2,627 research outputs found
A review towards finding a simplified approach for modelling the kinetics of the soluble microbial products (SMP) in an integrated mathematical model of membrane bioreactor (MBR)
Soluble microbial products (SMPs) tend to accumulate in the membrane bioreactor (MBR) systems as a consequence of high membrane rejection and apparently low biodegradability within the wastewater treatment system. The extension of the activated sludge models (ASMs) with SMPs, therefore, has received crucial importance in recent days, particularly considering their potential use as indicators of the membrane fouling propensity. This paper presents a critical review of the formation and degradation kinetics of SMP subdivisions that have so far been used for the mathematical modelling of MBR. The paper identified a simplified approach to incorporate the kinetics of the SMP formation and degradation in the general mathematical models of MBR. It suggested that the inclusion of only four additional linear differential equations in the ASM1-SMP integrated mathematical model could simulate well the effluent quality and membrane fouling prediction. The model would also serve as a useful tool in optimizing operation conditions for better treatability and fouling control. © 2013 Elsevier Ltd
Involvement of macrophage migration inhibitory factor (MIF) in graft-versus-host disease (GvHD)
published_or_final_versio
Feasibility of iron loaded 'okara' for biosorption of phosphorous in aqueous solutions
This study investigated the feasibility of using soybean milk by-products (okara) as a sustainable biosorbent for phosphate removal in water and wastewater. The results show that raw okara could hardly decontaminate phosphate from aqueous solutions. Hence, in this work, okara was modified by being cationized using FeCl3 0.25M (namely iron loaded okara, ILO) to enhance the phosphorus adsorption capacity. The phosphate sorption onto ILO was well achieved under the conditions of pH 3, initial phosphorous concentration of 25mg/L, biosorbent dose of 20mg/L and contact time of 7h. Based on Langmuir model, the maximum adsorption capacity of phosphate by ILO was 4.785mg/g. The effects of interfering anions were in the order of CO32->SO42->NO3 It was also observed that Fe(III) was detached during operation. This problem can hinder the sustainable usability of ILO. Thus, further research would be necessary for improving the modification method. © 2013 Elsevier Ltd
Phosphorus elimination from aqueous solution using 'zirconium loaded okara' as a biosorbent
This work deals with the capture of phosphorus from aqueous solutions by biosorption onto zirconium loaded okara (ZLO). The batch-mode experiments were conducted to examine the effect of pH, biosorbent dose, initial phosphorus concentration, contact time, and temperature on the process. It was found that, the adsorption was most favored in the pH range of 2-6. The optimal doses for the adsorption, at initial phosphorus concentrations of 5, 10, 25, 50mg/L were 2, 3, 7, 10g/L, respectively. The maximum adsorption capacity of ZLO was approximately 44.13mg PO4/g at 298K. The phosphate removal was rapid, reaching 95% in 30min. Freundlich model best fitted the equilibrium data, while Pseudo-second order model satisfactorily described the kinetic results. Thermodynamic analysis revealed feasible, spontaneous, and endothermic nature of the process. The research would be beneficial for developing a promising, eco-friendly phosphorus biosorbent from a plentiful AWB - okara. © 2014 Elsevier Ltd
A comparative study on different metal loaded soybean milk by-product 'okara' for biosorption of phosphorus from aqueous solution
Cationization of agricultural by-products using metal salts is widely used to activate their phosphorous capture ability. This study developed three kinds of new metal loaded soybean milk by-product 'okara' for phosphorus biosorption. A comparative study among these biosorbents was carried out with respect to their performances in terms of affinity, stability and reusability. Zirconium loaded okara (ZLO) was found to have the highest affinity towards PO43- anions (47.88mg/g), followed by iron/zirconium loaded okara - IZLO (40.96mg/g) and iron loaded okara - ILO (16.39mg/g). ZLO was successfully desorbed with 0.2M NaOH and activated with 0.1 HCl prior to the next cycle. After five consecutive cycles, the efficiency of both adsorption and desorption of ZLO remained about 85% whilst no Zr(IV) leakage was observed. Conversely, IZLO and ILO suffered from vital short comings such as high metal release and/or sharp reduction in PO43- sequestering capability after multi operation cycles. © 2014 Elsevier Ltd
Effects of C/N ratio on the performance of a hybrid sponge-assisted aerobic moving bed-anaerobic granular membrane bioreactor for municipal wastewater treatment
