24 research outputs found
Stability analysis of the self-phase-locked divide-by-2 optical parametric oscillator
The properties of all-optical phase-coherent frequency division by 2, based on a self-phase-locked continuous-wave (cw) optical parametric oscillator (OPO), are investigated theoretically. The coupled field equations of an OPO with intracavity quarter-wave plate are solved analytically in steady-state, yielding a condition for self-phase-locked operation. In the self-phase-locked state, two different values for the pump power at threshold are obtained. By using a linear stability analysis, it is proven that only the lower threshold value is stable, whereas the higher threshold value is unstable. The analytical investigations of the steady-state field values further reveal a twofold symmetry in phase space. The theoretical consideration is completed by a numerical analysis based on the integration of the envelopes of the three OPO fields, which allows for studying the temporal evolution of different initial values. The numerical investigation of the OPO subharmonic phases shows that the two-phase eigenstates are equivalent with respect to experimental parameters and are assumed by the self-phase-locked OPO in dependence of the initial phases of the subharmonic fields, dividing phase space into two symmetric basins of attraction
A route to sub-diffraction-limited CARS Microscopy
We theoretically investigate a scheme to obtain sub-diffraction-limited resolution in coherent anti-Stokes Raman scattering (CARS) microscopy. We find using density matrix calculations that the rise of vibrational (Raman) coherence can be strongly suppressed, and thereby the emission of CARS signals can be significantly reduced, when pre-populating the corresponding vibrational state through an incoherent process. The effectiveness of pre-populating the vibrational state of interest is investigated by considering the excitation of a neighbouring vibrational (control) state through an intense, mid-infrared control laser. We observe that, similar to the processes employed in stimulated emission depletion microscopy, the CARS signal exhibits saturation behaviour if the transition rate between the vibrational and the control state is large. Our approach opens up the possibility of achieving chemically selectivity sub-diffraction-limited spatially resolved imaging
Spatially dependent Rabi oscillations: an approach to sub-diffraction-limited CARS microscopy
We present a theoretical investigation of coherent anti-Stokes Raman
scattering (CARS) that is modulated by periodically depleting the ground state
population through Rabi oscillations driven by an additional control laser. We
find that such a process generates optical sidebands in the CARS spectrum and
that the frequency of the sidebands depends on the intensity of the control
laser light field. We show that analyzing the sideband frequency upon scanning
the beams across the sample allows one to spatially resolve emitter positions
where a spatial resolution of 65 nm, which is well below the diffraction-limit,
can be obtained
Ground-state depletion for subdiffraction-limited spatial resolution in coherent anti-Stokes Raman scattering microscopy
We theoretically investigate ground-state depletion for subdiffraction-limited spatial resolution in coherent anti-Stokes Raman scattering (CARS) microscopy. We propose a scheme based on ground-state depopulation, which is achieved via a control laser light field incident prior to the CARS excitation light fields. This ground-state depopulation results in a reduced CARS signal generation. With an appropriate choice of spatial beam profiles, the scheme can be used to increase the spatial resolution. Based on the density matrix formalism we calculate the CARS signal generation and find a CARS signal suppression by 75% due to ground-state depletion with a single control light field and by using two control light fields the CARS signal suppression can be enhanced to 94%. Additional control light fields will enhance the CARS suppression even further. In case of a single control light field we calculate resulting CARS images using a computer-generated test image including quantum and detector noise and show that the background from the limited CARS suppression can be removed by calculating difference images, yielding subdiffraction-limited resolution where the resolution achievable depends only on the intensity used
8x8 Reconfigurable quantum photonic processor based on silicon nitride waveguides
The development of large-scale optical quantum information processing
circuits ground on the stability and reconfigurability enabled by integrated
photonics. We demonstrate a reconfigurable 8x8 integrated linear optical
network based on silicon nitride waveguides for quantum information processing.
Our processor implements a novel optical architecture enabling any arbitrary
linear transformation and constitutes the largest programmable circuit reported
so far on this platform. We validate a variety of photonic quantum information
processing primitives, in the form of Hong-Ou-Mandel interference, bosonic
coalescence/anticoalescence and high-dimensional single-photon quantum gates.
We achieve fidelities that clearly demonstrate the promising future for
large-scale photonic quantum information processing using low-loss silicon
nitride.Comment: Added supplementary materials, extended introduction, new figures,
results unchange
Ground-state depletion for subdiffraction-limited spatial resolution in coherent anti-Stokes Raman scattering microscopy
We theoretically investigate ground-state depletion for subdiffraction-limited spatial resolution in coherent anti-Stokes Raman scattering (CARS) microscopy. We propose a scheme based on ground-state depopulation, which is achieved via a control laser light field incident prior to the CARS excitation light fields. This ground-state depopulation results in a reduced CARS signal generation. With an appropriate choice of spatial beam profiles, the scheme can be used to increase the spatial resolution. Based on the density matrix formalism we calculate the CARS signal generation and find a CARS signal suppression by 75% due to ground-state depletion with a single control light field and by using two control light fields the CARS signal suppression can be enhanced to 94%. Additional control light fields will enhance the CARS suppression even further. In case of a single control light field we calculate resulting CARS images using a computer-generated test image including quantum and detector noise and show that the background from the limited CARS suppression can be removed by calculating difference images, yielding subdiffraction-limited resolution where the resolution achievable depends only on the intensity used
Towards frequency stabilization of a chip-based, ultra-narrow linewidth InP-Si3N4 hybrid laser
Detection of hydrothermal aging in Cured-In-Place Pipes (CIPP) based on microwave system
Pipe rehabilitation by means of trenchless techniques has been performed for more than 40 years already. Cured-in-place pipe (CIPP) is a trenchless method to repair damaged pipelines by inserting a new liner of polymer composite inside the existing host pipe. Since these liners are exposed to water at different temperature after installation for a long time, the purpose of a study was to investigate the effect of hydrothermal aging on CIPP samples and how this effect can be assessed by means of nondestructive testing. The hydrothermal aging was performed by immersion of liner samples in double-distilled water at 65°C. The effect of aging on the samples was determined by comparison of reference information (optical microscopy images and weight) with nondestructive testing parameters using microwaves. For nondestructive material testing, microwaves have been applied in the frequency range between 0.3 and 300 GHz. Microwave based methods have the advantage of no directcoupling between the probe and the object under test being required, such that the evaluation can be performed remotely from a standoff distance. The microwaves used in this study were in the frequency range of 75 - 100 GHz. For this a vector network analyzer (VNA) with frequency-modulated continuous wave (FMCW) radar was used to enable an accurate and broadband measurement. The effect of water-induced aging appeared as a change in the received microwave amplitude, which results from a change in permittivity of the material being inspected. The results of the weight measurement proved the water absorption in the samples. Moreover, the effects of water absorption were visible in the optic microscopic images as cracks and de-bonding between fibers and matrix. Getting those results combined does result in an approach on how to hopefully assess CIPP liners in service in the future