6 research outputs found
Possibilities of the use of CeBr3 scintillation detectors for the measurement of the content of radionuclides in samples for environmental monitoring
The investigation of radioactivity in samples is an application of gamma-ray spectrometry dealing with low and very low level gamma-ray activities of different isotopes. Gamma-ray spectrometry performed in the framework of radiological environmental monitoring may be done after selective sampling processes or after a chemical purification of a sample. Both cases imply that only some specific radionuclides should contribute to the obtained spectrum. Gamma-ray spectrometry performed with medium energy resolution detectors may allow the possible distinction of their photopeaks. Therefore, a cerium bromide (CeBr3) detector can be particularly attractive for routine tasks in radiological environmental monitoring as it has a high efficiency, medium energy resolution and it can work at room temperature. This study describes the conditions under which a CeBr3 detector can serve for some routine analysis in radiological analysis of samples collected in the environment or collected by airsamplers in environmental radiological monitoring programmes
Quantification of the influence of the C, Cr and P contents on the permeability of hydrogen through Fe alloys
[EN] Ferritic-martensitic steels are candidate materials for blanket structural components of future thermonuclear fusion reactors. However, the tritium inventory that can be retained in different components of the reactor and its ability to migrate through the walls of any material may affect the correct operation of any fusion device. Therefore, the permeability of hydrogen isotopes through ferritic-martensitic steels, which depends on its metallurgical composition, becomes a key issue.
The European Fusion Development Agreement (EFDA) supplied 9 Fe alloys with controlled chemical alloying element contents and microstructure. The main alloying elements were C, Cr and P and they appeared in various concentrations in the 9 alloys. They were experimentally analyzed by means of the gas evolution permeation technique with temperatures ranging from 423 K to 823 K and for high purity hydrogen loading pressures ranging from 5.0 x 102 Pa to 1.5 x 105 Pa. The transport regime turned out to be diffusive and it was studied in depth, so that the permeability of each alloy was characterized by an Arrhenius-type regression for the aforementioned temperature range.
This work summarizes all the experimental measurements carried out for the permeability of hydrogen through the 9 alloys. It provides a quantification of the influence of the composition of the alloy on this transport parameter, posing different mathematical expressions for the variation of the permeability as a function of the contents of C, Cr and P.This work has been carried out in the framework of research projects funded by the Spanish Ministry of Science and Innovation (MEC08/98) , the University of the Basque Country (UPV/EHU-EHU08-34) and the European Fusion Development Agreement (EFDA MAT-REMEV) . The authors would also like to thank the FEMaS Coordinated Action project for the support in knowledge exchange among different research groups and Pilar Fernandez from CIEMAT for the preparation of the tested samples
Estudio de la radiactividad de los electrodos toriados por espectrometría gamma y alfa. Dosimetría en los procesos de soldadura TIG (Tungsten Inert Gas)
Este trabajo se enmarca dentro del estudio sobre la utilización, por parte de la industria no nuclear de materiales que contienen isótopos naturales radiactivos, Naturally Occurring adioactive Materials (NORM). En concreto se analiza el riesgo asociado a la utilización del torio en industrias no nucleares y centrando el estudio en los electrodos de soldadura y en procesos TIG (Tungsten Inert Gas), que es en estos momentos la aplicación más extendida en cuanto a usos del torio en nuestro país.Uno de los objetivos es el estudio de l torio en los electrodos de soldadura. La determinación de la radiactividad en los electrodos toriados se realizó mediante espectrometría gamma y alfa. Un segundo objetivo fue el estudio del campo de ardiación y la contaminación que se puede producir en el usuario de la soldadura TIG. As¿¿imismo se ha realizado la estimación dosimétrica durante los procesos de soldadura y afilado de estos electrodos toriados.Por último se realiza el estudio de la radiactividad mediante espectrometría gamma de las materias primas utilizadas para la elaboración del recubrimiento de los electrodos revestidos para la soldadura.<br /
Five Years (2014–2018) of Beta Activity Concentration and the Impact of Synoptic and Local Meteorological Conditions in Bilbao (Northern Spain)
