Nonlocal explanation of stationary and nonstationary regimes in cascaded soliton pulse compression

We study soliton pulse compression in materials with cascaded quadratic nonlinearities, and show that the group-velocity mismatch creates two different temporally nonlocal regimes. They correspond to what is known as the stationary and nonstationary regimes. The theory accurately predicts the transition to the stationary regime, where highly efficient pulse compression is possible.Comment: 3 pages, 2 figures, published verison in Optics Letters. Contains revised equations, including an updated mode

Limits to compression with cascaded quadratic soliton compressors

We study cascaded quadratic soliton compressors and address the physical mechanisms that limit the compression. A nonlocal model is derived, and the nonlocal response is shown to have an additional oscillatory component in the nonstationary regime when the group-velocity mismatch (GVM) is strong. This inhibits efficient compression. Raman-like perturbations from the cascaded nonlinearity, competing cubic nonlinearities, higher-order dispersion, and soliton energy may also limit compression, and through realistic numerical simulations we point out when each factor becomes important. We find that it is theoretically possible to reach the single-cycle regime by compressing high-energy fs pulses for wavelengths $\lambda=1.0-1.3 \mu{\rm m}$ in a $\beta$-barium-borate crystal, and it requires that the system is in the stationary regime, where the phase mismatch is large enough to overcome the detrimental GVM effects. However, the simulations show that reaching single-cycle duration is ultimately inhibited by competing cubic nonlinearities as well as dispersive waves, that only show up when taking higher-order dispersion into account.Comment: 16 pages, 5 figures, submitted to Optics Expres

Crystalline free energies of micelles of diblock copolymer solutions

We report a characterization of the relative stability and structural behavior of various micellar crystals of an athermal model of AB-diblock copolymers in solution. We adopt a previously devel- oped coarse-graining representation of the chains which maps each copolymer on a soft dumbbell. Thanks to this strong reduction of degrees of freedom, we are able to investigate large aggregated systems, and for a specific length ratio of the blocks f = MA/(MA + MB) = 0.6, to locate the order-disorder transition of the system of micelles. Above the transition, mechanical and thermal properties are found to depend on the number of particles per lattice site in the simulation box, and the application of a recent methodology for multiple occupancy crystals (B.M. Mladek et al., Phys. Rev. Lett. 99, 235702 (2007)) is necessary to correctly define the equilibrium state. Within this scheme we have performed free energy calculations at two reduced density {\rho}/{\rho}\ast = 4,5 and for several cubic structures as FCC,BCC,A15. At both densities, the BCC symmetry is found to correspond to the minimum of the unconstrained free energy, that is to the stable symmetry among the few considered, while the A15 structure is almost degenerate, indicating that the present sys- tem prefers to crystallize in less packed structures. At {\rho}/{\rho}\ast = 4 close to melting, the Lindemann ratio is fairly high (~ 0.29) and the concentration of vacancies is roughly 6%. At {\rho}/{\rho}\ast = 5 the mechanical stability of the stable BCC structure increases and the concentration of vacancies ac- cordingly decreases. The ratio of the corona layer thickness to the core radius is found to be in good agreement with experimental data for poly(styrene-b-isoprene)(22-12) in isoprene selective solvent which is also reported to crystallize in the BCC structure

Are there nodes in LaFePO, BaFe2_2(AsP)2_2, and KFe2_2As2_2 ?

We reexamined the experimental evidences for the possible existence of the superconducting (SC) gap nodes in the three most suspected Fe-pnictide SC compounds: LaFePO, BaFe$_2$(As$_{0.67}$P$_{0.33}$)$_2$, and KFe$_2$As$_2$. We showed that while the $T$-linear temperature dependence of the penetration depth $\lambda(T)$ of these three compounds indicate extremely clean nodal gap superconductors, the thermal conductivity data $\lim_{T,H \rightarrow 0} \kappa_S (H,T)/T$ unambiguously showed that LaFePO and BaFe$_2$(As$_{0.67}$P$_{0.33}$)$_2$ are extremely dirty, while KFe$_2$As$_2$ can be clean. This apparently conflicting experimental data casts a serious doubt on the nodal gap possibility on LaFePO and BaFe$_2$(As$_{0.67}$P$_{0.33}$)$_2$.Comment: 11 pages, 5 figures A new section "4. Remark on the quantum oscillation (QO) experiments" is adde

Superconductivity-induced Phonon Renormalization on NaFe1−x_{1-x}Cox_{x}As

We report a study of the lattice dynamics in superconducting NaFeAs (Tc = 8 K) and doped NaFe0.97Co0.03As (Tc = 20 K) using Raman light scattering. Five of the six phonon modes expected from group theory are observed. In contrast with results obtained on iso-structural and iso-electronic LiFeAs, anomalous broadening of Eg(As) and A1g(Na) modes upon cooling is observed in both samples. In addition, in the Co-doped sample, a superconductivity-induced renormalization of the frequency and linewidth of the B1g(Fe) vibration is observed. This renormalization can not be understood within a single band and simple multi-band approaches. A theoretical model that includes the effects of SDW correlations along with sign-changing s-wave pairing state and interband scattering has been developed to explain the observed behavior of the B1g(Fe) mode.Comment: 10 pages; 6 figure

Chalcogenide-glass polarization-maintaining photonic crystal fiber for mid-infrared supercontinuum generation

In this paper, we report the design and fabrication of a highly birefringent polarization-maintaining photonic crystal fiber (PM-PCF) made from chalcogenide glass, and its application to linearly-polarized supercontinuum (SC) generation in the mid-infrared region. The PM fiber was drawn using the casting method from As38Se62 glass which features a transmission window from 2 to 10 $\mu m$ and a high nonlinear index of 1.13.10$^{-17}$m$^{2}$W$^{-1}$. It has a zero-dispersion wavelength around 4.5 $\mu m$ and, at this wavelength, a large birefringence of 6.10$^{-4}$ and consequently strong polarization maintaining properties are expected. Using this fiber, we experimentally demonstrate supercontinuum generation spanning from 3.1-6.02 $\mu m$ and 3.33-5.78 $\mu m$ using femtosecond pumping at 4 $\mu m$ and 4.53 $\mu m$, respectively. We further investigate the supercontinuum bandwidth versus the input pump polarization angle and we show very good agreement with numerical simulations of the two-polarization model based on two coupled generalized nonlinear Schr\"odinger equations.Comment: 13 pages, 8 figure

Optimization of the neutron yield in fusion plasmas produced by Coulomb explosions of deuterium clusters irradiated by a petawatt laser

The kinetic energy of hot (multi-keV) ions from the laser-driven Coulomb explosion of deuterium clusters and the resulting fusion yield in plasmas formed from these exploding clusters has been investigated under a variety of conditions using the Texas Petawatt laser. An optimum laser intensity was found for producing neutrons in these cluster fusion plasmas with corresponding average ion energies of 14 keV. The substantial volume (1-10 mm(3)) of the laser-cluster interaction produced by the petawatt peak power laser pulse led to a fusion yield of 1.6x10(7) neutrons in a single shot with a 120 J, 170 fs laser pulse. Possible effects of prepulses are discussed. DOI: 10.1103/PhysRevE.87.023106Glenn Focht Memorial FellowshipNNSA DE-FC52-08NA28512DOE Office of Basic Energy SciencesPhysic