2,088 research outputs found
NASA Space Flight Vehicle Fault Isolation Challenges
The Space Launch System (SLS) is the new NASA heavy lift launch vehicle in development and is scheduled for its first mission in 2018.SLS has many of the same logistics challenges as any other large scale program. However, SLS also faces unique challenges related to testability. This presentation will address the SLS challenges for diagnostics and fault isolation, along with the analyses and decisions to mitigate risk.
New CMB Power Spectrum Constraints from MSAMI
We present new cosmic microwave background (CMB) anisotropy results from the
combined analysis of the three flights of the first Medium Scale Anisotropy
Measurement (MSAM1). This balloon-borne bolometric instrument measured about 10
square degrees of sky at half-degree resolution in 4 frequency bands from 5.2
icm to 20 icm with a high signal-to-noise ratio. Here we present an overview of
our analysis methods, compare the results from the three flights, derive new
constraints on the CMB power spectrum from the combined data and reduce the
data to total-power Wiener-filtered maps of the CMB. A key feature of this new
analysis is a determination of the amplitude of CMB fluctuations at . The analysis technique is described in a companion paper by Knox.Comment: 9 pages, 6 included figure
Comparing the effects of two inhaled glucocorticoids on allergen-induced bronchoconstriction and markers of systemic effects, a randomised cross-over double-blind study
<p>Abstract</p> <p>Background</p> <p>Inhaled glucocorticoids are efficient in protecting against asthma exacerbations, but methods to compare their efficacy vs systemic effects have only been attempted in larger multi-centre studies. The aim of the current study was therefore to directly compare the effects of two separate inhaled glucocorticoids, mometasone and budesonide, to compare the effects on the early and late asthmatic responses to inhaled allergen in patients with mild allergic asthma, and sputum eosinophils, and to relate the clinical positive effects to any systemic effects observed.</p> <p>Methods</p> <p>Twelve patients with documented early and late asthmatic responses (EAR and LAR) to inhaled allergen at a screening visit were randomized in a double-blind fashion to treatment with mometasone (200 μg × 2 or 400 μg × 2), budesonide (400 μg × 2) or placebo in a double-blind crossover fashion for a period of seven days. Challenge with the total allergen dose causing both an EAR and LAR was given on the last day of treatment taken in the morning. Lung function was assessed using FEV1, and systemic glucocorticoid activity was quantified using 24 h urinary cortisol.</p> <p>Results</p> <p>Mometasone and budesonide attenuate both EAR and LAR to allergen to a similar degree. No significant dose-related effects on the lung function parameters were observed. Both treatments reduced the relative amount of sputum eosinophils (%) after allergen. At the dose of 800 μg daily, mometasone reduced 24 h urinary cortisol by approximately 35%. Both drugs were well tolerated.</p> <p>Conclusions</p> <p>Mometasone and budesonide are equieffective in reducing early and late asthmatic responses induced by inhaled allergen challenge. Mometasone 800 μg given for seven days partially affects the HPA axis.</p
Studies of high temperature sliding wear of metallic dissimilar interfaces
The evolution of microstructures in the glaze layer formed during limited debris retention sliding wear of Nimonic 80A against Stellite 6 at 750 8C and a sliding speed of 0.314 m sK1 (7 N applied load, 4522 m sliding distance) was investigated using scanning electron microscopy (SEM), energy dispersive analysis by X-ray (EDX), X-ray diffraction (XRD), scanning tunnelling microscopy (STM) and transmission electron microscopy (TEM). The collected data indicate the development of a wear resistant nano-structured glaze layer. The process of ‘fragmentation’ involving deformation, generation of dislocations, formation of sub-grains and their increasing refinement causing increasing misorientation was responsible for the formation of nano-structured grains. The rapid formation of this glaze layer from primarily cobalt–chromium debris transferred from (and also back to) the surface of the Stellite 6, kept wear of both the Nimonic 80A and Stellite 6 to very low levels. However, increasing the sliding speed to 0.905 m sK1 (750 8C) suppressed glaze formation with only a patchy, unstable glaze forming on the Stellite 6 counterface and an absence of glaze development on the Nimonic 80A sample (the Nimonic 80A surface was covered with at most, a very thinly smeared layer of oxide). The high levels of oxide debris generated at 0.905 m sK1 instead acted as a loose abrasive assisting wear of especially the Nimonic 80A. This behaviour was attributed to a change in oxide chemistry (due to the dominance of nickel and chromium oxides generated from the Nimonic 80A) resulting in poor oxide sintering characteristics, in combination with increased mobility and reduced residency of the oxide debris at 0.905 m sK1
NASA Space Rocket Logistics Challenges
