Dependence of the critical temperature of laser-ablated YBa2Cu3O(7-delta) thin films on LaAlO3 substrate growth technique

Samples of LaAlO3 made by flame fusion and Czochralski method were subjected to the same temperature conditions that they have to undergo during the laser ablation deposition of YBa2Cu3O(7 - delta) thin films. After oxygen annealing at 750 C, the LaAlO3 substrate made by two methods experienced surface roughening. The degree of roughening on the substrate made by Czochralski method was three times greater than that on the substrate made by flame fusion. This excessive surface roughening may be the origin of the experimentally observed lowering of the critical temperature of a film deposited by laser ablation on a LaAlO3 substrate made by Czochralski method with respect to its counterpart deposited on LaAlO3 substrates made by flame fusion

Properties of large area ErBa2Cu3O(7-x) thin films deposited by ionized cluster beams

ErBa2Cu3O(7-x) films have been produced by simultaneous deposition of Er, Ba, and Cu from three ionized cluster beam (ICB) sources at acceleration voltages of 0.3 to 0.5 kV. Combining ozone oxidation with ICB deposition at 650 C eliminated any need of post annealing processing. The substrates were rotated at 10 rotations per minute during the deposition which took place at a rate of about 3 to 4 nm. Films with areas up to 70 mm in diameter have been made by ICB deposition. These films, 100 nm thick, were deposited on SrTiO3 (100) substrates at 650 C in a mixture of six percent O3 in O2 at a total pressure of 4 x 10(exp -4) Torr. They had T(sub c) ranging from 84.3 K to 86.8 K over a 70 mm diameter and J(sub c) above 10(exp 6) A/sq cm at 77 K. X ray diffraction measurements of the three samples showed preferential c-axis orientation normal to the substrate surface. Scanning electron micrographs (SEM) of the three samples also show some texture dependence on sample position. For the three samples, there is a correlation between SEM texture, full width at half-maximum of rocking curves and J(sub c) versus temperature curves

Design of an optically controlled Ka-band GaAs MMIC phased-array antenna

Phased array antennas long were investigated to support the agile, multibeam radiating apertures with rapid reconfigurability needs of radar and communications. With the development of the Monolithic Microwave Integrated Circuit (MMIC), phased array antennas having the stated characteristics are becoming realizable. However, at K-band frequencies (20 to 40 GHz) and higher, the problem of controlling the MMICs using conventional techniques either severely limits the array size or becomes insurmountable due to the close spacing of the radiating elements necessary to achieve the desired antenna performance. Investigations were made that indicate using fiber optics as a transmission line for control information for the MMICs provides a potential solution. By adding an optical interface circuit to pre-existing MMIC designs, it is possible to take advantage of the small size, lightweight, mechanical flexibility and RFI/EMI resistant characteristics of fiber optics to distribute MMIC control signals. The architecture, circuit development, testing and integration of optically controlled K-band MMIC phased array antennas are described

Multislice/multidetector-row computed tomography findings of a rare coronary anomaly: the first septal perforator branch originating from the left main coronary artery

Multislice/multidetector-row computed tomography (MDCT) is now widely used for noninvasive assessment of coronary arteries, and it may sometimes reveal coronary anomalies. Detection of such anomalies may be relevant both during follow-up and for planning cardiac or coronary surgical/interventional procedures. These anomalies may be missed unless carefully sought. In this paper, we present the MDCT images of a first septal perforator branch originating from the left main coronary artery, which represents an extremely rare coronary anomaly. To the bestof our knowledge, this is the first case in the literature where MDCT images are presented

Association of change in body condition score with milk yield and reproduction traits of holstein cows

The aim of the study was to determine the effect of changes in body condition score (BSC) on milk yield and reproduction traits in early (30, 60 and 90 d), mid (120 and 150 d) and late lactation (210 and 270 d) in Holstein cows raised on a private dairy cattle farm in Kırşehir, Turkey. The data were obtained from 140 cows calved from November 2014 to November 2015. BSC groups were categorized as low, moderate and high in early lactation ([removed]3.00), mid-lactation ([removed]3.25) and late lactation ([removed]3.50). Cows with low and moderate BCS in early (BCS<2.75 and BCS=2.75-3.00), mid (BCS<3.00 and BCS=3.00–3.25) and late lactation (BCS[removed]3.50) had a higher daily milk yield (DMY), lactation milk yield (LMY) and 305-day milk yield (305-dMY) (P<0.05). Reproduction traits were also affected (P<0.05) by BCS in mid-lactation. In mid-lactation, the cows with low and moderate BCS had a shorter period of calving to the first service interval (CFSI) and lower number of services per conception (NSC) than that of the cows with high BCS (P<0.05). Both milk yield and reproduction traits were adversely affected by high BCS. It is suggested that BCS can be used as a reliable indicator in indirect selection programs for higher milk yield and reproductive performance in Holstein cows. © 2020, Pakistan Agricultural Scientists Forum. All rights reserved

