Study of filtration mechanics and sampling techniques Annual technical summary report, phase 4, 1967-1968

Filtration mechanics and fluid contamination control in hydraulic system

Study of filtration mechanics and sampling techniques, phase 4 Annual report, 1967-1968

Filtration mechanics and fluid contaminatio

Post-operative cranial pressure monitoring system

System for monitoring of fluidic pressures in cranial cavity uses a miniaturized pressure sensing transducer, combined with suitable amplification means, a meter with scale calibrated in terms of pressures between minus 100 and plus 900 millimeters of water, and a miniaturized chart recorder covering similar range of pressures

Pressure Contact Sounding Data for NASA's Atmospheric Variability Experiment (AVE 3)

The basic rawinsonde data are described at each pressure contact from the surface to sounding termination for the 41 stations participating in the AVE III measurement program that began at 0000 GMT on February 6 and ended at 1200 GMT on February 7, 1975. Soundings were taken at 3-hour intervals during a large period of the experiment from most stations within the United States east of about 105 degrees west longitude. Methods of data processing, change in reduction scheme since the AVE II pilot experiment, and data accuracy are briefly discussed. An example of contact data is presented, and microfiche cards of all the contact data are included in the appendix. The AVE III project was conducted to better understand and establish the extent of applications for meteorological satellite sensor data through correlative ground truth experiments and to provide basic experimental data for use in studies of atmospheric scales of-motion interrelationships

A single-photon sampling architecture for solid-state imaging

Advances in solid-state technology have enabled the development of silicon photomultiplier sensor arrays capable of sensing individual photons. Combined with high-frequency time-to-digital converters (TDCs), this technology opens up the prospect of sensors capable of recording with high accuracy both the time and location of each detected photon. Such a capability could lead to significant improvements in imaging accuracy, especially for applications operating with low photon fluxes such as LiDAR and positron emission tomography. The demands placed on on-chip readout circuitry imposes stringent trade-offs between fill factor and spatio-temporal resolution, causing many contemporary designs to severely underutilize the technology's full potential. Concentrating on the low photon flux setting, this paper leverages results from group testing and proposes an architecture for a highly efficient readout of pixels using only a small number of TDCs, thereby also reducing both cost and power consumption. The design relies on a multiplexing technique based on binary interconnection matrices. We provide optimized instances of these matrices for various sensor parameters and give explicit upper and lower bounds on the number of TDCs required to uniquely decode a given maximum number of simultaneous photon arrivals. To illustrate the strength of the proposed architecture, we note a typical digitization result of a 120x120 photodiode sensor on a 30um x 30um pitch with a 40ps time resolution and an estimated fill factor of approximately 70%, using only 161 TDCs. The design guarantees registration and unique recovery of up to 4 simultaneous photon arrivals using a fast decoding algorithm. In a series of realistic simulations of scintillation events in clinical positron emission tomography the design was able to recover the spatio-temporal location of 98.6% of all photons that caused pixel firings.Comment: 24 pages, 3 figures, 5 table

A Serological Study of Eight Nigerian Group Simbu Arbovirus Isolates

n/