Ion beam induced enhanced diffusion from gold thin films in silicon

Enhanced diffusion of gold atoms into silicon substrate has been studied in Au thin films of various thicknesses (2.0, 5.3, 10.9 and 27.5 nm) deposited on Si(111) and followed by irradiation with 1.5 MeV Au2+ at a flux of 6.3x10^12 ions cm-2 s-1 and fluence up to 1x10^15 ions cm-2. The high resolution transmission electron microscopy measurements showed the presence of gold silicide formation for the above-mentioned systems at fluence greater than equal to 1x1014 ions cm-2. The maximum depth to which the gold atoms have been diffused at a fluence of 1x10^14 ions cm-2 for the cases of 2.0, 5.3, 10.9 and 27.5 nm thick films has been found to be 60, 95, 160 and 13 nm respectively. Interestingly, at higher fluence of 1x1015 ions cm-2 in case of 27.5 nm thick film, gold atoms from the film transported to a maximum depth of 265 nm in the substrate. The substrate silicon is found to be amorphous at the above fluence values where unusually large mass transport occurred. Enhanced diffusion has been explained on the basis of ion beam induced, flux dependent amorphous nature of the substrate, and transient beam induced temperature effects. This work confirms the absence of confinement effects that arise from spatially confined structures and existence of thermal and chemical reactions during ion irradiation.Comment: 15 pages, 3 figure

Stabilized Lateritic Blocks Reinforced With Fibrous Coir Wastes

Tropical countries are rich in lateritic soil, a naturally available raw material for building construction. But its potential in block making is not yet satisfactorily explored. This paper focuses on an experimental investigation for improvising stabilized lateritic blocks (SLB) with coir cutting wastes from coir industry as reinforcing elements. Lateritic soil used in this study showed a higher percentage of clay content. Hence it was pre-stabilized with sand and cement. Blocks were prepared by stabilizing it further with waste fibrous additives and tested for strength and durability. Considerable improvement in strength (compressive strength @19% and tensile strength @ 9%) and durability characteristics were exhibited by the new fiber reinforced lateritic blocks (FRLB) with fiber content of 0.5%. These blocks can be successfully proposed for load bearing construction and as well as for earthquake resistant structure

Discriminating quantum-optical beam-splitter channels with number-diagonal signal states: Applications to quantum reading and target detection

We consider the problem of distinguishing, with minimum probability of error, two optical beam-splitter channels with unequal complex-valued reflectivities using general quantum probe states entangled over M signal and M' idler mode pairs of which the signal modes are bounced off the beam splitter while the idler modes are retained losslessly. We obtain a lower bound on the output state fidelity valid for any pure input state. We define number-diagonal signal (NDS) states to be input states whose density operator in the signal modes is diagonal in the multimode number basis. For such input states, we derive series formulas for the optimal error probability, the output state fidelity, and the Chernoff-type upper bounds on the error probability. For the special cases of quantum reading of a classical digital memory and target detection (for which the reflectivities are real valued), we show that for a given input signal photon probability distribution, the fidelity is minimized by the NDS states with that distribution and that for a given average total signal energy N_s, the fidelity is minimized by any multimode Fock state with N_s total signal photons. For reading of an ideal memory, it is shown that Fock state inputs minimize the Chernoff bound. For target detection under high-loss conditions, a no-go result showing the lack of appreciable quantum advantage over coherent state transmitters is derived. A comparison of the error probability performance for quantum reading of number state and two-mode squeezed vacuum state (or EPR state) transmitters relative to coherent state transmitters is presented for various values of the reflectances. While the nonclassical states in general perform better than the coherent state, the quantitative performance gains differ depending on the values of the reflectances.Comment: 12 pages, 7 figures. This closely approximates the published version. The major change from v2 is that Section IV has been re-organized, with a no-go result for target detection under high loss conditions highlighted. The last sentence of the abstract has been deleted to conform to the arXiv word limit. Please see the PDF for the full abstrac

Carrier multiplication yields in PbS and PbSe nanocrystals measured by transient photoluminescence

