Beryllium fastener technology

Program was conducted to develop, produce, and test optimum-configuration, beryllium prestressed and blind fasteners. The program was carried out in four phases - phase 1, feasibility study, phase 2, development, phase 3, evaluation of beryllium alloys, and phase 4, fabrication and testing

Test results of the Chrysler upgraded automotive gas turbine engine: Initial design

The upgraded engine as built to the original design was deficient in power and had excessive specific fuel consumption. A high instrumented version of the engine was tested to identify the sources of the engine problems. Analysis of the data shows the major problems to be low compressor and power turbine efficiency and excessive interstage duct losses. In addition, high HC and CO emission were measured at idle, and high NOx emissions at high energy speeds

Space biology initiative program definition review. Trade study 2: Prototype utilization in the development of space biology hardware

The objective was to define the factors which space flight hardware developers and planners should consider when determining: (1) the number of hardware units required to support program; (2) design level of the units; and (3) most efficient means of utilization of the units. The analysis considered technology risk, maintainability, reliability, and safety design requirements for achieving the delivery of highest quality flight hardware. Relative cost impacts of the utilization of prototyping were identified. The development of Space Biology Initiative research hardware will involve intertwined hardware/software activities. Experience has shown that software development can be an expensive portion of a system design program. While software prototyping could imply the development of a significantly different end item, an operational system prototype must be considered to be a combination of software and hardware. Hundreds of factors were identified that could be considered in determining the quantity and types of prototypes that should be constructed. In developing the decision models, these factors were combined and reduced by approximately ten-to-one in order to develop a manageable structure based on the major determining factors. The Baseline SBI hardware list of Appendix D was examined and reviewed in detail; however, from the facts available it was impossible to identify the exact types and quantities of prototypes required for each of these items. Although the factors that must be considered could be enumerated for each of these pieces of equipment, the exact status and state of development of the equipment is variable and uncertain at this time

Mapping the Evolution of Optically-Generated Rotational Wavepackets in a Room Temperature Ensemble of D2_2

A coherent superposition of rotational states in D$_2$ has been excited by nonresonant ultrafast (12 femtosecond) intense (2 $\times$ 10$^{14}$ Wcm$^{-2}$) 800 nm laser pulses leading to impulsive dynamic alignment. Field-free evolution of this rotational wavepacket has been mapped to high temporal resolution by a time-delayed pulse, initiating rapid double ionization, which is highly sensitive to the angle of orientation of the molecular axis with respect to the polarization direction, $\theta$. The detailed fractional revivals of the neutral D$_2$ wavepacket as a function of $\theta$ and evolution time have been observed and modelled theoretically.Comment: 4 pages, 3 figures. Accepted for publication in Phys. Rev. A. Full reference to follow.

The Impacts of Microphysics and Planetary Boundary Layer Physics on Model Simulations of U. S. Deep South Summer Convection

Inspection of output from various configurations of high-resolution, explicit convection forecast models such as the Weather Research and Forecasting (WRF) model indicates significant sensitivity to the choices of model physics parameterizations employed. Some of the largest apparent sensitivities are related to the specifications of the cloud microphysics and planetary boundary layer physics packages. In addition, these sensitivities appear to be especially pronounced for the weakly-sheared, multicell modes of deep convection characteristic of the Deep South of the United States during the boreal summer. Possible ocean-land sensitivities also argue for further examination of the impacts of using unique ocean-land surface initialization datasets provided by the NASA Short-term Prediction Research and Transition (SPoRT Center to select NOAA/NWS weather forecast offices. To obtain better quantitative understanding of these sensitivities and also to determine the utility of the ocean-land initialization data, we have executed matrices of regional WRF forecasts for selected convective events near Mobile, AL (MOB), and Houston, TX (HGX). The matrices consist of identically initialized WRF 24-h forecasts using any of eight microphysics choices and any of three planetary boundary layer choices. The resulting 24 simulations performed for each event within either the MOB or HGX regions are then compared to identify the sensitivities of various convective storm metrics to the physics choices. Particular emphasis is placed on sensitivities of precipitation timing, intensity, and coverage, as well as amount and coverage of lightning activity diagnosed from storm kinematics and graupel in the mixed phase layer. The results confirm impressions gleaned from study of the behavior of variously configured WRF runs contained in the ensembles produced each spring at the Center for the Analysis and Prediction of Storms, but with the benefit of more straightforward control of the physics package choices. The design of the experiments thus allows for more direct interpretation of the sensitivities to each possible physics combination. The results should assist forecasters in their efforts to anticipate and correct for possible biases in simulated WRF convection patterns, and help the modeling community refine their model parameterizations

