The effect of clock, media, and station location errors on Doppler measurement accuracy

Doppler tracking by the Deep Space Network (DSN) is the primary radio metric data type used by navigation to determine the orbit of a spacecraft. The accuracy normally attributed to orbits determined exclusively with Doppler data is about 0.5 microradians in geocentric angle. Recently, the Doppler measurement system has evolved to a high degree of precision primarily because of tracking at X-band frequencies (7.2 to 8.5 GHz). However, the orbit determination system has not been able to fully utilize this improved measurement accuracy because of calibration errors associated with transmission media, the location of tracking stations on the Earth's surface, the orientation of the Earth as an observing platform, and timekeeping. With the introduction of Global Positioning System (GPS) data, it may be possible to remove a significant error associated with the troposphere. In this article, the effect of various calibration errors associated with transmission media, Earth platform parameters, and clocks are examined. With the introduction of GPS calibrations, it is predicted that a Doppler tracking accuracy of 0.05 microradians is achievable

Cross-calibration of Suzaku XIS and XMM-Newton EPIC using clusters of galaxies

We extend a previous cross-calibration study by the International Astronomical Consortium for High Energy Calibration (IACHEC) on XMM-Newton/EPIC, Chandra/ACIS and BeppoSAX/MECS X-ray instruments with clusters of galaxies to Suzaku/XIS instruments. Our aim is to study the accuracy of the energy-dependent effective area calibration of the XIS instruments by comparison of spectroscopic temperatures, fluxes and fit residuals obtained with Suzaku/XIS and XMM-Newton/EPIC-pn for the same cluster. The temperatures measured in the hard 2.0-7.0 keV energy band with all instruments are consistent within 5 %. However, temperatures obtained with the XIS instruments in the soft 0.5-2.0 keV band disagree by 9-29 %. We investigated residuals in the XIS soft band, which showed that if XIS0 effective area shape is accurately calibrated, the effective areas of XIS1 and XIS3 are overestimated below 1.0 keV (or vice versa). Adjustments to the modelling of the column density of the XIS contaminant in the 3-6 arcmin extraction region while forcing consistent emission models in each instrument for a given cluster significantly improved the fits. The oxygen column density in XIS1 and XIS3 contaminant must be increased by 1-2E17 cm^-2 in comparison to the values implemented in the current calibration, while the column density of the XIS0 contaminant given by the analysis is consistent with the public calibration. XIS soft band temperatures obtained with the modification to the column density of the contaminant agree better with temperatures obtained with the EPIC-pn instrument of XMM-Newton, than with those derived using the Chandra-ACIS instrument. However, comparison of hard band fluxes obtained using Suzaku-XIS to fluxes obtained using the Chandra-ACIS and EPIC-pn instruments proved inconclusive.Comment: 24 pages, 27 figures, accepted for publication in Astronomy & Astrophysic

A study of structural concepts for ultralightweight spacecraft

Structural concepts for ultralightweight spacecraft were studied. Concepts for ultralightweight space structures were identified and the validity of heir potential application in advanced spacecraft was assessed. The following topics were investigated: (1) membrane wrinkling under pretensioning; (2) load-carrying capability of pressurized tubes; (3) equilibrium of a precompressed rim; (4) design of an inflated reflector spacecraft; (5) general instability of a rim; and (6) structural analysis of a pressurized isotensoid column. The design approaches for a paraboloidal reflector spacecraft included a spin-stiffened design, both inflated and truss central columns, and to include both deep truss and rim-stiffened geodesic designs. The spinning spacecraft analysis is included, and the two truss designs are covered. The performances of four different approaches to the structural design of a paraboloidal reflector spacecraft are compared. The spinning and inflated configurations result in very low total masses and some concerns about their performance due to unresolved questions about dynamic stability and lifetimes, respectively

Determining masses of supersymmetric particles

If supersymmetric particles are produced at the Large Hadron Collider it becomes very important not only to identify them, but also to determine their masses with the highest possible precision, since this may lead to an understanding of the SUSY-breaking mechanism and the physics at some higher scale. We here report on studies of how such mass measurements are obtained, and how the precision can be optimized.Comment: 11 pages, contribution to the proceedings "II. Southeastern European Workshop Challenges Beyond The Standard Model", 19-23 May 2005, Vrnjacka Banja, Serbi

Interaction between superconductor and ferromagnetic domains in iron sheath: peak effect in MgB2/Fe wires

Interaction between the superconductor and ferromagnet in MgB2/Fe wires results in either a plateau or a peak effect in the field dependence of transport critical current, Ic(H). This is in addition to magnetic shielding of external field. Current theoretical models cannot account for the observed peak effect in Ic(H). This paper shows that the theoretical explanation of the peak effect should be sought in terms of interaction between superconductor and magnetic domain structure, obtained after re-magnetization of the iron sheath by the self-field of the current. There is a minimum value of critical current, below which the re-magnetization of the iron sheath and peak effect in Ic(H) are not observed

Resolving ambiguities in mass determinations at future colliders

The measurements of kinematical endpoints, in cascade decays of supersymmetric particles, in principle allow for a determination of the masses of the unstable particles. However, in this procedure ambiguities often arise. We here illustrate how such ambiguities arise. They can be resolved by a precise determination of the LSP mass, provided by the Linear Collider.Comment: 6 pages, 6 figures, to appear in the proceedings of the 2005 International Linear Collider Workshop, Stanford, U.S.