processes strongly. A mathematical model is developed that describes the transport of ash vapor and and the growth of the aerosol. The ash aerosol calculation is superimposed on an existing solution to the combustion problem. Included in the model are the effects of convective transport and of both homogeneous and heterogeneous condensation of the ash vapor. The results of the calculations show that refractory compounds with low surface tension, like silica, nucleate very near the coal particle's surface and produce a substantial mass loading of aerosol. The presence of the aerosol does not greatly affect the ash vaporization rate, which is primarily a function of combustion conditions. The size and amount of the submicron ash aerosol are determined by both the local combustion conditions and the ash's physical properties

Water-soluble SOA from Alkene ozonolysis: composition and droplet activation kinetics inferences from analysis of CCN activity

Cloud formation characteristics of the water-soluble organic fraction (WSOC) of secondary organic aerosol (SOA) formed from the ozonolysis of alkene hydrocarbons (terpinolene, 1-methlycycloheptene and cycloheptene) are studied. Based on size-resolved measurements of CCN activity (of the pure and salted WSOC samples) we estimate the average molar volume and surface tension depression associated with the WSOC using Köhler Theory Analysis (KTA). Consistent with known speciation, the results suggest that the WSOC are composed of low molecular weight species, with an effective molar mass below 200 g mol^(−1). The water-soluble carbon is also surface-active, depressing surface tension 10–15% from that of pure water (at CCN-relevant concentrations). The inherent hygroscopicity parameter, κ, of the WSOC ranges between 0.17 and 0.25; if surface tension depression and molar volume effects are considered in κ, a remarkably constant "apparent" hygroscopicity ~0.3 emerges for all samples considered. This implies that the volume fraction of soluble material in the parent aerosol is the key composition parameter required for prediction of the SOA hygroscopicity, as shifts in molar volume across samples are compensated by changes in surface tension. Finally, using "threshold droplet growth analysis", the water-soluble organics in all samples considered do not affect CCN activation kinetics