Measurements of complex permittivity of microwave substrates in the 20 to 300 K temperature range from 26.5 to 40.0 GHz

A knowledge of the dielectric properties of microwave substrates at low temperatures is useful in the design of superconducting microwave circuits. Results are reported for a study of the complex permittivity of sapphire (Al2O3), magnesium oxide (MgO), silicon oxide (SiO2), lanthanum aluminate (LaAlO3), and zirconium oxide (ZrO2), in the 20 to 300 Kelvin temperature range, at frequencies from 26.5 to 40.0 GHz. The values of the real and imaginary parts of the complex permittivity were obtained from the scattering parameters, which were measured using a HP-8510 automatic network analyzer. For these measurements, the samples were mounted on the cold head of a helium gas closed cycle refrigerator, in a specially designed vacuum chamber. An arrangement of wave guides, with mica windows, was used to connect the cooling system to the network analyzer. A decrease in the value of the real part of the complex permittivity of these substrates, with decreasing temperature, was observed. For MgO and Al2O3, the decrease from room temperature to 20 K was of 7 and 15 percent, respectively. For LaAlO3, it decreased by 14 percent, for ZrO2 by 15 percent, and for SiO2 by 2 percent, in the above mentioned temperature range

Quantum Monte Carlo Study of Semiconductor Artificial Graphene Nanostructures

Semiconductor artificial graphene nanostructures where Hubbard model parameter $U/t$ can be of the order of 100, provide a highly controllable platform to study strongly correlated quantum many-particle phases. We use accurate variational and diffusion Monte Carlo methods to demonstrate a transition from antiferromagnetic to metallic phases for experimentally accessible lattice constant $a=50$ nm in terms of lattice site radius $\rho$, for finite sized artificial honeycomb structures nanopatterned on GaAs quantum wells containing up to 114 electrons. By analysing spin-spin correlation functions for hexagonal flakes with armchair edges and triangular flakes with zigzag edges, we show that edge type, geometry and charge nonuniformity affect the steepness and the crossover $\rho$ value of the phase transition. For triangular structures, the metal-insulator transition is accompanied with a smoother edge polarization transition.Comment: 5 pages, 5 figures; references added, several system sizes added, typos corrected; abstract update

Optical RF distribution links for MMIC phased array antennas

Conventional methods to distribute RF signals to GaAs Monolithic Microwave Integrated Circuits Phased Array Antennas are inadequate for arrays having large numbers of elements. Optical RF distribution links have been proposed as a lightweight, mechanically flexible, and low volume solution. Three candidate techniques for providing optical RF distribution are discussed along with the electro-optic devices required to configure them. A discussion of the present status of applicable electro-optics devices is also included

Hereditary Systemic Autoinflammatory Diseases: Therapeutic Stratification

Hereditary systemic autoinflammatory diseases (SAIDs) are rare, often severe conditions characterised by mutations in the key regulators of innate immune responses. Dramatic advances in the molecular genetics and next-generation sequencing in the past decade enabled identification of novel mutations that play a pivotal role in the mechanistic pathways of inflammation. Although genetic testing may not always provide straightforward guidance in diagnosis and clinical decision making, through translational research, it sheds light into molecular immunopathogenesis, particularly in IL-1 inflammasome and cytokine signalling pathways. These remarkable insights provided a better understanding of autoinflammatory conditions and their association with the innate and adaptive immune systems, as well as leading to development of cytokine-targetted biologic treatments. Use of targetted therapeutics not only helps control disease flares, reduce acute-phase responses and prevent devastating complications such as amyloidosis, but also improves health-related quality of lives and support patients to pursue almost a normal life. Herein, we discuss the commonest monogenic SAIDs, describe their immunopathology, and summarise the approaches in the management and targetted treatment of these conditions, including presentation of novel data based on a cohort of children with these rare diseases from a single quaternary referral centre in London