Results of heating mode performance tests of a solar-assisted heat pump

The performance of a heat pump, utilizing 8.16 square meters of low-cost solar collectors as the evaporator in a Freon-114 refrigeration cycle, was determined under actual insolation conditions during the summer and fall of 1976. C.O.P.'s (coefficient of performance) greater than 3 were obtained with condensing temperatures around 78 C and evaporating temperatures around 27 C. Ambient temperatures were about 3 C above evaporating temperatures. Similar performance levels were obtained at other insolation and temperature conditions. Experience with the system has identified some component and system changes which should increase the obtainable C.O.P. to about 4.0. These are described along with the system's design rationale. The accumulated data are presented as an appendix

Procedure for analysis of nickel-cadmium cell materials

Quality control procedures include analyses on electrolyte, active materials, and separators for nickel cadmium cell materials. Tests range from the visual/mechanical inspection of cells to gas sampling, electrolyte extract, electrochemical tests, and physical measurements

An economic and performance design study of solar preheaters for domestic hot water heaters in North Carolina

The performance and estimated material costs for several solar preheaters for domestic hot water heaters using isolation levels present in North Carolina are presented. The effects of monthly variations in isolation and the direction of incident radiation are included. Demand is assumed at 13 gallons (49.2 liters) per day per person. The study shows that a closed circulation system with 82 gallons (310 liters) of preheated storage and 53.4 cu ft (4.94 cu m) of collector surface with single cover can be expected to cost about $800 and to repay it capital cost and interest (at 8%) in 5.2 years, assuming present electric rates increase at 5% per year

An analytical investigation of the performance of solar collectors as nighttime heat radiators in airconditioning cycles

It was found that if the upper and lower ends of a collector were opened, large free convention currents may be set up between the collector surface and the cover glass(es) which can result in appreciable heat rejection. If the collector is so designed that both plates surfaces are exposed to convection currents when the upper and lower ends of the collector enclosure are opened, the heat rejection rate is 300 watts sq m when the plate is 13 C above ambient. This is sufficient to permit a collector array designed to provide 100 percent of the heating needs of a home to reject the accumulated daily air conditioning load during the course of a summer night. This also permits the overall energy requirements for cooling to be reduced by at least 15 percent and shift the load on the utility entirely to the nighttime hours

Electrical impedance imaging in two-phase, gas-liquid flows: 1. Initial investigation

The determination of interfacial area density in two-phase, gas-liquid flows is one of the major elements impeding significant development of predictive tools based on the two-fluid model. Currently, these models require coupling of liquid and vapor at interfaces using constitutive equations which do not exist in any but the most rudimentary form. Work described herein represents the first step towards the development of Electrical Impedance Computed Tomography (EICT) for nonintrusive determination of interfacial structure and evolution in such flows

Fail-safe system for activity cooled supersonic and hypersonic aircraft

A fail-safe-system concept was studied as an alternative to a redundant active cooling system for supersonic and hypersonic aircraft which use the heat sink of liquid-hydrogen fuel for cooling the aircraft structure. This concept consists of an abort maneuver by the aircraft and a passive thermal protection system (TPS) for the aircraft skin. The abort manuever provides a low-heat-load descent from normal cruise speed to a lower speed at which cooling is unnecessary, and the passive TPS allows the aircraft skin to absorb the abort heat load without exceeding critical skin temperature. On the basis of results obtained, it appears that this fail-safe-system concept warrants further consideration, inasmuch as a fail-safe system could possibly replace a redundant active cooling system with no increase in weight and would offer other potential advantages

Near-infrared polarimetric observations of the afterglow of GRB 000301C

Based on near-infrared polarimetric observations we constrain the degree of linear polarization of the afterglow light of GRB 000301C to less than 30% 1.8 days after the burst.Comment: To appear in: Proc. 20th Texas Symposium on Relativistic Astrophysics, eds. J. C. Wheeler and H. Marte

Modelling the alumina abundance of oxygen-rich evolved stars in the Large Magellanic Cloud

In order to determine the composition of the dust in the circumstellar envelopes of oxygen-rich asymptotic giant branch (AGB) stars we have computed a grid of modust radiative-transfer models for a range of dust compositions, mass-loss rates, dust shell inner radii and stellar parameters. We compare the resulting colours with the observed oxygen-rich AGB stars from the SAGE-Spec Large Magellanic Cloud (LMC) sample, finding good overall agreement for stars with a mid-infrared excess. We use these models to fit a sample of 37 O-rich AGB stars in the LMC with optically thin circumstellar envelopes, for which 5$-$35-$\mu$m Spitzer infrared spectrograph (IRS) spectra and broadband photometry from the optical to the mid-infrared are available. From the modelling, we find mass-loss rates in the range $\sim 8\times10^{-8}$ to $5\times10^{-6}$ M$_{\odot}\ \mathrm{yr}^{-1}$, and we show that a grain mixture consisting primarily of amorphous silicates, with contributions from amorphous alumina and metallic iron provides a good fit to the observed spectra. Furthermore, we show from dust models that the AKARI [11]$-$[15] versus [3.2]$-$[7] colour-colour diagram, is able to determine the fractional abundance of alumina in O-rich AGB stars.Comment: 22 pages, 17 figures, accepted MNRA

Macroscopic and microscopic studies of electrical properties of very thin silicon dioxide subject to electrical stress

The electrical characteristics of various size tunnel switch diode devices, composed of Al/SiO2/n-Si/p+-Si layers, which operate with a range of parameters (such as current densities in excess of 104 A/cm2) that stress the oxide layer far beyond the levels used in typical thin oxide metal-oxide semiconductor research have been examined. It is found that the first time a large current and electric field are applied to the device, a "forming" process enhances transport through the oxide in the vicinity of the edges of the gate electrode, but the oxide still retains its integrity as a tunnel barrier. The device operation is relatively stable to stresses of greater than 107 C/cm2 areally averaged, time-integrated charge injection. Duplication and characterization of these modified oxide tunneling properties was attempted using scanning tunneling microscopy (STM) to stress and probe the oxide. Electrical stressing with the STM tip creates regions of reduced conductivity, possibly resulting from trapped charge in the oxide. Lateral variations in the conductivity of the unstressed oxide over regions roughly 20–50 nm across were also found

Modulation of endoglin expression in islets of langerhans by VEGF reveals a novel regulator of islet endothelial cell function

BACKGROUND: Endoglin/CD105 is an auxiliary receptor for transforming growth factor-β with established roles in vascular remodelling. It has recently been shown that heterozygous endoglin deficiency in mice decreases insulin secretion in an animal model of obesity, highlighting a potential role for endoglin in the regulation of islet function. We have previously identified two different populations of endoglin expressing cells in human and mouse islets which are: (i) endothelial cells (ECs) and (ii) islet mesenchymal stromal cells. The contribution of islet EC endoglin expression to islet development and sensitivity to VEGF is unknown and is the focus of this study. RESULTS: In vitro culture of mouse islets with VEGF164 for 48 h increased endoglin mRNA levels above untreated controls but VEGF did not modulate VEGFR2, CD31 or CD34 mRNA expression or islet viability. Removal of EC-endoglin expression in vivo reduced islet EC area but had no apparent effect on islet size or architecture. CONCLUSION: EC-specific endoglin expression in islets is sensitive to VEGF and plays partial roles in driving islet vascular development, however such regulation appears to be distinct to mechanisms required to modulate islet viability and size