79,067 research outputs found
Spin-triplet s-wave local pairing induced by Hund's rule coupling
We show within the dynamical mean field theory that local multiplet
interactions such as Hund's rule coupling produce local pairing
superconductivity in the strongly correlated regime. Spin-triplet
superconductivity driven by the Hund's rule coupling emerges from the pairing
mediated by local fluctuations in pair exchange. In contrast to the
conventional spin-triplet theories, the local orbital degrees of freedom has
the anti-symmetric part of the exchange symmetry, leaving the spatial part as
fully gapped and symmetric s-wave.Comment: 9 pages, 7 figure
Single-Electron Traps: A Quantitative Comparison of Theory and Experiment
We have carried out a coordinated experimental and theoretical study of
single-electron traps based on submicron aluminum islands and aluminum oxide
tunnel junctions. The results of geometrical modeling using a modified version
of MIT's FastCap were used as input data for the general-purpose
single-electron circuit simulator MOSES. The analysis indicates reasonable
quantitative agreement between theory and experiment for those trap
characteristics which are not affected by random offset charges. The observed
differences between theory and experiment (ranging from a few to fifty percent)
can be readily explained by the uncertainty in the exact geometry of the
experimental nanostructures.Comment: 17 pages, 21 figures, RevTex, eps
Experimental study of contact transition control incorporating joint acceleration feedback
Joint acceleration and velocity feedbacks are incorporated into a classical internal force control of a robot in contact with the environment. This is intended to achieve a robust contact transition and force tracking performance for varying unknown environments, without any need of adjusting the controller parameters, A unified control structure is proposed for free motion, contact transition, and constrained motion in view of the consumption of the initial kinetic energy generated by a nonzero impact velocity. The influence of the velocity and acceleration feedbacks, which are introduced especially for suppressing the transition oscillation, on the postcontact tracking performance is discussed. Extensive experiments are conducted on the third joint of a three-link direct-drive robot to verify the proposed scheme for environments of various stiffnesses, including elastic (sponge), less elastic (cardboard), and hard (steel plate) surfaces. Results are compared with those obtained by the transition control scheme without the acceleration feedback. The ability of the proposed control scheme in resisting the force disturbance during the postcontact period is also experimentally investigated
Numerical simulation of the world ocean circulation
A multi-level model, based on the primitive equations, is developed for simulating the temperature and velocity fields produced in the world ocean by differential heating and surface wind stress. The model ocean has constant depth, free slip at the lower boundary, and neglects momentum advection; so that there is no energy exchange between the barotropic and baroclinic components of the motion, although the former influences the latter through temperature advection. The ocean model was designed to be coupled to the UCLA atmospheric general circulation model, for the study of the dynamics of climate and climate changes. But here, the model is tested by prescribing the observed seasonally varying surface wind stress and the incident solar radiation, the surface air temperature and humidity, cloudiness and the surface wind speed, which, together with the predicted ocean surface temperature, determine the surface flux of radiant energy, sensible heat and latent heat
Heat transfer and pressure drop in blade cooling channels with turbulence promoters
Repeated rib roughness elements have been used in advanced turbine cooling designs to enhance the internal heat transfer. Often the ribs are perpendicular to the main flow direction so that they have an angle-of-attack of 90 deg. The objective of the project was to investigate the effect of rib angle-of-attack on the pressure drop and the average heat transfer coefficients in a square duct with two opposite rib-roughned walls for Reynolds number varied from 8000 to 80,000. The rib height-to-equivalent diameter ratio (e/D) was kept at a constant value of 0.063, the rib pitch-to-height ratio (P/e) was varied from 10 to 20, and the rib angle-of-attack (alpha) was varied from 90 deg to 60 deg to 45 deg to 30 deg respectively. Two types of entrance conditions were examined, namely, long duct and sudden contraction. The heat transfer coefficient distribution on the smooth side wall and the rough side wall at the entrance and the fully developed regions were measured. Thermal performance comparison indicated that the pumping power requirement for the rib with an oblique angle to the flow (alpha = 45 deg to 30 deg) was about 20 to 50 percent lower than the rib with a 90 deg angle to the flow for a given heat transfer duty
Coordination motifs and large-scale structural organization in atomic clusters
The structure of nanoclusters is complex to describe due to their
noncrystallinity, even though bonding and packing constraints limit the local
atomic arrangements to only a few types. A computational scheme is presented to
extract coordination motifs from sample atomic configurations. The method is
based on a clustering analysis of multipole moments for atoms in the first
coodination shell. Its power to capture large-scale structural properties is
demonstrated by scanning through the ground state of the Lennard-Jones and
C clusters collected at the Cambridge Cluster Database.Comment: 6 pages, 7 figure
Assessment of different urban traffic control strategy impacts on vehicle emissions
This paper investigates the influence of traffic signal control strategy on vehicle emissions, vehicle journey time and total throughput flow within a single isolated four-armed junction. Two pre-timed signal plans are considered, one with two-stages involving permissive-only opposing turns and the other with four-stages which has no conflicting traffic. Additionally, the increase in efficiency by utilising actuated signal timing where green time is re-optimised as flow values vary is investigated. A microscopic traffic simulation model is used to model flows and AIRE (Analysis of Instantaneous Road Emissions) microscopic emissions model is utilised to out- put emission levels from the flow data. A simple junction model shows that the two-stage signal plan is more efficient in both emis- sions and journey time. However, as the level of opposed turning vehicles and conflicting movement increases, the two-stage model moves to being the inferior signal plan choice and the four-stage plan outputs fewer emissions than the two-stage plan. A real-world example of a four-armed junction has been used in this study and from the traffic survey data and existing junction layout; it is rec- ommended that a two-stage plan is used as it produces lower amounts of emissions and shorter journey times compared to a four-stage plan. The results also show that nitrogen oxides (NOx) are the most sensitive to changes in flow followed by carbon dioxide (CO2), Black Carbon and then particulate matter (PM10)
Protein transduction: A novel tool for tissue regeneration
Tissue regeneration in humans is limited and excludes vitals organs like heart and brain. Transformation experiments with oncogenes like T antigen have shown that retrodifferentiation of the respective cells is possible but hard to control. To bypass the risk of cancer formation a protein therapy approach has been developed. The transient delivery of proteins rather than genes could still induce terminallydifferentiated cells to reenter the cell cycle. This approach takes advantage of proteintransducing domains that mediate the transfer of cargo proteins into cells. The goal of this brief review is to outline the basics of protein transduction and to discuss potential applications for tissue regeneration
- …