4,939 research outputs found
Thin Film Formation During Splashing of Viscous Liquids
After impact onto a smooth dry surface, a drop of viscous liquid initially
spreads in the form of a thick lamella. If the drop splashes, it first emits a
thin fluid sheet that can ultimately break up into droplets causing the splash.
Ambient gas is crucial for creating this thin sheet. The time for sheet
ejection, , depends on impact velocity, liquid viscosity, gas pressure
and molecular weight. A central air bubble is trapped below the drop at
pressures even below that necessary for this sheet formation. In addition, air
bubbles are entrained underneath the spreading lamella when the ejected sheet
is present. Air entrainment ceases at a lamella velocity that is independent of
drop impact velocity as well as ambient gas pressure.Comment: 8 pages, 11 figure
Strong Pinning Enhancement in MgB2 Using Very Small Dy2O3 Additions
0.5 to 5.0 wt.% Dy2O3 was in-situ reacted with Mg + B to form pinned MgB2.
While Tc remained largely unchanged, Jc was strongly enhanced. The best sample
(only 0.5 wt.% Dy2O3) had a Jc of 6.5 x 10^5 A/cm^2 at 6K, 1T and 3.5 x 10^5
A/cm^2 at 20K, 1T, around a factor of 4 higher compared to the pure sample, and
equivalent to hot-pressed or nano-Si added MgB2 at below 1T. Even distributions
of nano-scale precipitates of DyB4 and MgO were observed within the grains. The
room temperature resistivity decreased with Dy2O3 indicative of improved grain
connectivity.Comment: 13 pages, 4 figures and 1 tabl
Improved Current Densities in MgB2 By Liquid-Assisted Sintering
Polycrystalline MgB2 samples with GaN additions were prepared by reaction of
Mg, B, and GaN powders. The presence of Ga leads to a low melting eutectic
phase which allowed liquid phase sintering and produces plate-like grains. For
low-level GaN additions (5% at. % or less), the critical transition
temperature, Tc, remained unchanged and in 1T magnetic field, the critical
current density, Jc was enhanced by a factor of 2 and 10, for temperatures of
\~5K and 20K, respectively. The values obtained are approaching those of hot
isostatically pressed samples.Comment: 12 pages, 1 table, 4 figures, accepted in Applied Physics Letter
Creation of prompt and thin-sheet splashing by varying surface roughness or increasing air pressure
A liquid drop impacting a solid surface may splash by emitting a thin liquid
sheet that subsequently breaks apart or by promptly ejecting droplets from the
advancing liquid-solid contact line. Using high-speed imaging, we show that air
pressure and surface roughness influence both splash mechanisms. Roughness
increases prompt splashing at the advancing contact line but inhibits the
formation of the thin sheet. If the air pressure is lowered, droplet ejection
is suppressed not only during thin-sheet formation but for prompt splashing as
well. The threshold pressure depends on impact velocity, liquid viscosity and
surface roughness
Frequency-selective single photon detection using a double quantum dot
We use a double quantum dot as a frequency-tunable on-chip microwave detector
to investigate the radiation from electron shot-noise in a near-by quantum
point contact. The device is realized by monitoring the inelastic tunneling of
electrons between the quantum dots due to photon absorption. The frequency of
the absorbed radiation is set by the energy separation between the dots, which
is easily tuned with gate voltages. Using time-resolved charge detection
techniques, we can directly relate the detection of a tunneling electron to the
absorption of a single photon
Visualization and analysis of the structure of high Reynolds number hydrogen-air premixed flames
Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/77272/1/AIAA-1990-161-778.pd
Thin-Film Trilayer Manganate Junctions
Spin-dependent conductance across a manganate-barrier-manganate junction has
recently been demonstrated. The junction is a LaSrMnO%
-SrTiO-La SrMnO trilayer device supporting
current-perpendicular transport. Large magnetoresistance of up to a factor of
five change was observed in these junctions at 4.2K in a relatively low field
of the order of 100 Oe. Temperature and bias dependent studies revealed a
complex junction interface structure whose materials physics has yet to be
understood.Comment: 20 pages, 14 figures. To appear in Phil. Trans. R. Soc. Lond. A
vol.356 (1998
Isospectrality in Chaotic Billiards
We consider a modification of isospectral cavities whereby the classical
dynamics changes from pseudointegrable to chaotic. We construct an example
where we can prove that isospectrality is retained. We then demonstrate this
explicitly in microwave resonators.Comment: 5 pages, 7 figure
- …