Conductive Cooling of SDD and SSD Front-End Chips for ALICE

We present analysis, technology developments and test results of the heat drain system of the SDD and SSD front-end electronics for the ALICE Inner Tracker System (ITS). Application of super thermoconductive carbon fibre thin plates provides a practical solution for the development of miniature motherboards for the FEE chips situated inside the sensitive ITS volume. Unidirectional carbon fibre motherboards of 160 -300 micron thickness ensure the mounting of the FEE chips and an efficient heat sink to the cooling arteries. Thermal conductivity up to 1.3 times better than copper is achieved while preserving a negligible multiple scattering contribution by the material (less than 0.15 percent of X/Xo)

Measurement of mechanical vibrations excited in aluminium resonators by 0.6 GeV electrons

We present measurements of mechanical vibrations induced by 0.6 GeV electrons impinging on cylindrical and spherical aluminium resonators. To monitor the amplitude of the resonator's vibrational modes we used piezoelectric ceramic sensors, calibrated by standard accelerometers. Calculations using the thermo-acoustic conversion model, agree well with the experimental data, as demonstrated by the specific variation of the excitation strengths with the absorbed energy, and with the traversing particles' track positions. For the first longitudinal mode of the cylindrical resonator we measured a conversion factor of 7.4 +- 1.4 nm/J, confirming the model value of 10 nm/J. Also, for the spherical resonator, we found the model values for the L=2 and L=1 mode amplitudes to be consistent with our measurement. We thus have confirmed the applicability of the model, and we note that calculations based on the model have shown that next generation resonant mass gravitational wave detectors can only be expected to reach their intended ultra high sensitivity if they will be shielded by an appreciable amount of rock, where a veto detector can reduce the background of remaining impinging cosmic rays effectively.Comment: Tex-Article with epsfile, 34 pages including 13 figures and 5 tables. To be published in Rev. Scient. Instr., May 200

A continuous-discontinuous model for crack branching

This is the peer reviewed version of the following article: Tamayo, E. [et al.]. A continuous-discontinuous model for crack branching. "International journal for numerical methods in engineering", 5 Octubre 2019, vol. 120, núm. 1, p. 86-104, which has been published in final form at https://doi.org/10.1002/nme.6125. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Self-Archiving.A new continuous-discontinuous model for fracture that accounts for crack branching in a natural manner is presented. It combines a gradient-enhanced damage model based on nonlocal displacements to describe diffuse cracks and the extended finite element method (X-FEM) for sharp cracks. Its most distinct feature is a global crack tracking strategy based on the geometrical notion of medial axis: the sharp crack propagates following the direction dictated by the medial axis of a damage isoline. This means that, if the damage field branches, the medial axis automatically detects this bifurcation, and a branching sharp crack is thus easily obtained. In contrast to other existing models, no special crack-tip criteria are required to trigger branching. Complex crack patterns may also be described with this approach, since the X-FEM enrichment of the displacement field can be recursively applied by adding one extra term at each branching event. The proposed approach is also equipped with a crack-fluid pressure, a relevant feature in applications such as hydraulic fracturing or leakage-related events. The capabilities of the model to handle propagation and branching of cracks are illustrated by means of different two-dimensional numerical examples.Peer ReviewedPostprint (author's final draft

Measurement of the production of charm jets tagged with D0^{0} mesons in pp collisions at s\sqrt{s}= 7 TeV

The production of charm jets in proton-proton collisions at a center-of-mass energy of $\sqrt{s}=7$ TeV was measured with the ALICE detector at the CERN Large Hadron Collider. The measurement is based on a data sample corresponding to a total integrated luminosity of $6.23$ ${\rm nb}^{-1}$, collected using a minimum-bias trigger. Charm jets are identified by the presence of a D$^0$ meson among their constituents. The D$^0$ mesons are reconstructed from their hadronic decay D$^0\rightarrow$K$^{-}\pi^{+}$. The D$^0$-meson tagged jets are reconstructed using tracks of charged particles (track-based jets) with the anti-$k_{\mathrm{T}}$ algorithm in the jet transverse momentum range $5<p_{\rm{T,jet}}^{\mathrm{ch}}<30$ ${\rm GeV/}c$ and pseudorapidity $|\eta_{\rm jet}|<0.5$. The fraction of charged jets containing a D$^0$-meson increases with $p_{\rm{T,jet}}^{\rm{ch}}$ from $0.042 \pm 0.004\, \mathrm{(stat)} \pm 0.006\, \mathrm{(syst)}$ to $0.080 \pm 0.009\, \rm{(stat)} \pm 0.008\, \rm{(syst)}$. The distribution of D$^0$-meson tagged jets as a function of the jet momentum fraction carried by the D$^0$ meson in the direction of the jet axis ($z_{||}^{\mathrm{ch}}$) is reported for two ranges of jet transverse momenta, $5<p_{\rm{T,jet}}^{\rm{ch}}<15$ ${\rm GeV/}c$ and $15<p_{\rm{T,jet}}^{\rm{ch}}<30$ ${\rm GeV/}c$ in the intervals $0.2<z_{||}^{\rm{ch}}<1.0$ and $0.4<z_{||}^{\rm{ch}}<1.0$, respectively. The data are compared with results from Monte Carlo event generators (PYTHIA 6, PYTHIA 8 and Herwig 7) and with a Next-to-Leading-Order perturbative Quantum Chromodynamics calculation, obtained with the POWHEG method and interfaced with PYTHIA 6 for the generation of the parton shower, fragmentation, hadronisation and underlying event.Comment: 29 pages, 8 captioned figures, 3 tables, authors from page 24, published version, figures at http://alice-publications.web.cern.ch/node/525

