Resonant gratings with an etch-stop layer and a fabrication-error tolerant design

Sub-wavelength gratings (SWG) have shown much promise for applications such as lightweight high bandwidth reflectors, polarising filters and focusing lenses. Unfortunately, grating performance may be rapidly degraded through variability in grating dimensions. We demonstrate, in particular, how an error in depth of etch can be detrimental to the performance of zero contrast grating reflectors. We mitigate the impact of this fabrication error through the introduction of an etch stop layer and in so doing we experimentally realise a high bandwidth reflector based on this modified structure. Another common fabrication error is variation in the duty-cycle of fabricated gratings. This duty-cycle variation can weaken grating performance, however we demonstrate that grating designs that exhibit tolerance to duty-cycle fluctuation can be identified through simulation. Finally, we discuss the impact of lateral etching and the resulting sidewall concavity. We present our approach for numerically predicting the spectral response from such a grating and also for convenience we outline an approach for quickly approximating grating performance. Good agreement is observed between these numerical predictions and measurements made on a HCG with concave sidewalls. (C) 2018 Optical Society of America under the terms of the OSA Open Access Publishing Agreemen

Optical emission of strained direct-band-gap Ge quantum well embedded inside InGaAs alloy layers

We studied the optical properties of a strain-induced direct-band-gap Ge quantum well embedded in InGaAs. We showed that the band offsets depend on the electronegativity of the layer in contact with Ge, leading to different types of optical transitions in the heterostructure. When group-V atoms compose the interfaces, only electrons are confined in Ge, whereas both carriers are confined when the interface consists of group-III atoms. The different carrier confinement results in different emission dynamics behavior. This study provides a solution to obtain efficient light emission from Ge

Optical properties of hybrid quantum dot/quantum well active region based on GaAs system

We experimentally investigate the optical properties of a novel hybrid material/structure consisting of a GaInNAs quantum well and stacked InAs/InGaAs quantum dot layers on GaAs substrate. We demonstrate that the strong quantum confined Stark effect within the quantum well can effectively control well-dot detuning when reverse bias voltage is applied. With a combination of low-and room-temperature time resolved luminescence spectra we infer device absorption recovery time under 30 ps. These properties could be utilized in high-speed optoelectronics devices, in particular electro-absorption modulated lasers and reconfigurable multisection devices, where the hybrid quantum dots - quantum well material system could offer easily and rapidly interchangeable function, i.e., emission gain or variable attenuation, of each section depending on the external bias. (C) 2012 American Institute of Physics. [http://dx.doi.org/10.1063/1.4752279

Heterogeneously grown tunable group-IV laser on silicon

Tunable tensile-strained germanium (epsilon-Ge) thin films on GaAs and heterogeneously integrated on silicon (Si) have been demonstrated using graded III-V buffer architectures grown by molecular beam epitaxy (MBE). epsilon-Ge epilayers with tunable strain from 0% to 1.95% on GaAs and 0% to 1.11% on Si were realized utilizing MBE. The detailed structural, morphological, band alignment and optical properties of these highly tensile-strained Ge materials were characterized to establish a pathway for wavelength-tunable laser emission from 1.55 μm to 2.1 μm. High-resolution X-ray analysis confirmed pseudomorphic epsilon-Ge epitaxy in which the amount of strain varied linearly as a function of indium alloy composition in the InxGa1-xAs buffer. Cross-sectional transmission electron microscopic analysis demonstrated a sharp heterointerface between the epsilon-Ge and the InxGa1-xAs layer and confirmed the strain state of the epsilon-Ge epilayer. Lowtemperature micro-photoluminescence measurements confirmed both direct and indirect bandgap radiative recombination between the Γ and L valleys of Ge to the light-hole valence band, with L-lh bandgaps of 0.68 eV and 0.65 eV demonstrated for the 0.82% and 1.11% epsilon-Ge on Si, respectively. The highly epsilon-Ge exhibited a direct bandgap, and wavelength-tunable emission was observed for all samples on both GaAs and Si. Successful heterogeneous integration of tunable epsilon-Ge quantum wells on Si paves the way for the implementation of monolithic heterogeneous devices on Si

Coulomb effect inhibiting spontaneous emission in charged quantum dot

We investigate the emission dynamics of InAs/GaAs quantum dots (QDs) coupled to an InGaAs quantum well in a tunnel injection scheme by means of time-resolved photoluminescence. Under high-power excitation we observe a redshift in the QD emission of the order of 20 meV. The optical transition intensity shows a complex evolution, where an initial plateau phase is followed by an increase in intensity before a single-exponential decay. We attribute this behavior to the Coulomb interactions between the carriers in a charged QD and corroborate the experimental results with both a rate equation model and self-consistent eight-band k.p calculations. (C) 2010 American Institute of Physics. (doi:10.1063/1.3484143

