65,662 research outputs found

    Preformed stiffeners used to fabricate structural components for pressurized tanks

    Get PDF
    Process of fabricating stiffened section components of pressurized tanks for aerospace use was developed. A potential use of the fabrication process is the production of gore and quarter-panel sections of hydrogen and oxygen tanks for space vehicle boosters

    Piloted simulation of one-on-one helicopter air combat at NOE flight levels

    Get PDF
    A piloted simulation designed to examine the effects of terrain proximity and control system design on helicopter performance during one-on-one air combat maneuvering (ACM) is discussed. The NASA Ames vertical motion simulator (VMS) and the computer generated imagery (CGI) systems were modified to allow two aircraft to be independently piloted on a single CGI data base. Engagements were begun with the blue aircraft already in a tail-chase position behind the red, and also with the two aircraft originating from positions unknown to each other. Maneuvering was very aggressive and safety requirements for minimum altitude, separation, and maximum bank angles typical of flight test were not used. Results indicate that the presence of terrain features adds an order of complexiaty to the task performed over clear air ACM and that mix of attitude and rate command-type stability and control augmentation system (SCAS) design may be desirable. The simulation system design, the flight paths flown, and the tactics used were compared favorably by the evaluation pilots to actual flight test experiments

    Molar mass and solution conformation of branched alpha(1 - 4), alpha(1 - 6) Glucans. Part I: Glycogens in water

    Get PDF
    Solution molar masses and conformations of glycogens from different sources (rabbit, oyster, mussel and bovine) were analysed using sedimentation velocity in the analytical ultracentrifuge, size-exclusion chromatography coupled to multi-angle laser light scattering (SEC-MALLS), size-exclusion chromatography coupled to a differential pressure viscometer and dynamic light scattering. Rabbit, oyster and mussel glycogens consisted of one population of high molar mass (weight averages ranging from 4.6 x 106 to 1.1 x 107 g/mol) as demonstrated by sedimentation velocity and SEC-MALLS, whereas bovine glycogen had a bimodal distribution of significantly lower molar mass (1.0 x 105 and 4.5 x 105 g/mol). The spherical structure of all glycogen molecules was demonstrated in the slopes of the Mark-Houwink-Kuhn-Sakurada-type power-law relations for sedimentation coefficient (s20,wo), intrinsic viscosity ([η]), radius of gyration (rg,z) and radius of hydration (rH,z), respectively, and was further supported by the � (=rg,z/rH,z) function, the fractal dimension and the Perrin function. The degree of branching was estimated to be ∼10% from the shrinking factors, g′ (=[η]branched/[η]linear) and also h (=(f/fo)branched/(f/fo)linear), respectively, where (f/fo) is the translational frictional ratio, consistent with expectation. © 2007 Elsevier Ltd. All rights reserved

    Synthesis and Characterization of Mixed Methyl/Allyl Monolayers on Si(111)

    Get PDF
    The formation of mixed methyl/allyl monolayers has been accomplished through a two-step halogenation/alkylation reaction on Si(111) surfaces. The total coverage of alkylated Si, the surface recombination velocities, and the degree of surface oxidation as a function of time have been investigated using X-ray photoelectron spectroscopy, Fourier-transform infrared spectroscopy, and microwave conductivity measurements. The total coverage of alkyl groups, the rate of oxidation, and the surface recombination velocities of Si(111) terminated by mixed monolayers were found to be close to those observed for CH_3−Si(111) surfaces. Hence, the mixed-monolayer surfaces retained the beneficial properties of CH_3−Si(111) surfaces while allowing for convenient secondary surface functionalization

    The synergistic effects of slip ring-brush design and materials

    Get PDF
    Synergistic effects of slip ring-brush design and fabrication for vacuum application determined by friction, wear, electrical noise, and dielectric strength dat

    The synergistic effects of slip ring-brush design and materials

    Get PDF
    The design, fabrication, and subsequent testing of four power slip rings for synchronous orbit application are described. The synergistic effects of contact materials and slip ring-brush design are studied by means of frequent and simultaneous recording of friction, wear, and electrical noise. Data generated during the test period are presented along with post test analysis data

    Trade Restrictions and Trade Reversal: Lessons from the U.S.-Canada Herring Dispute

    Get PDF
    This paper analyzes international trade in value added products when free trade and perfect competition in the market for an intermediate product, such as raw fish, are the exception rather than the rule. Current evidence from the General Agreement on Tariffs and Trade (GATT) regarding disputes between countries, such as the V.S.-Canada dispute over trade in raw herring, suggests that bilateral trade in raw fish among major exporters of seafood products may not be completely free of structural and political barriers. The study presents models showing that restrictions on the exportation of raw fish from an exporting country can make possible monopsony behavior by fish processors in a rival exporting country and they outline the market behavior of the players under such circumstances. The analysis illustrates how, under such conditions, economic forces contribute to the creation of trade disputes. It further demonstrates how expansion of the demand for final product may, through trade reversal pressures, dilute the market power of the processor monopsony and make trade restriction policies irrelevant.roe herring, trade reversal, trade restrictions, monopsony, trade dispute, GATT, market imperfection, free trade, fishery management, comparative advantage reversal, Environmental Economics and Policy, International Relations/Trade,

    Normalizing connections and the energy-momentum method

    Get PDF
    The block diagonalization method for determining the stability of relative equilibria is discussed from the point of view of connections. We construct connections whose horizontal and vertical decompositions simultaneosly put the second variation of the augmented Hamiltonian and the symplectic structure into normal form. The cotangent bundle reduction theorem provides the setting in which the results are obtained
    corecore