Comparison of different measures for quantum discord under non-Markovian noise

Two geometric measures for quantum discord were recently proposed by Modi et al. [Phys. Rev. Lett. 104, 080501 (2010)] and Dakic et al. [Phys. Rev. Lett. 105, 190502 (2010)]. We study the similarities and differences for total quantum correlations of Bell-diagonal states using these two geometry-based quantum discord and the original quantum discord. We show that, under non-Markovian dephasing channels, quantum discord and one of the geometric measures stay constant for a finite amount of time, but not the other geometric measure. However, all the three measures share a common sudden change point. Our study on critical point of sudden transition might be useful for keeping long time total quantum correlations under decoherence.Comment: 10 pages, 3 figures submitted for publicatio

Performance of bolted steel-beam to CFST-column joints using stiffened angles in column-removal scenario

This paper presents three experimental investigations on the performance of steel-beam to CFST-column joints using stiffened angle, long bolts and fin plate under a middle column removal scenario. Three specimens were designed and tested. The failure modes and catenary action are investigated in detail. The test results show that increasing the angle plate thickness at the joint could not only improve its performance significantly, but also trigger an early formation of catenary action. Increasing the length of short-limb had influence on the deformation ability of the proposed joint, rather than the load capacity. The buckling of stiffeners could prevent the brittle failure of the joints. With the contribution of catenary action, the joint shows much higher rotation capacities than that required in DoD design guidance. The initial stiffness of the joint was calculated using an analytical model with consideration of bolt pretension. Good agreement to the test results is achieved. A numerical analysis is also carried out, whose results show that adding additional row of bolts would improve the redundancy of the joint under column loss. An equivalent dynamic response evaluation of the joints was also performed. The results show that dynamic amplification coefficient should be worked out considering catenary action under large deformation

Enhanced forward stimulated Brillouin scattering in silicon photonic slot waveguide Bragg grating

We study the forward stimulated Brillouin scattering process in a suspended silicon slot waveguide Bragg grating. Full-vectorial formalism is applied to analyze the interplay of electrostriction and radiation pressure. We show that radiation pressure is the dominant factor in the proposed waveguide. The Brillouin gain strongly depends on the structural parameters and the maximum value in the order of 106 W−1 m−1 is obtained in the slow light regime, which is more than two orders larger than that of the stand-alone strip and slot waveguides

The optical/UV excess of isolated neutron stars in the RCS model

The X-ray dim isolated neutron stars (XDINSs) are peculiar pulsar-like objects, characterized by their very well Planck-like spectrum. In studying their spectral energy distributions, the optical/UV excess is a long standing problem. Recently, Kaplan et al. (2011) have measured the optical/UV excess for all seven sources, which is understandable in the resonant cyclotron scattering (RCS) model previously addressed. The RCS model calculations show that the RCS process can account for the observed optical/UV excess for most sources . The flat spectrum of RX J2143.0+0654 may due to contribution from bremsstrahlung emission of the electron system in addition to the RCS process.Comment: 6 pages, 2 figures, 1 table, accepted for publication in Research in Astronomy and Astrophysic