Control of doped layers in p-i-n microcrystalline solar cells fully deposited with HWCVD

In this paper, the influence of the deposition conditions on the performance of p-i-n microcrystalline silicon solar cells completely deposited by hot-wire chemical vapor deposition is studied. With this aim, the role of the doping concentration, the substrate temperature of the p-type layer and of amorphous silicon buffer layers between the p/i and i/n microcrystalline layers is investigated. Best results are found when the p-type layer is deposited at a substrate temperature of 125 °C. The dependence seen of the cell performance on the thickness of the i layer evidenced that the efficiency of our devices is still limited by the recombination within this layer, which is probably due to the charge of donor centers most likely related to oxygen

Stick-Slip Motion and Phase Transition in a Block-Spring System

We study numerically stick slip motions in a model of blocks and springs being pulled slowly. The sliding friction is assumed to change dynamically with a state variable. The transition from steady sliding to stick-slip is subcritical in a single block and spring system. However, we find that the transition is continuous in a long chain of blocks and springs. The size distribution of stick-slip motions exhibits a power law at the critical point.Comment: 8 figure

Mechanisms for slow strengthening in granular materials

Several mechanisms cause a granular material to strengthen over time at low applied stress. The strength is determined from the maximum frictional force F_max experienced by a shearing plate in contact with wet or dry granular material after the layer has been at rest for a waiting time \tau. The layer strength increases roughly logarithmically with \tau -only- if a shear stress is applied during the waiting time. The mechanisms of strengthening are investigated by sensitive displacement measurements and by imaging of particle motion in the shear zone. Granular matter can strengthen due to a slow shift in the particle arrangement under shear stress. Humidity also leads to strengthening, but is found not to be its sole cause. In addition to these time dependent effects, the static friction coefficient can also be increased by compaction of the granular material under some circumstances, and by cycling of the applied shear stress.Comment: 21 pages, 11 figures, submitted to Phys. Rev.

Shearing behavior of polydisperse media

We study the shearing of polydisperse and bidisperse media with a size ratio of 10. Simulations are performed with a the two dimensional shear cell using contact dynamics. With a truncated power law for the polydisperse media we find that they show a stronger dilatancy and greater resistance to shearing than bidisperse mixtures. Motivated by the practical problem of reducing the energy needed to shear granular media, we introduce "point-like particles" representing charged particles in the distribution. Even though changing the kinematic behavior very little, they reduce the force necessary to maintain a fixed shearing velocity.Comment: 17 pages, 15 figure

Creep motion in a granular pile exhibiting steady surface flow

We investigate experimentally granular piles exhibiting steady surface flow. Below the surface flow, it has been believed exisitence of a `frozen' bulk region, but our results show absence of such a frozen bulk. We report here that even the particles in deep layers in the bulk exhibit very slow flow and that such motion can be detected at an arbitrary depth. The mean velocity of the creep motion decays exponentially with depth, and the characteristic decay length is approximately equal to the particle-size and independent of the flow rate. It is expected that the creep motion we have seeen is observable in all sheared granular systems.Comment: 3 pages, 4 figure

Aging in humid granular media

Aging behavior is an important effect in the friction properties of solid surfaces. In this paper we investigate the temporal evolution of the static properties of a granular medium by studying the aging over time of the maximum stability angle of submillimetric glass beads. We report the effect of several parameters on these aging properties, such as the wear on the beads, the stress during the resting period, and the humidity content of the atmosphere. Aging effects in an ethanol atmosphere are also studied. These experimental results are discussed at the end of the paper.Comment: 7 pages, 9 figure

Jamming and Fluctuations in Granular Drag

We investigate the dynamic evolution of jamming in granular media through fluctuations in the granular drag force. The successive collapse and formation of jammed states give a stick-slip nature to the fluctuations which is independent of the contact surface between the grains and the dragged object -- thus implying that the stress-induced collapse is nucleated in the bulk of the granular sample. We also find that while the fluctuations are periodic at small depths, they become "stepped" at large depths, a transition which we interpret as a consequence of the long-range nature of the force chains.Comment: 7 pages, 4 figures, RevTe

Time-Resolved Studies of Stick-Slip Friction in Sheared Granular Layers

Sensitive and fast force measurements are performed on sheared granular layers undergoing stick-slip motion, along with simultaneous imaging. A full study has been done for spherical particles with a +-20% size distribution. Stick-slip motion due to repetitive fluidization of the layer occurs for low driving velocities. Between major slip events, slight creep occurs that is variable from one event to the next. The effects of changing the stiffness k and velocity V of the driving system are studied in detail. The stick-slip motion is almost periodic for spherical particles over a wide range of parameters, but becomes irregular when k is large and V is relatively small. At larger V, the motion becomes smoother and is affected by the inertia of the upper plate bounding the layer. Measurements of the period T and amplitude A of the relative motion are presented as a function of V. At a critical value Vc, a transition to continuous sliding motion occurs that is discontinuous for k not too large. The time dependence of the instantaneous velocity of the upper plate and the frictional force produced by the granular layer are determined within individual slipping events. The force is a multi-valued function of the instantaneous velocity, with pronounced hysteresis and a sudden drop prior to resticking. Measurements of vertical displacement reveal a small dilation of the material (about one tenth of the mean particle size in a layer 20 particles deep) associated with each slip event. Finally, optical imaging reveals that localized microscopic rearrangements precede (and follow) each slip event. The behavior of smooth particles is contrasted with that of rough particles.Comment: 20, pages, 17 figures, to appear in Phys. Rev.

Optimal Spin Basis in Polarized Photon Linear Colliders

We analyze the spin correlations of the top quark pairs produced at Photon Linear Colliders. We employ the circular polarized photon beams and general spin basis for the top quark pair. We consider general spin bases to find a strong spin correlation between produced top quark and anti-top quark. We show the cross-section in these bases and discuss the characteristics of results.Comment: RevTeX, 16 pages, 6 figures, psfig.sty and here.sty are require

Particle dynamics in sheared granular matter

The particle dynamics and shear forces of granular matter in a Couette geometry are determined experimentally. The normalized tangential velocity $V(y)$ declines strongly with distance $y$ from the moving wall, independent of the shear rate and of the shear dynamics. Local RMS velocity fluctuations $\delta V(y)$ scale with the local velocity gradient to the power $0.4 \pm 0.05$. These results agree with a locally Newtonian, continuum model, where the granular medium is assumed to behave as a liquid with a local temperature $\delta V(y)^2$ and density dependent viscosity