Measurement of pion, kaon and proton production in proton-proton collisions at s=7\sqrt{s}=7 TeV

The measurement of primary $\pi^{\pm}$, K$^{\pm}$, p and $\overline{p}$ production at mid-rapidity ($|y| <$ 0.5) in proton-proton collisions at $\sqrt{s} = 7$ TeV performed with ALICE (A Large Ion Collider Experiment) at the Large Hadron Collider (LHC) is reported. Particle identification is performed using the specific ionization energy loss and time-of-flight information, the ring-imaging Cherenkov technique and the kink-topology identification of weak decays of charged kaons. Transverse momentum spectra are measured from 0.1 up to 3 GeV/$c$ for pions, from 0.2 up to 6 GeV/$c$ for kaons and from 0.3 up to 6 GeV/$c$ for protons. The measured spectra and particle ratios are compared with QCD-inspired models, tuned to reproduce also the earlier measurements performed at the LHC. Furthermore, the integrated particle yields and ratios as well as the average transverse momenta are compared with results at lower collision energies.Comment: 33 pages, 19 captioned figures, 3 tables, authors from page 28, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/156

Energy dependence of exclusive J/ψJ/\psi photoproduction off protons in ultra-peripheral p-Pb collisions at sNN\sqrt{s_{\rm{NN}}} = 5.02 TeV

The ALICE Collaboration has measured the energy dependence of exclusive photoproduction of $J/\psi$ vector mesons off proton targets in ultra-peripheral p-Pb collisions at a centre-of-mass energy per nucleon pair $\sqrt{s_{\rm NN}} = 5.02$ TeV. The e$^+$e$^-$ and $\mu^+\mu^-$ decay channels are used to measure the cross section as a function of the rapidity of the $J/\psi$ in the range $-2.5 < y < 2.7$, corresponding to an energy in the $\gamma$p centre-of-mass in the interval $40 < W_{\gamma\mathrm{p}}<550$ GeV. The measurements, which are consistent with a power law dependence of the exclusive $J/\psi$ photoproduction cross section, are compared to previous results from HERA and the LHC and to several theoretical models. They are found to be compatible with previous measurements.Comment: 25 pages, 3 captioned figures, 3 tables, authors from page 19, published version, figures at http://alice-publications.web.cern.ch/node/455

First measurement of Ξc0\Xi_{\rm c}^0 production in pp collisions at s\mathbf{\sqrt{s}} = 7 TeV

The production of the charm-strange baryon $\Xi_{\rm c}^0$ is measured for the first time at the LHC via its semileptonic decay into e$^+\Xi^-\nu_{\rm e}$ in pp collisions at $\sqrt{s}=7$ TeV with the ALICE detector. The transverse momentum ($p_{\rm T}$) differential cross section multiplied by the branching ratio is presented in the interval 1 $<$ $p_{\rm T}$ $<$ 8 GeV/$c$ at mid-rapidity, $|y|$ $<$ 0.5. The transverse momentum dependence of the $\Xi_{\rm c}^0$ baryon production relative to the D$^0$ meson production is compared to predictions of event generators with various tunes of the hadronisation mechanism, which are found to underestimate the measured cross-section ratio.Comment: 22 pages, 6 captioned figures, 1 table, authors from page 17, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/412

Spin-Momentum Correlations in Quasi-Elastic Electron Scattering from Deuterium

We report on a measurement of spin-momentum correlations in quasi-elastic scattering of longitudinally polarized electrons with an energy of 720 MeV from vector-polarized deuterium. The spin correlation parameter $A^V_{ed}$ was measured for the $^2 \vec{\rm H}(\vec e,e^\prime p)n$ reaction for missing momenta up to 350 MeV/$c$ at a four-momentum transfer squared of 0.21 (GeV/c)$^2$. The data give detailed information about the spin structure of the deuteron, and are in good agreement with the predictions of microscopic calculations based on realistic nucleon-nucleon potentials and including various spin-dependent reaction mechanism effects. The experiment demonstrates in a most direct manner the effects of the D-state in the deuteron ground-state wave function and shows the importance of isobar configurations for this reaction.Comment: 4 pages, 3 figures, submitted to Phys. Rev. Lett. for publicatio

Measurement of an excess in the yield of J/ψ\psi at very low pTp_{\rm T} in Pb-Pb collisions at sNN\sqrt{s_{\rm NN}} = 2.76 TeV

We report on the first measurement of an excess in the yield of J/$\psi$ at very low transverse momentum ($p_{\rm T}< 0.3$ GeV/$c$) in peripheral hadronic Pb-Pb collisions at $\sqrt{s_{\rm NN}}$ = 2.76 TeV, performed by ALICE at the CERN LHC. Remarkably, the measured nuclear modification factor of J/$\psi$ in the rapidity range $2.5<y<4$ reaches about 7 (2) in the $p_{\rm T}$ range 0-0.3 GeV/$c$ in the 70-90% (50-70%) centrality class. The J/$\psi$ production cross section associated with the observed excess is obtained under the hypothesis that coherent photoproduction of J/$\psi$ is the underlying physics mechanism. If confirmed, the observation of J/$\psi$ coherent photoproduction in Pb-Pb collisions at impact parameters smaller than twice the nuclear radius opens new theoretical and experimental challenges and opportunities. In particular, coherent photoproduction accompanying hadronic collisions may provide insight into the dynamics of photoproduction and nuclear reactions, as well as become a novel probe of the Quark-Gluon Plasma.Comment: 18 pages, 3 captioned figures, 1 table, authors from page 13, published version, figures at http://aliceinfo.cern.ch/ArtSubmission/node/191