Cross-Layer Support for Energy Efficient Routing in Wireless Sensor Networks

The Dynamic Source Routing (DSR) algorithm computes a new route when packet loss occurs. DSR does not have an in-built mechanism to determine whether the packet loss was the result of congestion or node failure causing DSR to compute a new route. This leads to inefficient energy utilization when DSR is used in wireless sensor networks. In this work, we exploit cross-layer optimization techniques that extend DSR to improve its routing energy efficiency by minimizing the frequency of recomputed routes. Our proposed approach enables DSR to initiate a route discovery only when link failure occurs. We conducted extensive simulations to evaluate the performance of our proposed cross-layer DSR routing protocol. The simulation results obtained with our extended DSR routing protocol show that the frequency with which new routes are recomputed is 50% lower compared with the traditional DSR protocol. This improvement is attributed to the fact that, with our proposed cross-layer DSR, we distinguish between congestion and link failure conditions, and new routes are recalculated only for the latter

Wireless multimedia delivery over 802.11e with cross-layer optimization techniques

The use of wireless networks has spread further than simple data transfer to delay sensitive and loss tolerant multimedia applications. Over the past few years, wireless multimedia transmission across Wireless Local area Networks (WLANs) has gained a lot of attention because of the introduction of technologies such as Bluetooth, IEEE 802.11, 3G, and WiMAX. The IEEE 802.11 WLAN has become a dominating technology due to its low cost and ease of implementation. But, transmitting video over WLANs in real time remains a challenge because it imposes strong demands on video codec, the underlying network, and the Media Access Control (MAC) layer. This paper presents a cross-layer mapping algorithm to improve the quality of transmission of H.264 (a recently-developed video coding standard of the ITU-T Video Coding Experts Group) video stream over IEEE 802.11e-based wireless networks. The major goals of H.264 standard were on improving the rate distortion and the enhanced compression performance. Our proposed cross-layer design involves the mapping of H.264 video slices (packets) to appropriate access categories of IEEE 802.11e according to their information significance. We evaluate the performance of our proposed cross-layer design and the results obtained demonstrate its effectiveness in exploiting characteristics of the MAC and application layers to improve the video transmission quality