Effectiveness of kanban approaches in systems engineering within rapid response environments

AbstractEffective application of systems engineering in rapid response environments has been difficult, particularly those where large, complex brownfield systems or systems of systems exist and are constantly being updated with both short and long term software enhancements. This paper proposes a general case for solving this problem by combining a services approach to systems engineering with a kanban-based scheduling system. It provides the basis for validating the approach with agent-based simulations

The effect of aging on cervical parameters in a normative North American population

Study Design: Retrospective cohort study. Objectives: To investigate age-based changes in cervical alignment parameters in an asymptomatic population. Methods: Retrospective review of a prospective study of 118 asymptomatic subjects who underwent biplanar imaging with 3-dimensional capabilities. Demographic and health-related quality of life data was collected prior to imaging. Patients were stratified into 5 age groups: &lt;35 years, 35-44 years, 45-54 years, 55-64 years, and ≥65 years. Radiographic measurements of the cervical spine and spinopelvic parameters were compared between age groups. The normal distribution of parameters was assessed followed by analysis of variance for comparison of variance between age groups. Results: C2-C7 lordosis, C0-C7 lordosis, and T1 slope demonstrated significant increases with age. C0-C7 lordosis was significantly less in subjects &lt;35 years compared with ≥55 years. Significant differences in T1 slope were identified in patients &lt;35 versus ≥65, 35-44 versus ≥65, and 45-54 versus ≥65 years. T1 slope demonstrated a positive correlation with age. Horizontal gaze parameters did not change linearly with age and mean averages of all age groups were within 10° of one another. Cervical kyphosis was present in approximately half of subjects who were &lt;55 compared with approximately 10% of subjects ≥55 years. Differences in pelvic tilt, pelvic incidence-lumbar lordosis, and C7-S1 sagittal vertical axis were identified with age. Conclusions: C0-C7 lordosis, C2-C7 lordosis, and T1 slope demonstrate age-based changes while other cervical and horizontal gaze parameters remain relatively constant with age. </jats:sec

Agile and Lean Systems Engineering: Kanban in Systems Engineering

This is the 2nd of two reports that were created for research on this topic funded through SERC. The first report, SERC-TR-032-1 dated March 13, 2012, constituted the 2011-2012 Annual Technical Report and the Final Technical Report of the SERC Research Task RT-6: Software Intensive Systems Data Quality and Estimation Research In Support of Future Defense Cost Analysis. The overall objectives of RT-6 were to use data submitted to DoD in the Software Resources Data Report (SRDR) forms to provide guidance for DoD projects in estimating software costs for future DoD projects. In analyzing the data, the project found variances in productivity data that made such SRDR-based estimates highly variable. The project then performed additional analyses that provided better bases of estimate, but also identified ambiguities in the SRDR data definitions that enabled the project to help the DoD DCARC organization to develop better SRDR data definitions. In SERC-TR-2012-032-1, the resulting Manual provided the guidance elements for software cost estimation performers and users. Several appendices provide further related information on acronyms, sizing, nomograms, work breakdown structures, and references. SERC-TR-2013-032-2 (current report), included the “Software Cost Estimation Metrics Manual.” This constitutes the 2012-2013 Annual Technical Report and the Final Technical Report of the SERC Research Task Order 0024, RT-6: Software Intensive Systems Cost and Schedule Estimation Estimating the cost to develop a software application is different from almost any other manufacturing process. In other manufacturing disciplines, the product is developed once and replicated many times using physical processes. Replication improves physical process productivity (duplicate machines produce more items faster), reduces learning curve effects on people and spreads unit cost over many items. Whereas a software application is a single production item, i.e. every application is unique. The only physical processes are the documentation of ideas, their translation into computer instructions and their validation and verification. Production productivity reduces, not increases, when more people are employed to develop the software application. Savings through replication are only realized in the development processes and on the learning curve effects on the management and technical staff. Unit cost is not reduced by creating the software application over and over again. This manual helps analysts and decision makers develop accurate, easy and quick software cost estimates for different operating environments such as ground, shipboard, air and space. It was developed by the Air Force Cost Analysis Agency (AFCAA) in conjunction with DoD Service Cost Agencies, and assisted by the SERC through involving the University of Southern California and the Naval Postgraduate School. The intent is to improve quality and consistency of estimating methods across cost agencies and program offices through guidance, standardization, and knowledge sharing. The manual consists of chapters on metric definitions, e.g., what is meant by equivalent lines of code, examples of metric definitions from commercially available cost models, the data collection and repository form, guidelines for preparing the data for analysis, analysis results, cost estimating relationships found in the data, productivity benchmarks, future cost estimation challenges and a very large appendix.SERCU.S. Department of DefenseSystems Engineering Research Center (SERC)Systems Engineering Research Center (SERC) Contract H98230-08-D-0171

