An antenna switching based NOMA scheme for IEEE 802.15.4 concurrent transmission

This paper introduces a Non-Orthogonal Multiple Access (NOMA) scheme to support concurrent transmission of multiple IEEE 802.15.4 packets. Unlike collision avoidance Multiple Access Control (MAC), concurrent transmission supports Concurrent-MAC (C-MAC) where packet collision is allowed. The communication latency can be reduced by C-MAC because a user can transmit immediately without waiting for the completion of other users’ transmission. The big challenge of concurrent transmission is that error free demodulation of multiple collided packets hardly can be achieved due to severe Multiple Access Interference (MAI). To improve the demodulation performance with MAI presented, we introduce an architecture with multiple switching antennas sharing a single analog transceiver to capture spatial character of different users. Successive Interference Cancellation (SIC) algorithm is designed to separate collided packets by utilizing the spatial character. Simulation shows that at least five users can transmit concurrently to the SIC receiver equipped with eight antennas without sacrificing Packet Error Rate

Openwifi : a free and open-source IEEE802.11 SDR implementation on SoC

Open source Software Defined Radio (SDR) project, such as srsLTE and Open Air Interface (OAI), has been widely used for 4G/5G research. However the SDR implementation of the IEEE802.11 (Wi-Fi) is still difficult. The Wi-Fi Short InterFrame Space (SIFS) requires acknowledgement (ACK) packet being sent out in 10μs/16μs(2.4 GHz/5GHz) after receiving a packet successfully, thus the Personal Computer (PC) based SDR architecture hardly can be used due to the latency (≥100μs) between PC and Radio Frequency (RF) front-end. Researchers have to do simulation, hack a commercial chip or buy an expensive reference design to test their ideas. To change this situation, we have developed an open-source full-stack IEEE802.11a/g/n SDR implementation — openwifi. It is based on Xilinx Zynq Systemon-Chip (SoC) that includes Field Programmable Gate Array (FPGA) and ARM processor. With the low latency connection between FPGA and RF front-end, the most critical SIFS timing is achieved by implementing Physical layer (PHY) and low level Media Access Control (low MAC) in FPGA. The corresponding driver is implemented in the embedded Linux running on the ARM processor. The driver instantiates Application Programming Interfaces (APIs) defined by Linux mac80211 subsystem, which is widely used for most SoftMAC Wi-Fi chips. Researchers could study and modify openwifi easily thanks to the modular design. Compared to PC based SDR, the SoC is also a better choice for portable and embedded scenario

A baseband wireless spectrum hypervisor for multiplexing concurrent OFDM signals

The next generation of wireless and mobile networks will have to handle a significant increase in traffic load compared to the current ones. This situation calls for novel ways to increase the spectral efficiency. Therefore, in this paper, we propose a wireless spectrum hypervisor architecture that abstracts a radio frequency (RF) front-end into a configurable number of virtual RF front ends. The proposed architecture has the ability to enable flexible spectrum access in existing wireless and mobile networks, which is a challenging task due to the limited spectrum programmability, i.e., the capability a system has to change the spectral properties of a given signal to fit an arbitrary frequency allocation. The proposed architecture is a non-intrusive and highly optimized wireless hypervisor that multiplexes the signals of several different and concurrent multi-carrier-based radio access technologies with numerologies that are multiple integers of one another, which are also referred in our work as radio access technologies with correlated numerology. For example, the proposed architecture can multiplex the signals of several Wi-Fi access points, several LTE base stations, several WiMAX base stations, etc. As it able to multiplex the signals of radio access technologies with correlated numerology, it can, for instance, multiplex the signals of LTE, 5G-NR and NB-IoT base stations. It abstracts a radio frequency front-end into a configurable number of virtual RF front ends, making it possible for such different technologies to share the same RF front-end and consequently reduce the costs and increasing the spectral efficiency by employing densification, once several networks share the same infrastructure or by dynamically accessing free chunks of spectrum. Therefore, the main goal of the proposed approach is to improve spectral efficiency by efficiently using vacant gaps in congested spectrum bandwidths or adopting network densification through infrastructure sharing. We demonstrate mathematically how our proposed approach works and present several simulation results proving its functionality and efficiency. Additionally, we designed and implemented an open-source and free proof of concept prototype of the proposed architecture, which can be used by researchers and developers to run experiments or extend the concept to other applications. We present several experimental results used to validate the proposed prototype. We demonstrate that the prototype can easily handle up to 12 concurrent physical layers

An approach to achieve zero turnaround time in TDD operation on SDR front-end

Thanks to the digitization and softwarization of radio communication, the development cycle of new radio technologies can be significantly accelerated by prototyping on software-defined radio (SDR) platforms. However, a slow turnaround time (TT) of the front-end of an SDR for switching from receiving mode to transmitting mode or vice versa, are jeopardizing the prototyping of wireless protocols, standards, or systems with stringent latency requirements. In this paper, a novel solution called BaseBand processing unit operating in Half Duplex mode and analog Radio Frequency front-end operating in Full Duplex mode, BBHD-RFFD, is presented to reduce the TT on SDR. A prototype is realized on the widely adopted AD9361 radio frequency frontend to prove the validity of the proposed solution. Experiments unveil that for any type of application, the TT in time division duplex (TDD) operation mode can be reduced to zero by the BBHD-RFFD approach, with negligible impact on the communication system in terms of receiver sensitivity. The impact is measured for an in-house IEEE 802.15.4 compliant transceiver. When compared against the conventional TDD approach, only a 7.5-dB degradation is observed with the BBHD-RFFD approach. The measured sensitivity of -91 dBm is still well above the minimum level (i.e., -85 dBm at 2.4 GHz) defined by the IEEE 802.15.4 standard

