Long distance fiber Bragg grating strain sensor interrogation using a high speed Raman-based Fourier domain mode-locked fiber laser with recycled residual Raman pump

We propose a novel fiber Bragg grating (FBG) sensor interrogation using a Raman-based Fourier-domain mode locking (FDML) fiber laser for a high speed and long distance measurement. A residual Raman pump after the generation of the Raman-based FDML fiber laser is recycled for secondary signal amplification in a 2-m erbium-doped fiber (EDF) to further enhance the output power. The chromatic dispersion is precisely controlled to suppress the phase noise in the FDML laser cavity, resulting in the improvement of an R-number of 1.43 mm/dB. After recycling residual pump, we achieve the 40-km round trip transmission of the sensing probe signal with a high scan rate of 30.8 kHz. With 205-mW residual pump power, the bandwidth and the maximum gain are measured to be more than 50 nm, 10.3 dB at 1550 nm, respectively. The sensitivity of the proposed Raman-based FDML fiber laser to strain is also measured, which are 0.81 pm/μstrain in the spectral domain and 0.19 ns/μstrain in the time domain, respectively

Electronic structures of hexagonal RMnO3 (R = Gd, Tb, Dy, and Ho) thin films

We investigated the electronic structure of multiferroic hexagonal RMnO3 (R = Gd, Tb, Dy, and Ho) thin films using both optical spectroscopy and first-principles calculations. Using artificially stabilized hexagonal RMnO3, we extended the optical spectroscopic studies on the hexagonal multiferroic manganite system. We observed two optical transitions located near 1.7 eV and 2.3 eV, in addition to the predominant absorption above 5 eV. With the help of first-principles calculations, we attribute the low-lying optical absorption peaks to inter-site transitions from the oxygen states hybridized strongly with different Mn orbital symmetries to the Mn 3d3z2-r2 state. As the ionic radius of the rare earth ion increased, the lowest peak showed a systematic increase in its peak position. We explained this systematic change in terms of a flattening of the MnO5 triangular bipyramid

Tip-Enhanced Raman Scattering Imaging of Two-Dimensional Tungsten Disulfide with Optimized Tip Fabrication Process

We successfully achieve the tip-enhanced nano Raman scattering images of a tungsten disulfide monolayer with optimizing a fabrication method of gold nanotip by controlling the concentration of etchant in an electrochemical etching process. By applying a square-wave voltage supplied from an arbitrary waveform generator to a gold wire, which is immersed in a hydrochloric acid solution diluted with ethanol at various ratios, we find that both the conical angle and radius of curvature of the tip apex can be varied by changing the ratio of hydrochloric acid and ethanol. We also suggest a model to explain the origin of these variations in the tip shape. From the systematic study, we find an optimal condition for achieving the yield of similar to 60% with the radius of similar to 34 nm and the cone angle of similar to 35 degrees. Using representative tips fabricated under the optimal etching condition, we demonstrate the tip-enhanced Raman scattering experiment of tungsten disulfide monolayer grown by a chemical vapor deposition method with a spatial resolution of similar to 40 nm and a Raman enhancement factor of similar to 4,760. © The Author(s) 2017

Influence of Friction Stir Welding on Mechanical Properties of Butt Joints of AZ61 Magnesium Alloy

In this study, the effect of heat input on the mechanical properties and fracture behaviors of AZ61 magnesium alloy joints has been studied. Magnesium alloy AZ61 plates with thickness of 5 mm were welded at different ratios of tool rotational speed to welding speed (ω/ν). The average ultimate tensile strength of all weld conditions satisfying a ω/ν ratio of 3 reached 100% of the strength of the base material. Fractures occurred at the interface between the thermomechanical affected zone at advancing side and the stir zone in all welded specimens. From the scanning electron microscope and electron backscatter diffraction analysis, it was determined that the interface between the thermomechanical affected zone and the stir zone, which is the region where the grain orientation changes, was the weakest part; the advancing side region was relatively weaker than the retreating side region because the grain orientation change occurred more dramatically in the advancing side region

Visible-light absorptivity of a zincoxysulfide (ZnOxS1-x) composite semiconductor and its photocatalytic activities for degradation of organic pollutants under visible-light irradiation

This work reports the development of a visible-light sensible photocatalyst and the photocatalytic degradation of organic pollutants under visible-light irradiation. A composite semiconductor of ZnS and ZnO was prepared through co-precipitation process of Zn(NO3)2 in the mixed solution of aqueous Na2S and NaOH followed by calcination at 400 °C in N2 atmosphere. It was revealed that the composite semiconductor was a solid solution of ZnS and ZnO, a zincoxysulfide (ZnOxS1-x) having advanced visible-light absorptivity. It was assured that the visible-light absorptivity was caused by modification of band structure while the solid solution had been prepared, thus we suggested a reasonable band structure model involved in a zincoxysulfide. To observe its photocatalytic activity under visible-light illumination, photodegradation test was done and we confirmed that zincoxysulfide showed predominant photocatalytic activity due to its superior visible-light absorptivity to pure ZnS and ZnO. © 2007 Elsevier B.V. All rights reserved.1

Suppression of STAT3 and HIF-1 Alpha Mediates Anti-Angiogenic Activity of Betulinic Acid in Hypoxic PC-3 Prostate Cancer Cells

Background: Signal transducer and activator of transcription 3 (STAT3) is a transcription factor that regulates various cellular processes such as cell survival, angiogenesis and proliferation. In the present study, we examined that betulinic acid (BA), a triterpene from the bark of white birch, had the inhibitory effects on hypoxia-mediated activation of STAT3 in androgen independent human prostate cancer PC-3 cells. Methodology/Principal Findings: BA inhibited the protein expression and the transcriptional activities of hypoxia-inducible factor-1a (HIF-1a) under hypoxic condition. Consistently, BA blocked hypoxia-induced phosphorylation, DNA binding activity and nuclear accumulation of STAT3. In addition, BA significantly reduced cellular and secreted levels of vascular endothelial growth factor (VEGF), a critical angiogenic factor and a target gene of STAT3 induced under hypoxia. Furthermore, BA prevented in vitro capillary tube formation in human umbilical vein endothelial cells (HUVECs) maintained in conditioned medium of hypoxic PC-3 cells, implying anti-angiogenic activity of BA under hypoxic condition. Of note, chromatin immunoprecipitation (ChiP) assay revealed that BA inhibited binding of HIF-1a and STAT3 to VEGF promoter. Furthermore, silencing STAT3 using siRNA transfection effectively enhanced the reduced VEGF production induced by BA treatment under hypoxia. Conclusions/Significance: Taken together, our results suggest that BA has anti-angiogenic activity by disturbing th

Linear Magnetoelectric Phase in Ultrathin MnPS₃ Probed by Optical Second Harmonic Generation

The transition metal thiophosphates MPS₃ (M=Mn, Fe, Ni) are a class of van der Waals stacked insulating antiferromagnets that can be exfoliated down to the ultrathin limit. MnPS₃ is particularly interesting because its Néel ordered state breaks both spatial-inversion and time-reversal symmetries, allowing for a linear magnetoelectric phase that is rare among van der Waals materials. However, it is unknown whether this unique magnetic structure of bulk MnPS₃ remains stable in the ultrathin limit. Using optical second harmonic generation rotational anisotropy, we show that long-range linear magnetoelectric type Néel order in MnPS₃ persists down to at least 5.3 nm thickness. However an unusual mirror symmetry breaking develops in ultrathin samples on SiO₂ substrates that is absent in bulk materials, which is likely related to substrate induced strain