The impact of bone mineral density and disc degeneration on shear strength and stiffness of the lumbar spine following laminectomy

Purpose Laminectomy is a standard surgical procedure for elderly patients with symptomatic degenerative lumbar stenosis. The procedure aims at decompression of the affected nerves, but it also causes a reduction of spinal shear strength and shear stiffness. The magnitude of this reduction and the influence of bone mineral density (BMD) and disc degeneration are unknown. We studied the influence of laminectomy, BMD, and disc degeneration on shear force to failure (SFF) and shear stiffness (SS). Methods Ten human cadaveric lumbar spines were obtained (mean age 72.1 years, range 53-89 years). Laminectomy was performed either on L2 or L4, equally divided within the group of ten spines. BMD was assessed by dual X-ray absorptiometry (DXA). Low BMD was defined as a BMD value below the median. Intervertebral discs were assessed for degeneration by MRI (Pfirrmann) and scaled in mild and severe degeneration groups. Motion segments L2-L3 and L4-L5 were isolated from each spine. SFF and SS were measured, while loading simultaneously with 1,600 N axial compression. Results Low BMD had a significant negative effect on SFF. In addition, a significant interaction between low BMD and laminectomy was found. In the high BMD group, SFF was 2,482 N (range 1,678-3,284) and decreased to 1,371 N (range 940-1,886) after laminectomy. In the low BMD group, SFF was 1,339 N (range 909-1,628) and decreased to 761 N (range 561-1,221). Disc degeneration did not affect SFF, nor did it interact with laminectomy. Neither low BMD nor the interaction of low BMD and laminectomy did affect SS. Degeneration and its interaction with laminectomy did not significantly affect SS. Conclusions In conclusion, low BMD significantly decreased SFF before and after lumbar laminectomy. Therefore, DXA assessment may be an important asset to preoperative screening. Lumbar disc degeneration did not affect shear properties of lumbar segments before or after laminectomy. © 2012 Springer-Verlag

Short-term cost-effectiveness of one-stage implant-based breast reconstruction with an acellular dermal matrix versus two-stage expander-implant reconstruction from a multicentre randomized clinical trial

Background: Implant-based breast reconstruction (IBBR) is the most commonly performed reconstructive procedure and its economic impact is significant. This study aimed to analyse whether a direct one-stage IBBR with use of an acellular dermal matrix (ADM) is more cost-effective than two-stage (expander-implant) breast reconstruction. Methods: The BRIOS (Breast Reconstruction In One Stage) study was an open-label multicentre RCT in which women scheduled for skin-sparing mastectomy and immediate IBBR were randomized between one-stage IBBR with ADM or two-stage IBBR. Duration of surgery and hospital stay, and visits for the primary surgery, unplanned and cosmetic procedures were recorded. Costs were estimated at an institutional level. Health status was assessed by means of the EuroQol Five Dimensions 5L questionnaire. Results: Fifty-nine patients (91 breasts) underwent one-stage IBBR with ADM and 62 patients (92 breasts) two-stage IBBR. The mean(s.d.) duration of surgery in the one-stage group was significantly longer than that for two-stage IBBR for unilateral (2⋅52(0⋅55) versus 2⋅02(0⋅35) h; P < 0⋅001) and bilateral (4⋅03(1⋅00) versus 3⋅25(0⋅58) h; P = 0⋅017) reconstructions. Costs were higher for one-stage compared with two-stage IBBR for both unilateral (€12 448 (95 per cent c.i. 10 722 to 14 387) versus €9871 (9373 to 10 445) respectively; P = 0⋅025) and bilateral (€16 939 (14 887 to 19 360) versus €13 383 (12 414 to 14 669); P = 0⋅002) reconstructions. This was partly related to the use of relatively expensive ADM. There was no difference in postoperative health status between the groups. Conclusion: One-stage IBBR with ADM was associated with higher costs, but similar health status, compared with conventional two-stage IBBR. Registration number: NTR5446 (http://www .trialregister.nl)

A Dutch guideline for the treatment of scoliosis in neuromuscular disorders

<p>Abstract</p> <p>Background</p> <p>Children with neuromuscular disorders with a progressive muscle weakness such as Duchenne Muscular Dystrophy and Spinal Muscular Atrophy frequently develop a progressive scoliosis. A severe scoliosis compromises respiratory function and makes sitting more difficult. Spinal surgery is considered the primary treatment option for correcting severe scoliosis in neuromuscular disorders. Surgery in this population requires a multidisciplinary approach, careful planning, dedicated surgical procedures, and specialized after care.</p> <p>Methods</p> <p>The guideline is based on scientific evidence and expert opinions. A multidisciplinary working group representing experts from all relevant specialties performed the research. A literature search was conducted to collect scientific evidence in answer to specific questions posed by the working group. Literature was classified according to the level of evidence.</p> <p>Results</p> <p>For most aspects of the treatment scientific evidence is scarce and only low level cohort studies were found. Nevertheless, a high degree of consensus was reached about the management of patients with scoliosis in neuromuscular disorders. This was translated into a set of recommendations, which are now officially accepted as a general guideline in the Netherlands.</p> <p>Conclusion</p> <p>In order to optimize the treatment for scoliosis in neuromuscular disorders a Dutch guideline has been composed. This evidence-based, multidisciplinary guideline addresses conservative treatment, the preoperative, perioperative, and postoperative care of scoliosis in neuromuscular disorders.</p

