Thermal Properties of Graphene, Carbon Nanotubes and Nanostructured Carbon Materials

Recent years witnessed a rapid growth of interest of scientific and engineering communities to thermal properties of materials. Carbon allotropes and derivatives occupy a unique place in terms of their ability to conduct heat. The room-temperature thermal conductivity of carbon materials span an extraordinary large range - of over five orders of magnitude - from the lowest in amorphous carbons to the highest in graphene and carbon nanotubes. I review thermal and thermoelectric properties of carbon materials focusing on recent results for graphene, carbon nanotubes and nanostructured carbon materials with different degrees of disorder. A special attention is given to the unusual size dependence of heat conduction in two-dimensional crystals and, specifically, in graphene. I also describe prospects of applications of graphene and carbon materials for thermal management of electronics.Comment: Review Paper; 37 manuscript pages; 4 figures and 2 boxe

A Novel Role of Three Dimensional Graphene Foam to Prevent Heater Failure during Boiling

We report a novel boiling heat transfer (NBHT) in reduced graphene oxide (RGO) suspended in water (RGO colloid) near critical heat flux (CHF), which is traditionally the dangerous limitation of nucleate boiling heat transfer because of heater failure. When the heat flux reaches the maximum value (CHF) in RGO colloid pool boiling, the wall temperature increases gradually and slowly with an almost constant heat flux, contrary to the rapid wall temperature increase found during water pool boiling. The gained time by NBHT would provide the safer margin of the heat transfer and the amazing impact on the thermal system as the first report of graphene application. In addition, the CHF and boiling heat transfer performance also increase. This novel boiling phenomenon can effectively prevent heater failure because of the role played by the self-assembled three-dimensional foam-like graphene network (SFG).open2

Thermal Conductivity of ZnTe Nanowires

The thermal conductivity of individual ZnTe nanowires (NWs) was measured using a suspended micro-bridge device with built-in resistance thermometers. A collection of NWs with different diameters were measured, and strong size-dependent thermal conductivity was observed in these NWs. Compared to bulk ZnTe, NWs with diameters of 280 and 107 nm showed approximately three and ten times reduction in thermal conductivity, respectively. Such a reduction can be attributed to phonon-surface scattering. The contact thermal resistance and the intrinsic thermal conductivities of the nanowires were obtained through a combination of experiments and molecular dynamic simulations. The obtained thermal conductivities agree well with theoretical predictions. (C) 2013 AIP Publishing LLC.open111415sciescopu

Superior thermal conductivity in suspended bilayer hexagonal boron nitride

We reported the basal-plane thermal conductivity in exfoliated bilayer hexagonal boron nitride h-BN that was measured using suspended prepatterned microstructures. The h-BN sample suitable for thermal measurements was fabricated by dry-transfer method, whose sample quality, due to less polymer residues on surfaces, is believed to be superior to that of PMMA-mediated samples. The measured room temperature thermal conductivity is around 484 Wm-1K-1(+141 Wm-1K-1/ -24 Wm-1K-1) which exceeds that in bulk h-BN, providing experimental observation of the thickness-dependent thermal conductivity in suspended few-layer h-BN.Comment: 10 pages, 3 figure