© 2017 Elsevier Ltd This study aimed to evaluate the impact of C/N ratio on the performance of a hybrid sponge-assisted aerobic moving bed-anaerobic granular membrane bioreactor (SAAMB-AnGMBR) in municipal wastewater treatment. The results showed that organic removal efficiencies were above 94% at all C/N conditions. Nutrient removal was over 91% at C/N ratio of 100/5 but was negatively affected when decreasing C/N ratio to 100/10. At lower C/N ratio (100/10), more noticeable membrane fouling was caused by aggravated cake formation and pore clogging, and accumulation of extracellular polymeric substances (EPS) in the mixed liquor and sludge cake as a result of deteriorated granular quality. Foulant analysis suggested significant difference existed in the foulant organic compositions under different C/N ratios, and humic substances were dominant when the fastest fouling rate was observed. The performance of the hybrid system was found to recover when gradually increasing C/N ratio from 100/10 to 100/5
Comparing the value of bioproducts from different stages of anaerobic membrane bioreactors
© 2016 Elsevier Ltd The anaerobic digestion process in anaerobic membrane bioreactors is an effective way for waste management, energy sustainability and pollution control in the environment. This digestion process basically involves the production of volatile fatty acids and biohydrogen as intermediate products and methane as a final product. This paper compares the value of bioproducts from different stages of anaerobic membrane bioreactors through a thorough assessment. The value was assessed in terms of technical feasibility, economic assessment, environmental impact and impact on society. Even though the current research objective is more inclined to optimize the production of methane, the intermediate products could also be considered as economically attractive and environment friendly options. Hence, this is the first review study to correlate the idea into an anaerobic membrane bioreactor which is expected to guide future research pathways regarding anaerobic process and its bioproducts
Measuring luteinising hormone pulsatility with a robotic aptamer-enabled electrochemical reader
Normal reproductive functioning is critically dependent on pulsatile secretion of luteinising hormone (LH). Assessment of LH pulsatility is important for the clinical diagnosis of reproductive disorders, but current methods are hampered by frequent blood sampling coupled to expensive serial immunochemical analysis. Here, we report the development and application of a Robotic APTamer-enabled Electrochemical Reader (RAPTER) electrochemical analysis system to determine LH pulsatility. Through selective evolution of ligands by exponential enrichment (SELEX), we identify DNA aptamers that bind specifically to LH and not to related hormones. The aptamers are integrated into electrochemical aptamer-based (E-AB) sensors on a robotic platform. E-AB enables rapid, sensitive and repeatable determination of LH concentration profiles. Bayesian Spectrum Analysis is applied to determine LH pulsatility in three distinct patient cohorts. This technology has the potential to transform the clinical care of patients with reproductive disorders and could be developed to allow real-time in vivo hormone monitoring
Dzyaloshinskii-Moriya Interaction and Spiral Order in Spin-orbit Coupled Optical Lattices
We show that the recent experimental realization of spin-orbit coupling in
ultracold atomic gases can be used to study different types of spin spiral
order and resulting multiferroic effects. Spin-orbit coupling in optical
lattices can give rise to the Dzyaloshinskii-Moriya (DM) spin interaction which
is essential for spin spiral order. By taking into account spin-orbit coupling
and an external Zeeman field, we derive an effective spin model in the Mott
insulator regime at half filling and demonstrate that the DM interaction in
optical lattices can be made extremely strong with realistic experimental
parameters. The rich finite temperature phase diagrams of the effective spin
models for fermions and bosons are obtained via classical Monte Carlo
simulations.Comment: 7 pages, 5 figure
Epigenetic Differences in Cortical Neurons from a Pair of Monozygotic Twins Discordant for Alzheimer's Disease
DNA methylation [1], [2] is capable of modulating coordinate expression of large numbers of genes across many different pathways, and may therefore warrant investigation for their potential role between genes and disease phenotype. In a rare set of monozygotic twins discordant for Alzheimer's disease (AD), significantly reduced levels of DNA methylation were observed in temporal neocortex neuronal nuclei of the AD twin. These findings are consistent with the hypothesis that epigenetic mechanisms may mediate at the molecular level the effects of life events on AD risk, and provide, for the first time, a potential explanation for AD discordance despite genetic similarities
- …