We report here an assessment of carrier multiplication (CM) yields in PbSe and PbS nanocrystals (NCs) by a quantitative analysis of biexciton and exciton dynamics in transient photoluminescence decays. Interest in CM, the generation of more than one electron and hole in a semiconductor after absorption of one photon, has renewed in recent years because of reports suggesting greatly increased efficiencies in nanocrystalline materials compared to the bulk form, in which CM was otherwise too weak to be of consequence in photovoltaic energy conversion devices. In our PbSe and PbS NC samples, however, we estimate using transient photoluminescence that at most 0.25 additional e-h pairs are generated per photon even at energies hv > 5Eg, instead of the much higher values reported in the literature. We argue by comparing NC CM estimates and reported bulk values on an absolute energy basis, which we justify as appropriate on physical grounds, that the data reported thus far are inconclusive with respect to the importance of nanoscale-specific phenomena in the CM process.Comment: 10 pages, 7 figure

Vibrio parahaemolyticus and the seafood industry

The role of Vibrio parahaemolyticus in food borne gastroenteritis outbreaks associated primarily with the consumption of contaminated seafoods has been well documented. Information pertaining to various aspects of its occurrence in seafoods, procedures for isolation and identification, generation time and inactivation profiles is discussed. Emphasis has been given to the response of V. parahaemolyticus to low temperatures, heating and antibacterial agents. The public health hazard posed by the pathogen is outlined and the guidelines for control are reviewed in detail

Hyperfine interaction and electronic spin fluctuation study on Sr2−x_{2-x}Lax_xFeCoO6_6 (x = 0, 1, 2) by high-resolution back-scattering neutron spectroscopy

The study of hyperfine interaction by high-resolution inelastic neutron scattering is not very well known compared to the other competing techniques viz. NMR, M\"ossbauer, PACS etc. Also the study is limited mostly to magnetically ordered systems. Here we report such study on Sr$_{2-x}$La$_x$FeCoO$_6$ (x = 0, 1, 2) of which first (Sr$_2$FeCoO$_6$ with x = 0) has a canonical spin spin glass, the second (SrLaFeCoO$_6$ with x = 1) has a so-called magnetic glass and the third (La$_2$FeCoO$_6$ with x = 2) has a magnetically ordered ground state. Our present study revealed clear inelastic signal for SrLaFeCoO$_6$, possibly also inelastic signal for Sr$_2$FeCoO$_6$ below the spin freezing temperatures $T_{sf}$ but no inelastic signal at all for for the magnetically ordered La$_2$FeCoO$_6$ in the neutron scattering spectra. The broadened inelastic signals observed suggest hyperfine field distribution in the two disordered magnetic glassy systems and no signal for the third compound suggests no or very small hyperfine field at the Co nucleus due to Co electronic moment. For the two magnetic glassy system apart from the hyperfine signal due only to Co, we also observed electronic spin fluctuations probably from both Fe and Co electronic moments. \end{abstract

Flux dependent 1.5 MeV self-ion beam induced sputtering from Gold nanostructured thin films

We discuss four important aspects of 1.5 MeV Au2+ ion-induced flux dependent sputtering from gold nanostrcutures (of an average size 7.6 nm and height 6.9 nm) that are deposited on silicon substrates: (a) Au sputtering yield at the ion flux of 6.3x10^12 ions cm-2 s-1 is found to be 312 atoms/ion which is about five times the sputtering yield reported earlier under identical irradiation conditions at a lower beam flux of 10^9 ions cm-2 s-1, (b) the sputtered yield increases with increasing flux at lower fluence and reduces at higher fluence (1.0x10^15 ions cm-2) for nanostructured thin films while the sputtering yield increases with increasing flux and fluence for thick films (27.5 nm Au deposited on Si) (c) Size distribution of sputtered particles has been found to vary with the incident beam flux showing a bimodal distribution at higher flux and (d) the decay exponent obtained from the size distributions of sputtered particles showed an inverse power law dependence ranging from 1.5 to 2.5 as a function of incident beam flux. The exponent values have been compared with existing theoretical models to understand the underlying mechanism. The role of wafer temperature associated with the beam flux has been invoked for a qualitative understanding of the sputtering results in both the nanostructured thin films and thick films.Comment: 25 pages, 5 figures, 1 table To be Appeared in J. Phys. D: Appl. Phy