Measured opening characteristics of an electromagnetically opened diaphragm for the Langley expansion tunnel

Results from an experimental study of the opening characteristics of an electromagnetically opened, 15.24 cm diameter diaphragm are presented. This diaphragm consists of a polyester film bonded to a preformed wire and is opened by passing a current pulse (capacitor discharge) through the wire. The diaphragm separates the acceleration section of the expansion tunnel from the nozzle so that the nozzle may be at a lower pressure than the acceleration section prior to a test. Opening times and cleanness of the opened area were examined for dependence on diaphragm thickness, on wire diameter, on technique of bonding the wire to the diaphragm, and on voltage and energy level of the energy source. Time histories of the pitot pressure measured at the expansion-tunnel nozzle entrance location are presented for (1) no diaphragm, (2) a flow-opened diaphragm, and (3) an electromagnetically opened diaphragm

Description and initial operating performance of the Langley 6-inch expansion tube using heated helium driver gas

A general description of the Langley 6-inch expansion tube is presented along with discussion of the basic components, internal resistance heater, arc-discharge assemblies, instrumentation, and operating procedure. Preliminary results using unheated and resistance-heated helium as the driver gas are presented. The driver-gas pressure ranged from approximately 17 to 59 MPa and its temperature ranged from 300 to 510 K. Interface velocities of approximately 3.8 to 6.7 km/sec were generated between the test gas and the acceleration gas using air as the test gas and helium as the acceleration gas. Test flow quality and comparison of measured and predicted expansion-tube flow quantities are discussed

Investigation of a twisted cambered wing with a 75 deg swept leading edge at mach 3 and reynolds numbers to 39 x 106

Wing planforms with highly swept subsonic leading edges at Mach

Disappearance of the de Almeida-Thouless line in six dimensions

We show that the Almeida-Thouless line in Ising spin glasses vanishes when their dimension d -> 6 as h_{AT}^2/T_c^2 = C(d-6)^4(1- T/T_c)^{d/2 - 1}, where C is a constant of order unity. An equivalent result which could be checked by simulations is given for the one-dimensional Ising spin glass with long-range interactions. It is shown that replica symmetry breaking also stops as d -> 6.Comment: Additional text and one figure adde

Reply to "Comment on Evidence for the droplet picture of spin glasses"

Using Monte Carlo simulations (MCS) and the Migdal-Kadanoff approximation (MKA), Marinari et al. study in their comment on our paper the link overlap between two replicas of a three-dimensional Ising spin glass in the presence of a coupling between the replicas. They claim that the results of the MCS indicate replica symmetry breaking (RSB), while those of the MKA are trivial, and that moderate size lattices display the true low temperature behavior. Here we show that these claims are incorrect, and that the results of MCS and MKA both can be explained within the droplet picture.Comment: 1 page, 1 figur

Exploratory study of performance of the Langley pilot model expansion tube with a hydrogen driver

Expansion tube for simulating hypervelocity flow conditions for reentry vehicle

Fish tracking technology development. Phases 1 and 2, project definition desk study and equipment

The document reports on the major findings from a definition study to appraise the options to develop fish tracking equipment, in particular tags and data logging systems, in order to improve the effeciency of the Agency tracking studies and to obtain a greater understanding of fish biology. The definition study was in two parts. The first, Phase 1, collated and evaluated all the known tracking systems that may be suitable for studies of fish which are either produced commercially or have been constructed for specific in-house studies. Phase 2 was an evaluation of all the tracking equipment considered to merit further investigation in Phase 1. The deficiencies between existing and required technologies to improve the efficiency of Agency's tracking studies and to obtain a greater understanding of fish biology are also identified