Effect of pH on the growth of KDP

The acidity of KDP salt solution is one of the important parameters. This parameter determines a lot of properties of solution, crystallization processes in solution, properties of grown crystals. An alteration of the KDP salt solution acidity changes it`s properties such as KDP salt volubility, stability of the KDP solution, solution density, solution viscosity, solution heat capacity, etc. It also changes state of impurities in the solution and characteristics of interaction between growing faces of the crystal and solution impurities. As a result kinetics of crystallization changes, habit and physical properties of the grown crystal change too. It should be mentioned that investigations in were done for low rate processes of crystal growth. Here we report the results of our investigations which have been done for high rate crystal growth processes (R{sub Z} {approx} 20 mm/day)

Growth from Solutions: Kink dynamics, Stoichiometry, Face Kinetics and stability in turbulent flow

1. Kink dynamics. The first segment of a polygomized dislocation spiral step measured by AFM demonstrates up to 60% scattering in the critical length l*- the length when the segment starts to propagate. On orthorhombic lysozyme, this length is shorter than that the observed interkink distance. Step energy from the critical segment length based on the Gibbs-Thomson law (GTL), l* = 20(omega)alpha/(Delta)mu is several times larger than the energy from 2D nucleation rate. Here o is tine building block specific voiume, a is the step riser specific free energy, Delta(mu) is the crystallization driving force. These new data support our earlier assumption that the classical Frenkel, Burton -Cabrera-Frank concept of the abundant kink supply by fluctuations is not applicable for strongly polygonized steps. Step rate measurements on brushite confirms that statement. This is the1D nucleation of kinks that control step propagation. The GTL is valid only if l* <Dk/vk, the diffusion path of a kink that has diffusivity Dk and average growth velocity vk. This is equivalent to supersaturations sigma less than approx. alpha/2l*, where alpha is the building block size. For lysozyme, sigma much less than (1%). Conventionally used interstep distance generated by screw dislocation, 19(omega)alpha/Delta(mu) should be replaced by the very different real one, approx.4l*. 2. Stoichiometry. Kink, and thus step and face rates of a non-Kossel complex molecular monocomponent or any binary, AB, lattice was found theoretically to be proportional to 1/(zeta(sup 1/2) + zeta(sup - 1/2)), where zeta = [B]/[A] is the stoichiometry ratio in solution. The velocities reach maxima at zeta = 1. AFM studies of step rates on CaOxalate monohydrate (kidney stones) from aqueous solution was found to obey the law mentioned above. Generalization for more complex lattice will be discussed. 3. Turbulence. In agreement with theory, high precision in-situ laser interferometry of the (101) KDP crystal face shows step bunching if solution flows parallel to the step flow. The bunch height increases with the distance the bunch travels, i.e. with the face size. However, when the flow rate, u, increases, at u greater than approx. 1 m / s , the average step bunch height decreases as 1/u. The pheonomenon is attributed to the turbulent rather than laminar viscous boundary layer where diffusivity Dt = 0.5u(sub tau),y, i.e. increases linearly with the distance y from the solid face. Friction velocity, u(sub tau) approx. u(sup 7/8). Dramatically larger rate of the mass/heat transport within the turbulent, as compared to the laminar, viscous layer will be discussed

Fluctuations and Gibbs-Thomson Law - the Simple Physics.

Crystals of slightly soluble materials should be subject of relatively weak attachment/detachment fluctuations on their faces so that steps on that faces have low kink density. These steps are parallel to the most close packed lattice rows and form polygons on a crystal surface. The process responsible for implementation of the classical Gibbs-Thomson law (GTL) for the polygonal step (in two dimensions, 2D) is kink exchange between the step corners. For the 3D crystallites, this mechanism includes step exchange. If these mechanisms do not operate because of slow fluctuations the GTL is not applicable. Physics of these processes and conditions for the GTL applicability are discussed on a simple qualitative level