Some Applications of Detailed Wind Profile Data to Launch Vehicle Response Problems

The response of a launch vehicle to a number of detailed wind profiles has been determined. The wind profiles were measured by two techniques which are briefly described. One of these techniques uses an angle-of-attack sensor in conjunction with guidance data to measure the wind profile traversed by some particular launch vehicle. The other wind-measuring technique is a photographic triangulation method, whereby two cameras take simultaneous pictures of a vertical trail of smoke left by a launch vehicle or sounding rocket. The response of a vehicle flying these detailed profiles is compared with the response of the same vehicle flying through balloon-measured profiles. The response to the detailed wind profiles, relative t o the balloon-measured profiles, is characterized by the large excitation of the rigid pitch and elastic bending modes. This is found to cause higher loads on the launch vehicle structure. Established design criteria which utilize balloon measured wind profiles have arbitrarily accounted-for this increased load by adding a load due to some type of discrete gust

Unpowered Aerodynamic Characteristics of a 15-Percent Scale Model of a Twin-Engine Commuter Aircraft

An experimental investigation was conducted in the Ames 12-Foot Pressure Wind Tunnel to determine the unpowered aerodynamic characteristics of a 15-percent-scale model of a twin-engine commuter aircraft. Model longitudinal aerodynamic characteristics were examined at discrete flap deflections for various angle-of-attack and wind-tunnel-velocity ranges with the empennage on and off. Data are presented for the basic model configuration consisting of the fuselage, wing, basic wing leading edge, double slotted flaps, midengine nacelles, and empennage. Other configurations tested include a particle-span drooped leading edge (dropped outboard of the engine nacelles), a full-span drooped leading edge, low- and high-mounted engine nacelles, and a single-slotted flap. An evaluation was made of the model mounting system by comparing data obtained with the model mounted conventionally on the wind-tunnel model-support struts and the model inverted

Arcuate nucleus homeostatic systems reflect blood leptin concentration but not feeding behaviour during scheduled feeding on a high-fat diet in mice

Acknowledgements T.B. was funded by a CASE studentship from the BBSRC and AstraZeneca. J.B. was a summer student from Bordeaux Sciences Agro and funded by student laboratory experience grant from the British Society of Neuroendocrinology. The authors are also grateful for funding from the Scottish Government, and from the European Union Seventh Framework Programme (FP7/2007-2013) under grant agreements 266408 (Full4Health) and 245009 (NeuroFAST).Peer reviewedPublisher PD

Development of Ground-testable Phase Fresnel Lenses in Silicon

Diffractive/refractive optics, such as Phase Fresnel Lenses (PFL's), offer the potential to achieve excellent imaging performance in the x-ray and gamma-ray photon regimes. In principle, the angular resolution obtained with these devices can be diffraction limited. Furthermore, improvements in signal sensitivity can be achieved as virtually the entire flux incident on a lens can be concentrated onto a small detector area. In order to verify experimentally the imaging performance, we have fabricated PFL's in silicon using gray-scale lithography to produce the required Fresnel profile. These devices are to be evaluated in the recently constructed 600-meter x-ray interferometry testbed at NASA/GSFC. Profile measurements of the Fresnel structures in fabricated PFL's have been performed and have been used to obtain initial characterization of the expected PFL imaging efficiencies.Comment: Presented at GammaWave05: "Focusing Telescopes in Nuclear Astrophysics", Bonifacio, Corsica, September 2005, to be published in Experimental Astronomy, 8 pages, 3 figure

Identification of Trace Organic Components in the CR Chondrites by 4D TOFMS

This paper reports preliminary results of a 4D TOFMS study of CR chondrite organic material, highlighting the low-level organic species that may further reveal the complexity of parent body modification of interstellar precursors

First-principles prediction of redox potentials in transition-metal compounds with LDA+U

First-principles calculations within the Local Density Approximation (LDA) or Generalized Gradient Approximation (GGA), though very successful, are known to underestimate redox potentials, such as those at which lithium intercalates in transition metal compounds. We argue that this inaccuracy is related to the lack of cancellation of electron self-interaction errors in LDA/GGA and can be improved by using the DFT+$U$ method with a self-consistent evaluation of the $U$ parameter. We show that, using this approach, the experimental lithium intercalation voltages of a number of transition metal compounds, including the olivine Li$_{x}$MPO$_{4}$ (M=Mn, Fe Co, Ni), layered Li$_{x}$MO$_{2}$ ($x=$Co, Ni) and spinel-like Li$_{x}$M$_{2}$O$_{4}$ (M=Mn, Co), can be reproduced accurately.Comment: 19 pages, 6 figures, Phys. Rev. B 70, 235121 (2004

Testing equality of variances in the analysis of repeated measurements

The problem of comparing the precisions of two instruments using repeated measurements can be cast as an extension of the Pitman-Morgan problem of testing equality of variances of a bivariate normal distribution. Hawkins (1981) decomposes the hypothesis of equal variances in this model into two subhypotheses for which simple tests exist. For the overall hypothesis he proposes to combine the tests of the subhypotheses using Fisher's method and empirically compares the component tests and their combination with the likelihood ratio test. In this paper an attempt is made to resolve some discrepancies and puzzling conclusions in Hawkins's study and to propose simple modifications.\ud \ud The new tests are compared to the tests discussed by Hawkins and to each other both in terms of the finite sample power (estimated by Monte Carlo simulation) and theoretically in terms of asymptotic relative efficiencies