Development and implementation of a virtual laboratory for fundamentals on power systems

Abstract In almost any engineering department, a laboratory is an integral part of the educational process. The laboratory is a key component in the field of engineering in general, and electrical power engineering in particular. The virtual laboratory (VL) is a simulated experiment run by students on a computer station program; it can transform the conventional laboratory experiments into an interactive virtual environment, allowing simple and complex phenomena to be investigated by students just by changing the parameters and conditions of the experiments. This paper describes the development and the implementation of a VL, named VLABPOWER, for fundamentals on power systems. Mainly, electrical power engineering students will using to increase their understanding and to bridge the gap that exists between the theoretical part in the class and the practical at the traditional (real) laboratory and to better prepare before going to the traditional laboratory. The purpose of this work is to develop and implement a VL in order to enable students to have a better understanding of the experiments done in the traditional laboratory and to familiarize themselves with the different components used for those experiments. It presents a virtual interactive experiment environment that simulates the physical conditions on the transmission line. Moreover, it discusses and explains different types of short circuit faults such as symmetrical and unsymmetrical faults, modeling of different type of lines, and load condition analysis

Regular Doses of Nature: The Efficacy of Green Exercise Interventions for Mental Wellbeing.

This study investigated the efficacy of medium-term Green Exercise (GE; being physically active within a natural environment) interventions for improving wellbeing, by pooling data collected at the start and end of participants' engagement with a range of GE interventions. Hypotheses were that (i) interventions would show good efficacy for improving wellbeing in the overall sample; (ii) compared to participants reporting 'average to high' wellbeing at the start of their project, participants with 'low' starting wellbeing would report greater improvements post-intervention; and (iii) improvements would significantly differ between age groups. The pooled dataset was categorized in line with UK norms (n = 318) and analyzed using a standardized meta-analysis approach. Effect size was large: g = 0.812 (95% CI [0.599, 1.025]), and differences in wellbeing changes associated with project duration, age or sex were not statistically significant. Compared to those reporting 'average-high' starting wellbeing, participants reporting 'low' starting wellbeing exhibited greater improvements (BCa 95% CI [-31.8, -26.5]), with 60.8% moving into the 'average-high' wellbeing category. GE can play an important role in facilitating wellbeing and can provide alternative pathways for health and social care practice. Public health commissioners should consider integrating such interventions for patients experiencing low wellbeing or associated comorbidities

Pasos Adelante: The Effectiveness of a Community-based Chronic Disease Prevention Program

BACKGROUND: Implementing programs that target primary prevention of chronic diseases is critical for at-risk populations. Pasos Adelante, or "Steps Forward," is a curriculum aimed at preventing diabetes, cardiovascular disease, and other chronic diseases in Hispanic populations. Pasos Adelante is adapted from the National Heart, Lung, and Blood Institute's cardiovascular disease prevention curriculum, Su Corazón, Su Vida, and includes sessions on diabetes and community advocacy and incorporates walking clubs. CONTEXT: The Pasos Adelante curriculum was implemented in two Arizona, United States-Sonora, Mexico border counties. Key issues in these communities are safety, access to recreational facilities, climate, and cultural beliefs. METHODS: Pasos Adelante is a 12-week program facilitated by community health workers. The program includes interactive sessions on chronic disease prevention, nutrition, and physical activity. Evaluation of the program included precurriculum and postcurriculum questionnaires with self-reported measures of physical activity and dietary patterns. Approximately 250 people participated in the program in Yuma and Santa Cruz counties. CONSEQUENCES: Postprogram evaluation results demonstrate a significant increase in moderate to vigorous walking among participants and shifts in nutritional patterns. INTERPRETATION: The Pasos Adelante program demonstrates that an educational curriculum in conjunction with the support of community health workers can motivate people in Arizona/Sonora border communities to adopt healthy lifestyle behaviors