82 research outputs found
First generation of optical fiber phase reference distribution system for TESLA
This report describes the design of a phase stable Fiber Optic (FO) link for the TESLA technology based projects. The concept of this long optical link, with a feedback system suppressing long term drifts of the RF signal phase is described. Stability requirements are given and most important design issues affecting the system performance are discussed. The technical design issues of system components like laser transmitter and optical phase shifter are described in detail. Last sections depict the software developed for system control and experimental results obtained after system was assembled
Recommended from our members
Operation of the rf controls in the CEBAF injector
The CEBAF injector has produced its first relativistic beam with two superconducting cavities. Six RF control modules are used to control amplitude and phase in the chopper cavities, the buncher, the capture section, and the two superconducting cavities. In this paper the required stability and actual performance of the modules are discussed. For the superconducting cavity control, performance is consistent with energy stability of {approx}10{sup {minus}4}
First Observation of Self-Amplified Spontaneous Emission in a Free-Electron Laser at 109 nm Wavelength
We present the first observation of Self-Amplified Spontaneous Emission
(SASE) in a free-electron laser (FEL) in the Vacuum Ultraviolet regime at 109
nm wavelength (11 eV). The observed free-electron laser gain (approx. 3000) and
the radiation characteristics, such as dependency on bunch charge, angular
distribution, spectral width and intensity fluctuations all corroborate the
existing models for SASE FELs.Comment: 6 pages including 6 figures; e-mail: [email protected]
The Superconducting TESLA Cavities
The conceptional design of the proposed linear electron-positron collider
TESLA is based on 9-cell 1.3 GHz superconducting niobium cavities with an
accelerating gradient of Eacc >= 25 MV/m at a quality factor Q0 > 5E+9. The
design goal for the cavities of the TESLA Test Facility (TTF) linac was set to
the more moderate value of Eacc >= 15 MV/m. In a first series of 27
industrially produced TTF cavities the average gradient at Q0 = 5E+9 was
measured to be 20.1 +- 6.2 MV/m, excluding a few cavities suffering from
serious fabrication or material defects. In the second production of 24 TTF
cavities additional quality control measures were introduced, in particular an
eddy-current scan to eliminate niobium sheets with foreign material inclusions
and stringent prescriptions for carrying out the electron-beam welds. The
average gradient of these cavities at Q0 = 5E+9 amounts to 25.0 +- 3.2 MV/m
with the exception of one cavity suffering from a weld defect. Hence only a
moderate improvement in production and preparation techniques will be needed to
meet the ambitious TESLA goal with an adequate safety margin. In this paper we
present a detailed description of the design, fabrication and preparation of
the TESLA Test Facility cavities and their associated components and report on
cavity performance in test cryostats and with electron beam in the TTF linac.
The ongoing R&D towards higher gradients is briefly addressed.Comment: 45 pages (Latex), 39 figures (Encapsulated Postscript), 53 Author
Recommended from our members
The CEBAF fiber optic phase reference system
The specified phase stability of the CEBAF RF distribution system is 2.9{degree} rms per linac. Stability is achieved through the use of a temperature and pressure regulated coaxial drive line. Purpose of the fiber optic phase reference system is to monitor the relative phase at the beginning and ending of this drive line, between linacs, injector and separator to determine drift due to ambient temperature fluctuations. The system utilizes an Ortel 1310 nm single mode laser driving Sumitumo optical fiber to distribute a reference signal at 1497 MHz. Phase of this reference signal is compared to the 1427 MHz (LO) and the 70 MHz (IF) via a 360{degree} phase detector. The detected information is then routed to the CEBAF control system for display with a specified resolution of {+-}0.2{degree} over a 20{degree} phase delta
- …