Pump-induced wavefront distortion in prototypical NIF/LMJ amplifiers-modeling and comparison with experiments

In large-aperture laser amplifiers such as those envisioned for the National Ignition Facility (NIF) and Laser Megajoules (LMJ) lasers, the geometry is such that the front and back faces of the laser slab are heated unevenly by the pump process. This uneven heating results in a mechanical deformation of the laser slab and consequent internal stresses. The deformation and stresses, along with a temperature-dependent refractive index variation, result in phase variations across the laser beam (so-called pump-induced wavefront distortions). These phase variations lead to beam steering which may affect frequency conversion as well as energy-on-target. We have developed a model which allows us to estimate the pump-induced wavefront distortion for a given amplifier configuration as well as the spatially-resolved depolarization. The model is compared with experiments taken in our amplifier development laboratory, AMPLA

Laser coupling to reduced-scale targets at NIF Early Light

Deposition of maximum laser energy into a small, high-Z enclosure in a short laser pulse creates a hot environment. Such targets were recently included in an experimental campaign using the first four of the 192 beams of the National Ignition Facility [J. A. Paisner, E. M. Campbell, and W. J. Hogan, Fusion Technology 26, 755 (1994)], under construction at the University of California Lawrence Livermore National Laboratory. These targets demonstrate good laser coupling, reaching a radiation temperature of 340 eV. In addition, the Raman backscatter spectrum contains features consistent with Brillouin backscatter of Raman forward scatter [A. B. Langdon and D. E. Hinkel, Physical Review Letters 89, 015003 (2002)]. Also, NIF Early Light diagnostics indicate that 20% of the direct backscatter from these reduced-scale targets is in the polarization orthogonal to that of the incident light

Design and performance of the main amplifier system for the National Ignition Facility

This paper describes the design and performance of flashlamp-pumped, Nd:glass. Brewster-angle slab amplifiers intended to be deployed in the National Ignition Facility (NIF). To verify performance, we tested a full-size, three-slab-long, NIF prototype amplifier, which we believe to be the largest flashlamp-pumped Nd:glass amplifier ever assembled. Like the NIF amplifier design, this prototype amplifier had eight 40-cm-square apertures combined in a four-aperture-high by two-aperture-wide matrix. Specially-shaped reflectors, anti-reflective coatings on the blastshields, and preionized flashlamps were used to increase storage efficiency. Cooling gas was flowed over the flashlamps to remove waste pump heat and to accelerate thermal wavefront recovery. The prototype gain results are consistent with model predictions and provide high confidence in the final engineering design of the NIF amplifiers. Although the dimensions, internal positions, and shapes of the components in the NIF amplifiers will be slightly different from the prototype, these differences are small and should produce only slight differences in amplifier performanc