7 research outputs found

    Displacement probes with self-contained exciting medium

    Get PDF
    A transducer that combines a noncontacting displacement probe with a self-contained target is described. The target is held in position against a vibrating surface by a housing which also supports the noncontacting probe. The target vibrates with the surface and the probe senses the vibrations of the target

    Vibration studies of a lightweight three-sided membrane suitable for space application

    Get PDF
    Vibration studies carried out in a vacuum chamber are reported for a three-sided membrane with inwardly curved edges. Uniform tension was transmitted by thin steel cables encased in the edges. Variation of ambient air pressure from atmospheric to near vacuum resulted in increased response frequencies and amplitudes. The first few vibration modes measured in a near vacuum are shown to be predictable by a finite element structural analysis over a range of applied tension loads. The complicated vibration mode behavior observed during tests at various air pressures is studied analytically with a nonstructural effective air-mass approximation. The membrane structure is a candidate for reflective surfaces in space antennas

    Deployment and performance characteristics of 1.5-meter supersonic attached inflatable decelerators

    Get PDF
    Attached-inflatable-decelerator (AID) canopies fabricated from lightweight Nomex cloth and tapes were deployed in a supersonic stream from the base of a 140 deg conical aeroshell. Characteristics of the deceleration system were obtained over a wide range of Mach number, dynamic pressure, and pitch angle. All models deployed rapidly by ram air and experienced only mild deployment shock loads. Steady-state drag coefficients as high as 1.3 were obtained in the supersonic stream and were relatively insensitive to Mach number, dynamic pressure, and pitch angle. All models were free of fluttering motion. Results also showed that the AID is aerodynamically more efficient without a burble fence in a supersonic stream. Though measured meridian-tape loads were higher than those predicted by theory, the ram-air deployment rates and steady-state drag coefficients were in good agreement with theory. These results indicate that the AID is a stable, efficient decelerator in a supersonic stream and its performance is readily predictable

    Some space shuttle tile/strain-isolator-pad sinusoidal vibration tests

    Get PDF
    Vibration tests were performed on the tile/strain-isolator-pad system used as thermal protection for the space shuttle orbiter. Experimental data on normal and in-plane vibration response and damping properties are presented. Three test specimens exhibited shear type motion during failures that occurred in the tile near the tile/strain-isolator-pad bond-line. A dynamic instability is described which has large in-plane motion at a frequency one-half that of the nominal driving frequency. Analysis shows that this phenomenon is a parametric response

    Aerothermal performance and structural integrity of a Rene 41 thermal protection system at Mach 6.6

    Get PDF
    A flightweight panel based on a metallic thermal-protection-system concept for hypersonic and reentry vehicles was subjected repeatedly to thermal cycling by quartz-lamp radiant heating using a thermal history representative of a reentry heat pulse and to aerodynamic heating at heating rates required to sustain a surface temperature of 1089 K (1960 R). The panel consisted of a corrugated heat shield and support members of 0.05-cm (0.02-in.) thick Rene 41 of riveted construction and 5.08-cm (2-in.) thick silica fibrous insulation packages covered by Rene 41 foil and inconel screening. All tests were conducted in the Langley 8-foot high-temperature structures tunnel with the heat shield corrugations alined in the stream direction. The panel sustained 5.33 hr of intermittent radiant heating and 6.5 min of intermittent aerodynamic heating of up to 1-min duration for differential pressures up to 6.2 kPa (0.9 psi) with no apparent degradation of thermal or structural integrity, as indicated by temperature distributions and results from load deflection tests and vibration surveys of natural frequencies
    corecore