Rescuing Loading Induced Bone Formation at Senescence

The increasing incidence of osteoporosis worldwide requires anabolic treatments that are safe, effective, and, critically, inexpensive given the prevailing overburdened health care systems. While vigorous skeletal loading is anabolic and holds promise, deficits in mechanotransduction accrued with age markedly diminish the efficacy of readily complied, exercise-based strategies to combat osteoporosis in the elderly. Our approach to explore and counteract these age-related deficits was guided by cellular signaling patterns across hierarchical scales and by the insight that cell responses initiated during transient, rare events hold potential to exert high-fidelity control over temporally and spatially distant tissue adaptation. Here, we present an agent-based model of real-time Ca2+/NFAT signaling amongst bone cells that fully described periosteal bone formation induced by a wide variety of loading stimuli in young and aged animals. The model predicted age-related pathway alterations underlying the diminished bone formation at senescence, and hence identified critical deficits that were promising targets for therapy. Based upon model predictions, we implemented an in vivo intervention and show for the first time that supplementing mechanical stimuli with low-dose Cyclosporin A can completely rescue loading induced bone formation in the senescent skeleton. These pre-clinical data provide the rationale to consider this approved pharmaceutical alongside mild physical exercise as an inexpensive, yet potent therapy to augment bone mass in the elderly. Our analyses suggested that real-time cellular signaling strongly influences downstream bone adaptation to mechanical stimuli, and quantification of these otherwise inaccessible, transient events in silico yielded a novel intervention with clinical potential

Inverse remodelling algorithm identifies habitual manual activities of primates based on metacarpal bone architecture

Previously, a micro-finite element (micro-FE)-based inverse remodelling method was presented in the literature that reconstructs the loading history of a bone based on its architecture alone. Despite promising preliminary results, it remains unclear whether this method is sensitive enough to detect differences of bone loading related to pathologies or habitual activities. The goal of this study was to test the sensitivity of the inverse remodelling method by predicting joint loading histories of metacarpal bones of species with similar anatomy but clearly distinct habitual hand use. Three groups of habitual hand use were defined using the most representative primate species: manipulation (human), suspensory locomotion (orangutan), and knuckle-walking locomotion (bonobo, chimpanzee, gorilla). Nine to ten micro-computed tomography scans of each species ( n=48 in total) were used to create micro-FE models of the metacarpal head region. The most probable joint loading history was predicted by optimally scaling six load cases representing joint postures ranging from −75∘ (extension) to +75∘ (flexion). Predicted mean joint load directions were significantly different between knuckle-walking and non-knuckle-walking groups ( p<0.05 ) and in line with expected primary hand postures. Mean joint load magnitudes tended to be larger in species using their hands for locomotion compared to species using them for manipulation. In conclusion, this study shows that the micro-FE-based inverse remodelling method is sensitive enough to detect differences of joint loading related to habitual manual activities of primates and might, therefore, be useful for palaeoanthropologists to reconstruct the behaviour of extinct species and for biomedical applications such as detecting pathological joint loading

Proposal for the regulatory mechanism of Wolff's law

It is currently believed that the trabecular structure in bone is the result of a dynamic remodeling process controlled by mechanical loads. We propose a regulatory mechanism based on the hypothesis that osteocytes located within the bone sense mechanical signals and that these cells mediate osteoclasts and osteoblasts in their vicinity to adapt bone mass. A computer-simulation model based on these assumptions was used to investigate if the adaptation of bone, in the sense of Wolff's law, and remodeling phenomena, as observed in reality, can be explained by such a local control process. The model produced structures resembling actual trabecular architectures. The architecture transformed after the external loads were changed, aligning the trabeculae with the actual principal stress orientation, in accordance with Wolff's trajectorial hypothesis. As in reality, the relative apparent density of the structure depended on the magnitude of the applied stresses. Osteocyte density influenced the remodeling rate, which also is consistent with experimental findings. Furthermore, the results indicated that the domain of influence of the osteocytes affects the refinement of the structure as represented by separation and thickness of the struts. We concluded that the trabecular adaptation to mechanical load, as described by Wolff, can be explained by a relatively simple regulatory model. The model is useful for investigating the effects of physiological parameters on the development, maintenance, and adaptation of bone. [Journal Article; In English; United States

A physiological approach to the simulation of bone remodeling as a self-organizational control process

Although the capacity of bone to adapt to functional mechanical requirements has been known for more than a century, it is still unclear how the bone adaptation processes are regulated. The authors hypothesize that osteocytes are sensitive to mechanical loading and control the regulation of bone mass in their environment. Recently, simulation models of such a process were developed, using the finite element method. It was discovered that these models produce discontinuous structures, not unlike trabecular bone. However, it was also found that severe discontinuities violate the continuum assumption underlying the finite element method and that the solutions were element mesh dependent. The authors have developed a simulation model (which is physiologically and mechanically more consistent) which maintains the self-organizational characteristics but does not produce these discontinuities. This was accomplished by separating the sensor density and range of action from the mesh. The results clearly show that predicted trabecular morphology, i.e. sizes and branching of struts, depend on the actual relationship between local load, sensor density and range of influence. The authors believe that the model is suitable to study the relationship between trabecular morphology and load and can also explain adaptation of morphology, in the sense of `Wolff's law