Improved room-temperature luminescence of core-shell InGaAs/GaAs nanopillars via lattice-matched passivation

Optical properties of GaAs/InGaAs/GaAs nanopillars (NPs) grown on GaAs (111)B were investigated. Employment of a mask-etching technique allowed for an accurate control over the geometry of NP arrays in terms of both their diameter and separation. This work describes both the steady-state and time-resolved photoluminescence of these structures as a function of the ensemble geometry, composition of the insert, and various shell compounds. The effects of the NP geometry on a parasitic radiative recombination channel, originating from an overgrown lateral sidewall layer, are discussed. Optical characterization reveals a profound influence of the core-shell lattice mismatch on the carrier lifetime and emission quenching at room temperature. When the latticematching conditions are satisfied, an efficient emission from the NP arrays at room temperature and below the band-gap of silicon is observed, clearly highlighting their potential application as emitters in optical interconnects integrated with silicon platforms

Competitive carrier interactions influencing the emission dynamics of GaAsSb-capped InAs quantum dots

The optical properties of InAs/GaAs quantum dots capped with a GaAsSb quantum well are investigated by means of power-dependent and time-resolved photoluminescence. The structure exhibits the coexistence of a type-I ground state and few type-II excited states, the latter characterized by a simultaneous carrier density shift of the peak position and wavelength-dependent carrier lifetimes. Complex emission dynamics are observed under a high-power excitation regime, with the different states undergoing shifts during specific phases of the measurement. These features are satisfactorily explained in terms of band structure and energy level modifications induced by two competitive carrier interactions inside the structure. (C) 2012 American Institute of Physics. (http://dx.doi.org/10.1063/1.4769431

Electro-optic properties of GaInAsSb/GaAs quantum well for high-speed integrated optoelectronic devices

The electro-optic properties of strained GaInAsSb/GaAs quantum wells (QWs) are investigated. A single QW p-i-n sample was grown by molecular beam epitaxy with antimony (Sb) pre-deposition technique. We numerically predict and experimentally verify a strong quantum confined Stark shift of 40 nm. We also predict a fast absorption recovery times crucial of high-speed optoelectronic devices mainly due to strong electron tunneling and thermionic emission. Predicted recovery times are corroborated by bias and temperature dependent time-resolved photoluminescence measurements indicating (<= 30 ps) recovery times. This makes GaInAsSb QW an attractive material particularly for electroabsorption modulators and saturable absorbers. (C) 2013 American Institute of Physics. (http://dx.doi.org/10.1063/1.4775371

Complex emission dynamics of type-II GaSb/GaAs quantum dots

Optical properties of the GaSb/GaAs quantum dot system are investigated using a time-resolved photoluminescence technique. In this type-II heterostructure the carriers of different species are spatially separated and, as a consequence, a smooth evolution of both the emission wavelength and decay timescale is observed. A wavelength shift of 170 nm is measured simultaneously with the progressive timescale change from 100 ps to 23 ns. These phenomena are explained by the evolution of the carrier density, which brings a modification to the optical transition probability as well as the shift in the emission toward the higher energies. (C) 2009 American Institute of Physics. (10.1063/1.3202419

Monolithic InGaAs nanowire array lasers on silicon-on-insulator operating at room temperature

Chip-scale integrated light sources are a crucial component in a broad range of photonics applications. III–V semiconductor nanowire emitters have gained attention as a fascinating approach due to their superior material properties, extremely compact size, and capability to grow directly on lattice-mismatched silicon substrates. Although there have been remarkable advances in nanowire-based emitters, their practical applications are still in the early stages due to the difficulties in integrating nanowire emitters with photonic integrated circuits. Here, we demonstrate for the first time optically pumped III–V nanowire array lasers monolithically integrated on silicon-on-insulator (SOI) platform. Selective-area growth of InGaAs/InGaP core/shell nanowires on an SOI substrate enables the nanowire array to form a photonic crystal nanobeam cavity with superior optical and structural properties, resulting in the laser to operate at room temperature. We also show that the nanowire array lasers are effectively coupled with SOI waveguides by employing nanoepitaxy on a prepatterned SOI platform. These results represent a new platform for ultracompact and energy-efficient optical links and unambiguously point the way toward practical and functional nanowire lasers