Estudo da geometria do cavaco no corte com discos abrasivos

This paper shows a research about the study of the chip's geometry generated in the diving cut-off operation, under several cutting conditions. As a result it was possible to verify tint the cutting conditions and the type of the material being cut can directly affect the chip's geometry

Análise do comportamento da microestrutura de materiais endurecidos retificados com rebolos de CBN

CBN grinding wheels are superabrasive tools, with cutting ability higher than the conventional ones, specially used for grinding DTG (Difficult to Grind) materials. Due to the higher hardness and thermal conductivity of the CBN superabrasive grains, when compared with conventional abrasive grains, the use of CBN tools reduce the grinding temperatures decreasing the probability of workipece’s thermal damage. These proprieties of CBN grains permit lowering the energy partition because less heat is generated during grinding and much heat is dissipated through the grinding wheel instead of through the workpiece. This paper shows a research about the microstructural changes in the ground subsurface and the differences in the superficial integrity when using two types of superabrasive grinding wheels, manufactured with vitrified and resin bonds, analyzed in different cutting conditions. The ground material was the VC 131 steel, hardened and tempered. Were not observed microstructural changes in the subsurface ground with the two types of tools. As a result, the use of different types of the bonding do not affect the surface integrity neither resulted in microstructural changes, because the maximum temperatures measured in the grinding zone were lower than 125 °C, much less than the required level to cause microstructural changes

The cutting time with abrasive discs can be reduced by the control of the cutting speed

This paper presents an experimental study on the life of abrasive discs in cut-off type operations with two conditions of cutting speed. The cutting time is shown with a comparative analysis of the cutting speed

O Tempo de Corte com Discos Abrasivos Pode Ser Reduzido pelo Controle da Velocidade de Corte

This work presents an experimental study on the life of abrasive discs in cut-off type operations with two conditions of cutting speed. The cutting time is shown with a comparative analysis of the cutting speed

Análise do comportamento de rebolos convencionais na retificação de aços frágeis e dúcteis

The aim of this work war to study the behavior of the plan tangential grinding process with conventional grinding wheels, under several machining conditions and a selected dressing condition. The analysis of the grinding performance was done regarding the cutting surface wear behavior of the grinding wheel for brittle and ductile steels workpieces. The grinding input parameters, which were, cutting speed, workpiece speed and cutting feed, were chosen based on the grinding machine characteristics. The results discussion emphasized the wear mechanism of the grinding wheel cutting surface and the cutting phenomenology of the grinding process

Performance of aerodynamic baffles in cylindrical grinding analyzed on the basis of air layer pressure and speed

Over the years, grinding has been considered one of the most important manufacturing processes. Grinding is a high precision process, and the loss of a single workpiece in this stage of the production is unacceptable, fir the value added to the material is very high due to many processes it has already undergone prior to grinding. This study aims to contribute toward the development of an experimental methodology whereby the pressure and speed of the air layer produced by the high rotation of the grinding wheel is evaluated with and without baffles, i.e., in an optimized grinding operation and in a traditional one. Tests were also carried out with steel samples to check the difference in grinding wheel wear with and without the use of baffles