231 research outputs found
Proposal of a new Hcal geometry avoiding cracks in the calorimeter
The classical geometry of a calorimeter consists most of the time in several modules, whose edges are pointing on the beam axis. Thus, detection discontinuities between two consecutive modules induce cracks in the calorimeter, and consequently a loss of precious information. This paper describes two new possible Hcal geometries avoiding such cracks in the detection. Then it deals with the internal layout and assembly procedure
The Heavy Photon Search beamline and its performance
The Heavy Photon Search (HPS) is an experiment to search for a hidden sector
photon, aka a heavy photon or dark photon, in fixed target electroproduction at
the Thomas Jefferson National Accelerator Facility (JLab). The HPS experiment
searches for the ee decay of the heavy photon with bump hunt and
detached vertex strategies using a compact, large acceptance forward
spectrometer, consisting of a silicon microstrip detector (SVT) for tracking
and vertexing, and a PbWO electromagnetic calorimeter for energy
measurement and fast triggering. To achieve large acceptance and good vertexing
resolution, the first layer of silicon detectors is placed just 10 cm
downstream of the target with the sensor edges only 500 m above and below
the beam. Placing the SVT in such close proximity to the beam puts stringent
requirements on the beam profile and beam position stability. As part of an
approved engineering run, HPS took data in 2015 and 2016 at 1.05 GeV and 2.3
GeV beam energies, respectively. This paper describes the beam line and its
performance during that data taking
First Results from the TOTEM Experiment
The first physics results from the TOTEM experiment are here reported,
concerning the measurements of the total, differential elastic, elastic and
inelastic pp cross-section at the LHC energy of = 7 TeV, obtained
using the luminosity measurement from CMS. A preliminary measurement of the
forward charged particle distribution is also shown.Comment: Conference Proceeding. MPI@LHC 2010: 2nd International Workshop on
Multiple Partonic Interactions at the LHC. Glasgow (UK), 29th of November to
the 3rd of December 201
Elastic Scattering and Total Cross-Section in p+p reactions measured by the LHC Experiment TOTEM at sqrt(s) = 7 TeV
Proton-proton elastic scattering has been measured by the TOTEM experiment at
the CERN Large Hadron Collider at TeV in special runs with the
Roman Pot detectors placed as close to the outgoing beam as seven times the
transverse beam size. The differential cross-section measurements are reported
in the |t|-range of 0.36 to 2.5 GeV^2. Extending the range of data to low t
values from 0.02 to 0.33 GeV^2,and utilizing the luminosity measurements of
CMS, the total proton-proton cross section at sqrt(s) = 7 TeV is measured to be
(98.3 +- 0.2(stat) +- 2.8(syst)) mb.Comment: Proceedings of the XLI International Symposium on Multiparticle
Dynamics. Accepted for publication in Prog. Theor. Phy
Performance of the TOTEM Detectors at the LHC
The TOTEM Experiment is designed to measure the total proton-proton
cross-section with the luminosity-independent method and to study elastic and
diffractive pp scattering at the LHC. To achieve optimum forward coverage for
charged particles emitted by the pp collisions in the interaction point IP5,
two tracking telescopes, T1 and T2, are installed on each side of the IP in the
pseudorapidity region 3.1 < = |eta | < = 6.5, and special movable beam-pipe
insertions - called Roman Pots (RP) - are placed at distances of +- 147 m and
+- 220 m from IP5. This article describes in detail the working of the TOTEM
detector to produce physics results in the first three years of operation and
data taking at the LHC.Comment: 40 pages, 31 figures, submitted to Int. J. Mod. Phys.
LHC Optics Measurement with Proton Tracks Detected by the Roman Pots of the TOTEM Experiment
Precise knowledge of the beam optics at the LHC is crucial to fulfil the
physics goals of the TOTEM experiment, where the kinematics of the scattered
protons is reconstructed with the near-beam telescopes -- so-called Roman Pots
(RP). Before being detected, the protons' trajectories are influenced by the
magnetic fields of the accelerator lattice. Thus precise understanding of the
proton transport is of key importance for the experiment. A novel method of
optics evaluation is proposed which exploits kinematical distributions of
elastically scattered protons observed in the RPs. Theoretical predictions, as
well as Monte Carlo studies, show that the residual uncertainty of this optics
estimation method is smaller than 0.25 percent.Comment: 20 pages, 11 figures, 5 figures, to be submitted to New J. Phy
Double diffractive cross-section measurement in the forward region at LHC
The first double diffractive cross-section measurement in the very forward
region has been carried out by the TOTEM experiment at the LHC with
center-of-mass energy of sqrt(s)=7 TeV. By utilizing the very forward TOTEM
tracking detectors T1 and T2, which extend up to |eta|=6.5, a clean sample of
double diffractive pp events was extracted. From these events, we measured the
cross-section sigma_DD =(116 +- 25) mub for events where both diffractive
systems have 4.7 <|eta|_min < 6.5 .Comment: 5 pages, 1 figure, submitted for publicatio
Proton-proton elastic scattering at the LHC energy of {\surd} = 7 TeV
Proton-proton elastic scattering has been measured by the TOTEM experiment at
the CERN Large Hadron Collider at {\surd}s = 7 TeV in dedicated runs with the
Roman Pot detectors placed as close as seven times the transverse beam size
(sbeam) from the outgoing beams. After careful study of the accelerator optics
and the detector alignment, |t|, the square of four-momentum transferred in the
elastic scattering process, has been determined with an uncertainty of d t =
0.1GeV p|t|. In this letter, first results of the differential cross section
are presented covering a |t|-range from 0.36 to 2.5GeV2. The differential
cross-section in the range 0.36 < |t| < 0.47 GeV2 is described by an
exponential with a slope parameter B = (23.6{\pm}0.5stat {\pm}0.4syst)GeV-2,
followed by a significant diffractive minimum at |t| =
(0.53{\pm}0.01stat{\pm}0.01syst)GeV2. For |t|-values larger than ~ 1.5GeV2, the
cross-section exhibits a power law behaviour with an exponent of -7.8_\pm}
0.3stat{\pm}0.1syst. When compared to predictions based on the different
available models, the data show a strong discriminative power despite the small
t-range covered.Comment: 12pages, 5 figures, CERN preprin
The UA9 experimental layout
The UA9 experimental equipment was installed in the CERN-SPS in March '09
with the aim of investigating crystal assisted collimation in coasting mode.
Its basic layout comprises silicon bent crystals acting as primary
collimators mounted inside two vacuum vessels. A movable 60 cm long block of
tungsten located downstream at about 90 degrees phase advance intercepts the
deflected beam.
Scintillators, Gas Electron Multiplier chambers and other beam loss monitors
measure nuclear loss rates induced by the interaction of the beam halo in the
crystal. Roman pots are installed in the path of the deflected particles and
are equipped with a Medipix detector to reconstruct the transverse distribution
of the impinging beam. Finally UA9 takes advantage of an LHC-collimator
prototype installed close to the Roman pot to help in setting the beam
conditions and to analyze the efficiency to deflect the beam. This paper
describes in details the hardware installed to study the crystal collimation
during 2010.Comment: 15pages, 11 figure, submitted to JINS
- …