High-Temperature Transport Properties of Yb4−xSmxSb3

Polycrystalline L4Sb3 (L = La, Ce, Sm, and Yb) and Yb4−x Sm x Sb3, which crystallizes in the anti-Th3P4 structure type (I-43d no. 220), were synthesized via high-temperature reaction. Structural and chemical characterization were performed by x-ray diffraction and electronic microscopy with energy-dispersive x-ray analysis. Pucks were densified by spark plasma sintering. Transport property measurements showed that these compounds are n-type with low Seebeck coefficients, except for Yb4Sb3, which shows semimetallic behavior with hole conduction above 523 K. By partially substituting Yb by a trivalent rare earth we successfully improved the thermoelectric figure of merit of Yb4Sb3 up to 0.7 at 1273 K

A feasibility study of ion implantation techniques for mass spectrometer calibration

An experimental study was undertaken to examine the feasibility of using ion-implanted filaments doped with either an alkali metal or noble gas for in situ recalibration of onboard mass spectrometers during extended space missions. Implants of rubidium and krypton in rhenium ribbon filaments were subsequently tested in a bakeable 60 deg sector mass spectrometer operating in the static mode. Surface ionization and electron impact ion sources were both used, each yielding satisfactory results. The metallic implant with subsequent ionization provided a means of mass scale calibration and determination of system operating parameters, whereas the noble gas thermally desorbed into the system was more suited for partial pressure and sensitivity determinations

Mesoscopic motion of atomic ions in magnetic fields

We introduce a semiclassical model for moving highly excited atomic ions in a magnetic field which allows us to describe the mixing of the Landau orbitals of the center of mass in terms of the electronic excitation and magnetic field. The extent of quantum energy flow in the ion is investigated and a crossover from localization to delocalization with increasing center of mass energy is detected. It turns out that our model of the moving ion in a magnetic field is closely connected to models for transport in disordered finite-size wires.Comment: 4 pages, 2 figures, subm. to Phys.Rev.A, Rap.Co

Biomarker Testing for People With Advanced Lung Cancer in England

Introduction: Optimal management of people with advanced NSCLC depends on accurate identification of predictive markers. Yet, real-world data in this setting are limited. We describe the impact, timeliness, and outcomes of molecular testing for patients with advanced NSCLC and good performance status in England. // Methods: In collaboration with Public Health England, patients with stages IIIB to IV NSCLC, with an Eastern Cooperative Oncology Group performance status of 0 to 2, in England, between June 2017 and December 2017, were identified. All English hospitals were invited to record information. // Results: A total of 60 of 142 invited hospitals in England participated in this study and submitted data on 1157 patients. During the study period, 83% of patients with advanced adenocarcinoma underwent molecular testing for three recommended predictive biomarkers (EGFR, ALK, and programmed death-ligand 1). A total of 80% of patients with nonsquamous carcinomas on whom biomarker testing was performed had adequate tissue for analysis on initial sampling. First-line treatment with a tyrosine kinase inhibitor was received by 71% of patients with adenocarcinoma and a sensitizing EGFR mutation and by 59% of those with an ALK translocation. Of patients with no driver mutation and a programmed death-ligand 1 expression of greater than or equal to 50%, 47% received immunotherapy. // Conclusions: We present a comprehensive data set for molecular testing in England. Although molecular testing is well established in England, timeliness and uptake of targeted therapies should be improved