37 research outputs found
Low-amplitude, force gradient imaging of Cu(100) surface using tunnel current feedback
The large corrugation amplitudes in scanning tunnelling microscope (STM) images of metal surfaces have been commonly attributed to the action of forces between the tip and the sample. We have investigated the Cu(100) surface using a high-resolution non-contact atomic force microscope/scanning tunnelling microscope (nc-AFM/STM) in UHV. Force gradient and STM topography images were acquired simultaneously using constant tunnelling current feedback. Force gradient images showed atomic resolution whereas STM scans exhibited almost no contrast, corresponding to a flat tip trajectory during scans. The corrugation height in force gradient images was found to increase as the set tunnelling current was increased. Force gradient and tunnel current were directly measured as a function of separation, to determine the operating conditions during imaging. The STM operation regime is found to lie between the minimum of the stiffness curve and the start of repulsive force
Energy dissipation in atomic force microscopy and atomic loss processes
Atomic scale dissipation is of great interest in nanomechanics and atomic manipulation. We present dissipation
measurements with a linearized, ultrasmall amplitude atomic force microscope which is capable
of measuring dissipation at chosen, fixed separations. We show that the dynamic dissipation in the noncontact
regime is of the order of a few 10–100 meV per cycle. This dissipation is likely due to the
motion of a bistable atomic defect in the tip-surface region. In the contact regime we observe dc hysteresis
associated with nanoscale plasticity. We find the hysteretic energy loss to be 1 order of magnitude
higher for a silicon surface than for copper
Direct measurement of interatomic force gradients using an ultra-low-amplitude atomic force microscope
Interatomic force gradients between a W tip and a 7 × 7 reconstructed Si(111) surface were measured using an off-resonance, ultra-low-amplitude atomic force microscope (AFM) technique. The amplitudes used were less than 1 Å (peak-to-peak), which allowed direct measurement of the interaction force gradients as a function of separation. The force gradient curves are shown to consist of an attractive van der Waals part and short-range attractive and repulsive interactions. The van der Waals background can be subtracted, leaving a short-range interaction with an energy parameter of 1.9-3.4 eV and an interaction length-scale of 0.54-1.26 Å, characteristic of a single atomic bond. This correlates well with our observation of single-atom resolved force gradient images. In general, the interaction is reversible up to the zero intercept of the force gradient (inflection point of the energy). Beyond this point hysteresis tends to be observed and the onset of inelastic deformation can be clearly discerned. An analysis of the atomic scale contact gives reasonable values for the interfacial energy, yield strength, and the energy per atom needed to initiate plastic deformation
High-sensitivity noncontact atomic force microscope/scanning tunneling microscope (ne AFM/STM) operating at subangstrom oscillation amplitudes for atomic resolution imaging and force spectroscopy
A highly sensitive noncontact atomic force microscope/scanning tunneling microscope (STM) operating in ultrahigh vacuum (UHV) with subangstrom oscillation amplitudes for atomic resolution imaging and force-distance spectroscopy was described. A novel fiber interferometer with very low noise levels was employed to detect cantilever displacements. The subangstrom oscillation amplitudes allow the force-distance measurements which reveal very short range force interactions
Superstructure formation and faceting in the Cu(210)-O system studied by scanning tunneling microscopy
Physical Review B - Condensed Matter and Materials Physics5812R7548-R7551PRBM
Quantitative atom-resolved force gradient imaging using noncontact atomic force microscopy
Quantitative force gradient images are obtained using a sub-angström amplitude, off-resonance lever oscillation method during scanning tunneling microscopy imaging. We report the direct observation of short-range bonds, and the measured short-range force interaction agrees well in magnitude and length scale with theoretical predictions for single bonds. Atomic resolution is shown to be associated with the presence of a prominent short-range contribution to the total force interaction. It is shown that the background longer-range interaction, whose relative magnitude depends on the tip structure, has a significant effect on the contrast observed at the atomic scale. © 2001 American Institute of Physics