Self-focusing effect in Au-target induced by high power pulsed laser at PALS

AbstractSelf-focusing effects, induced by ASTERIX pulsed laser at PALS Laboratory of Prague, have been investigated. Laser was employed at the third harmonics (438 nm) and intensities of the order of 1016 W/cm2. Pure Au was used as thin target and irradiated with 30° incidence angle. An ion energy analyzer was employed to detect the energy-to-mass ratio of emitted ions from plasma. Measurements were performed by changing the focal point position with a high spatial resolution step-motor. Results demonstrated that non linear processes, due to self-focusing effects, occurs when the laser beam is focused at about 200 µm in front of the target surface. In such conditions, a new ion group, having high charge state and kinetic energy, is produced because of the increment in temperature of the laser-generated plasma

Thomson Parabola Spectrometer for Energetic Ions Emitted from Sub-ns Laser Generated Plasmas

Laser-generated plasmas were obtained in high vacuum by irradiating micrometric thin films (Au, Au/Mylar, Mylar) with the Asterix laser at the PALS Research Infrastructure in Prague. Irradiations at the fundamental wavelength, 300 ps pulse duration, at intensities up to about 1016W/cm2, enabled ions to be accelerated in forward direction with kinetic energies of the order of 2 MeV/charge state. Protons above 2 MeV were obtained in the direction orthogonal to the target surface in selffocusing conditions. Gold ions up to about 120 MeV and 60+ charge state were detected. Ion collectors and semiconductor SiC detectors were employed in time-of-flight arrangement in order to measure the ion velocities as a function of the angle around the normal direction to the target surface. A Thomson parabola spectrometer (TPS) with a multi-channel-plate detector was used to separate the different ion contributions to the charge emission in single laser shots, and to get information on the ion charge states, energy and proton acceleration. TPS experimental spectra were compared with accurate TOSCA simulations of TPS parabolas

Experimental studies of generation of ~100 MeV Au-ions from the laser-produced plasma

AbstractUsing the PALS iodine laser system, Au ions with the charge state up to 58+ and with the kinetic energy as high as ~300 MeV were generated. The production of these ions was tested in dependence on the laser frequency (1ω, 3ω), on the irradiation/detection angles (0°, 30°), on the focus position with regard to the target surface, and on the target thickness (500 µm, 200 µm, 80 µm). A larger amount of the fastest ions was produced with 1ω than with 3ω, the most of the fast ions were recorded in the direction ~10°from the target normal, the optimum focus position is in front of the target and should be set on with a precision of 50 µm. The forward emission is weaker than the backward one for both of the thinner targets (which burn through) at our experimental conditions

Self-focusing in processes of laser generation of highly-charged and high-energy heavy ions

Laser-beam interaction with expanding plasma was investigated using the PALS high-power iodine-laser system. The interaction conditions are significantly changing with the laser focus spot position. The decisive role of the laser-beam self-focusing, participating in the production of ions with the highest charge states, was proved

Angular distributions of ions emitted from laser plasma produced at various irradiation angles and laser intensities

AbstractAngular distributions of currents and velocities (energies) of ions produced at various target irradiation angles and laser intensities ranged from 1010 W/cm2 to 1017 W/cm2 were analyzed. It was confirmed that for low laser intensities the ion current distributions are always peaked along the target normal. However, at laser intensities comparable to or higher than 1014 W/cm2, the preferred direction of ion emission strongly depends on the irradiation geometry (laser focus setting, the irradiation angle), and can be off the target normal. This is very likely caused by the non-linear interaction of the laser beam with produced plasma, in particular, by the action of ponderomotive forces and the laser beam self-focusing

Factors influencing parameters of laser ion sources

Various applications demand various kinds of ions. Charge state, energy and the amount of laser produced ions depend, primary, on the wavelength, the energy, the pulse duration, and the focusing ability of the laser used. Angle of the target irradiation, angle of the ion extraction (recording), and mainly the focus setting may significantly influence especially the portion of ions with the highest charge states. The participation of non-linear processes on the generation of ions with extremely high parameters is demonstrated. The observed effects support the idea of a longitudinal structure of the self-focused laser beam with a space period of ∼200 µm

X-ray microscopy of living multicellular organisms with the Prague Asterix Iodine Laser System

Soft X-ray contact microscopy (SXCM) experiments have been performed using the Prague Asterix Iodine Laser System (PALS). Laser wavelength and pulse duration were λ = 1.314 μm and τ (FWHM) = 450 ps, respectively. Pulsed X rays were generated using teflon, gold, and molybdenum targets with laser intensities I ≥ 1014 W/cm2. Experiments have been performed on the nematodes Caenorhabditis elegans. Images were recorded on PMMA photo resists and analyzed using an atomic force microscope operating in contact mode. Our preliminary results indicate the suitability of the SXCM for multicellular specimens

Shock pressure induced by 0.44 [mu]m laser radiation on aluminum targets

Shock pressure generated in aluminum targets due to the interaction of 0.44 μm (3 ω of iodine laser) laser radiation has been studied. The laser intensity profile was smoothed using phase zone plates. Aluminum step targets were irradiated at an intensity I ≈ 1014 W/cm2. Shock velocity in the aluminum target was estimated by detecting the shock luminosity from the target rear using a streak camera to infer the shock pressure. Experimental results show a good agreement with the theoretical model based on the delocalized laser absorption approximation. In the present report, we explicitly discuss the importance of target thickness on the shock pressure scaling