Demo : WiSCoP : wireless sensor communication prototyping platform

To enhance system performance of future heterogeneous wireless networks the co-design of PHY, MAC, and higher layer protocols is inevitable. In this work, we present WiSCoP - a novel embedded platform for experimentation, prototyping and implementation of integrated cross-layer network design approaches. WiSCoP is built on top of a Zynq hardware platform integrated with FMCOMMS1/2/4 RF front ends. We demonstrate the flexibility of WiSCoP by using it to prototype a fully standard compliant IEEE 802.15.4 stack with real-time performance and cross-layer integration.Comment: 2 pages, 2 figures, to be published in the EWSN'17 Proceedings of the 2017 International Conference on Embedded Wireless Systems and Networks, Uppsala, Sweden - February 20-22, 201

CMCVT : a concurrent multi-channel virtual transceiver

State-of-the-art wireless Gateways (GW) used in Internet of Things (IoT) offer a single channel radio link, which limits the capabilities of the IoT network controlled by the GW, as the GW can only use a single channel at a time to communicate with the end-device(s). The quality of service (e.g., aggregate throughput, latency) offered by a single channel GW could be substantially improved by employing a multi-channel transceiver, which is capable of transmitting/receiving data on different radio channels simultaneously, particularly for larger wireless networks. However, current solutions available in both research and commercial communities only offer multi-channel receiver capabilities, and do not incorporate the multi-channel transmitter part. In addition, in terms of implementation, these multi-channel receivers duplicate single-channel hardware functionality. In this paper, for the first time, a novel concurrent multi-channel virtual transceiver is introduced. The virtual transceiver offers multi-channel capabilities and uses the same single-hardware hardware implementation for the Physical (PHY) layer by employing the virtualization technique. This new virtual transceiver concept is demonstrated for an IEEE 802.15.4 based 8 x 8 channel transceiver, implemented on an Field Programmable Gate Array (FPGA) of a modern Software Defined Radio and is compared with the existing duplication approach. The duplication approach consumes 9008 LUTs, and 12120 FFs, whereas the proposed approach occupies only 2959 LUTs and 2105 FFs, saving 67.15% LUTs and 82.63% FFs in comparison with the duplication approach. The experimental results reveal that the virtual transceiver provides the same performance (e.g., receiver sensitivity of -98.5dBm) as the transceiver achieved by duplicating the PHY layers but consumes much less hardware resources. (C) 2020 The Authors. Published by Elsevier GmbH

Accelerating FPGA-Based Wi-Fi Transceiver Design and Prototyping by High-Level Synthesis

Field-Programmable Gate Array (FPGA)-based Software-Defined Radio (SDR) is well-suited for experimenting with advanced wireless communication systems, as it allows to alter the architecture promptly while obtaining high performance. However, programming the FPGA using a Hardware Description Language (HDL) is a time-consuming task for FPGA developers and difficult for software developers, which limits the potential of SDR. High-Level Synthesis (HLS) tools aid the designers by allowing them to program on a higher layer of abstraction. However, if not carefully designed, it may lead to a degradation in computing performance or significant increase in resource utilization. This work shows that it is feasible to design modern Orthogonal Frequency Division Multiplex (OFDM) baseband processing modules like channel estimation and equalization using HLS without sacrificing performance and to integrate them in an HDL design to form a fully-operational FPGA-based Wi-Fi (IEEE 802.11a/g/n) transceiver. Starting from no HLS experience, a design with minor overhead in terms of latency and resource utilization as compared to the HDL approach was created in less than one month. We show the readability of the sequential logic as coded in HLS, and discuss the lessons learned from the approach taken and the benefits it brings for further design and experimentation. The FPGA design generated by HLS was verified to be bit-true with its MATLAB implementation in simulation. Furthermore, we show its practical performance when deployed on a System-on-Chip (SoC)-based SDR using a professional wireless connectivity tester.Comment: 7 pages, extended version of poster accepted at FCCM 202

Radio hardware virtualization for software-defined wireless networks

Software-Defined Network (SDN) is a promising architecture for next generation Internet. SDN can achieve Network Function Virtualization much more efficiently than conventional architectures by splitting the data and control planes. Though SDN emerged first in wired network, its wireless counterpart Software-Defined Wireless Network (SDWN) also attracted an increasing amount of interest in the recent years. Wireless networks have some distinct characteristics compared to the wired networks due to the wireless channel dynamics. Therefore, network controllers present some extra degrees of freedom, such as taking measurements against interference and noise, or adapting channels according to the radio spectrum occupation. These specific characteristics bring about more challenges to wireless SDNs. Currently, SDWN implementations are mainly using customized firmware, such as OpenWRT, running on an embedded application processor in commercial WiFi chips, and restricted to layers above lower Media Access Control. This limitation comes from the fact that radio hardware usually require specific drivers, which have a proprietary implementation by various chipset vendors. Hence, it is difficult, if not impossible, to achieve virtualization on the radio hardware. However, this status has been changing as Software-Defined Radio (SDR) systems open up the entire radio communication stack to radio hobbyists and researchers. The bridge between SDR and SDN will make it possible to bring the softwarization and virtualization of wireless networks down to the physical layer, which will unlock the full potential of SDWN. This paper investigates the necessity and feasibility of extending the virtualization of wireless networks towards the radio hardware. A SDR architecture is presented for radio hardware virtualization in order to facilitate SDWN design and experimentation. We do believe that by adopting the virtualization-oriented hardware accelerator design presented here, an all-layer end-to-end high performance SDWN can be achieved