The aim of this paper is to statistically characterize gross beta activity concentrations in ground-level air in Bilbao (northern Spain) by analysing five years (2014–2018) worth of weekly measurements in aerosols collected in filters to analyse the impact of local meteorological parameters on concentrations. In addition, synoptic meteorological scenarios associated with anomalous beta surface activity concentrations were identified. Over this five-year period, beta activity concentrations ranged from 35.45 µBq/m3 to 1778 µBq/m3 with a mean of 520.12 ± 281.77 µBq/m3. A positive correlation was found with the alpha concentrations (0.67), with an average of 0.138 for the alpha/beta ratio, and a low correlation was found with 7Be (0.16). Statistical analysis identified a seasonal component in the time series, increasing, on average, beta activity concentrations from winter to autumn. The highest beta activity concentrations were measured under the arrival of southerly land winds with low wind speeds, while the wind analysis (surface winds and air masses) of two different seasonal periods (autumn 2015 and winter 2017) have highlighted how small variations in synoptic and local winds highly influence beta activity concentrations. These results are relevant to understand the meteorological factors affecting beta activity concentrations in this area and hence to define meteorological scenarios that are in favour to high/anomalous surface activity concentrations that are harmful to the environmental and public health
Meteorological Factors Controlling 7Be Activity Concentrations in the Atmospheric Surface Layer in Northern Spain
This work presents the analysis of weekly 7Be activity concentrations in the air measured in Bilbao (northern Spain) by collecting aerosols in filters over a ten years period (2009–2018). 7Be level is in the 0.35–7.3 mBq/m3 range, with a mean of 3.20 ± 1.12 mBq/m3. The trend, cycle, seasonal and monthly variability are evaluated using time series analysis techniques. The results indicate the impact of sunspots (24th solar cycle) on interannual 7Be activity concentrations, and a significant seasonal and monthly variation, with maximum concentrations occurring in spring-summer and minimum in the winter. The correlation of different 7Be ranges with local meteorological parameters, such as precipitation, temperature, relative humidity, and pressure, is also addressed, with precipitation having the greatest impact on 7Be activity values. The analysis of synoptic airflows, by calculating the back-trajectory clusters, and local winds at surface level reveals the important influence of the arrival of slow northwest Atlantic flows and the development of breezes on reaching high 7Be activity concentrations in this area
Radiological characterisation in view of nuclear reactor decommissioning: On-site benchmarking exercise of a biological shield
[EN] Nearly all decommissioning and dismantling (D&D) projects are steered by the characterisation of the plant being dismantled. This radiological characterisation is a complex process that is updated and modified during the course of the D&D. One of the tools for carrying out this characterisation is the performance of in-situ measurements.
There is a wide variety of equipment and methodologies used to carry out on-site measurements, depending on the environment in which they are to be carried out and also on the specific objectives of the measurements and the financial and personnel resources available. The extent to which measurements carried out with different types of equipment or methodologies providing comparable results can be crucial in view of the D&D strategy development and the decision-making process. This paper concerns an on-site benchmarking exercise carried out at the activated biological shield of Belgian Reactor 3 (BR3). This activity allows comparison and validation of characterisation methodologies and different equipment used as well as future interpretation of final results in terms of uncertainties and sensitivities.
This paper describes the measurements and results from the analysis of this exercise. Other aspects of this exercise will be reported in separate papers. This paper provides an overview of the on-site benchmarking exercise, outlines the participating organisations and the measurement equipment used for total gamma, dose rate and gamma spectrometry measurements and finally, results obtained and their interpretations are discussed for each type of measurement as a function of detector type.
Regarding the dose measurements, results obtained by using a large variety of equipment are very consistent. In view of mapping the inner surface of the biological shield the most appropriate equipment tested might be the organic scintillator, the BGO or even the ionisation chamber. In addition, for mapping this surface, the most appropriate total gamma equipment tested might be the LaBr3(Ce), the thick organic scintillator or the BGO. These measurements can only be used as a secondary parameter in a relative way. Results for the gamma spectrometry are very consistent for all the equipment used and the main parameters to be determined.INSIDER is a EU Horizon 2020 project and received funding from the Euratom Research and Training Programme 2014–2018 under grant agreement No 755554