98 research outputs found
Inclusive Production Cross Sections from 920 GeV Fixed Target Proton-Nucleus Collisions
Inclusive differential cross sections and
for the production of \kzeros, \lambdazero, and
\antilambda particles are measured at HERA in proton-induced reactions on C,
Al, Ti, and W targets. The incident beam energy is 920 GeV, corresponding to
GeV in the proton-nucleon system. The ratios of differential
cross sections \rklpa and \rllpa are measured to be and , respectively, for \xf . No significant dependence upon the
target material is observed. Within errors, the slopes of the transverse
momentum distributions also show no significant
dependence upon the target material. The dependence of the extrapolated total
cross sections on the atomic mass of the target material is
discussed, and the deduced cross sections per nucleon are
compared with results obtained at other energies.Comment: 17 pages, 7 figures, 5 table
Recommended from our members
Feasibility of Diffraction Radiation for a Non-invasive Diagnostics of the SLAC Electron Beam
The development of the non-invasive bunch size diagnostics based on the diffraction radiation is now in progress in frame of TPU-KEK-SLAC collaboration. The experimental test of a transverse beam size measurement was performed successful on the KEK-ATF extracted electron beam. However many difficulties emerge if we going from the one GeV electron energy to the several tenth GeV electron beams. The extremely high Lorenz-factor value gives rise to the some problems, such as large contribution of a radiation from an accelerator construction elements in submillimeter wavelength region, extremely pre-wave zone effect even in the optical range, exceeding of the electron beam divergence over the diffraction radiation cone, and so on. More over, the sensitivity of the method based on the optical diffraction radiation from flat slit target decrease catastrophic when an electron energy increase up to several tenth GeV. We suggest the new method based on the phase shift on the slit target, consisting on the two semi-planes which are turned at a some angle one to other (crossed target technique) and present here the results of experimental test of this technique. Also we discuss the origins of indicated difficulties and suggest the ways of these problems solution
Recommended from our members
Characteristics of round and extracted strands of Nb3Al Rutherford cable
Long Nb{sub 3}Al strands with copper stabilizer are promising for future high field accelerator magnets. A 1.2 kilometer Nb{sub 3}Al strand with Cu stabilizer was fabricated at the National Institute for Materials Science in Japan. Using this strand a 30 meter Cu stabilized Nb{sub 3}Al Rutherford cable was made for the first time by a collaboration of NIMS and Fermilab. The Nb{sub 3}Al strands extracted from cable with a relatively low packing factor showed almost no J{sub c} degradation. But the extracted strands from the highly compacted cable showed some degradation in both J{sub c} and n value, which may be caused by local separation of the copper stabilizer. Still, its J{sub c} degradation is lower than that of typical Nb{sub 3}Sn strands. The current limit due to magnetic instability in low field is about 500 A at 4.2 K. The magnetization of the strands, which was measured with balanced coils at 4.2 K, showed large flux jumps, usually around 1.5 T. This value is much larger than the B{sub c2} (4.2 K) of the Nb matrix, which is around 0.4 Tesla. The magnetic instability of the Nb{sub 3}Al strand at low field is not completely understood, but it might be explained by the superconducting coupling current through the Nb matrix
- …