The Space Launch System (SLS) is the new NASA heavy lift launch vehicle and is scheduled for its first mission in 2017. The goal of the first mission, which will be uncrewed, is to demonstrate the integrated system performance of the SLS rocket and spacecraft before a crewed flight in 2021. SLS has many of the same logistics challenges as any other large scale program. Common logistics concerns for SLS include integration of discreet programs geographically separated, multiple prime contractors with distinct and different goals, schedule pressures and funding constraints. However, SLS also faces unique challenges. The new program is a confluence of new hardware and heritage, with heritage hardware constituting seventy-five percent of the program. This unique approach to design makes logistics concerns such as commonality especially problematic. Additionally, a very low manifest rate of one flight every four years makes logistics comparatively expensive. That, along with the SLS architecture being developed using a block upgrade evolutionary approach, exacerbates long-range planning for supportability considerations. These common and unique logistics challenges must be clearly identified and tackled to allow SLS to have a successful program. This paper will address the common and unique challenges facing the SLS programs, along with the analysis and decisions the NASA Logistics engineers are making to mitigate the threats posed by each
Heterogeneous addiction to transforming growth factor-beta signalling in recessive dystrophic epidermolysis bullosa-associated cutaneous squamous cell carcinoma
Comparing Cosmic Microwave Background Datasets
To extract reliable cosmic parameters from cosmic microwave background
datasets, it is essential to show that the data are not contaminated by
residual non-cosmological signals. We describe general statistical approaches
to this problem, with an emphasis on the case in which there are two datasets
that can be checked for consistency. A first visual step is the Wiener filter
mapping from one set of data onto the pixel basis of another. For more
quantitative analyses we develop and apply both Bayesian and frequentist
techniques. We define the ``contamination parameter'' and advocate the
calculation of its probability distribution as a means of examining the
consistency of two datasets. The closely related ``probability enhancement
factor'' is shown to be a useful statistic for comparison; it is significantly
better than a number of chi-squared quantities we consider. Our methods can be
used: internally (between different subsets of a dataset) or externally
(between different experiments); for observing regions that completely overlap,
partially overlap or overlap not at all; and for observing strategies that
differ greatly.
We apply the methods to check the consistency (internal and external) of the
MSAM92, MSAM94 and Saskatoon Ring datasets. From comparing the two MSAM
datasets, we find that the most probable level of contamination is 12%, with no
contamination only 1.05 times less probable, and 100% contamination strongly
ruled out at over 2 X 10^5 times less probable. From comparing the 1992 MSAM
flight with the Saskatoon data we find the most probable level of contamination
to be 50%, with no contamination only 1.6 times less probable and 100%
contamination 13 times less probable. [Truncated]Comment: LaTeX, 16 pages which include 16 figures, submitted to Phys. Rev.
Recommended from our members
Human Verbal Memory Encoding Is Hierarchically Distributed in a Continuous Processing Stream.
Processing of memory is supported by coordinated activity in a network of sensory, association, and motor brain regions. It remains a major challenge to determine where memory is encoded for later retrieval. Here, we used direct intracranial brain recordings from epilepsy patients performing free recall tasks to determine the temporal pattern and anatomical distribution of verbal memory encoding across the entire human cortex. High γ frequency activity (65-115 Hz) showed consistent power responses during encoding of subsequently recalled and forgotten words on a subset of electrodes localized in 16 distinct cortical areas activated in the tasks. More of the high γ power during word encoding, and less power before and after the word presentation, was characteristic of successful recall and observed across multiple brain regions. Latencies of the induced power changes and this subsequent memory effect (SME) between the recalled and forgotten words followed an anatomical sequence from visual to prefrontal cortical areas. Finally, the magnitude of the memory effect was unexpectedly found to be the largest in selected brain regions both at the top and at the bottom of the processing stream. These included the language processing areas of the prefrontal cortex and the early visual areas at the junction of the occipital and temporal lobes. Our results provide evidence for distributed encoding of verbal memory organized along a hierarchical posterior-to-anterior processing stream
Universities and community-based research in developing countries: community voice and educational provision in rural Tanzania
The main focus of recent research on the community engagement role of universities has been in developed countries, generally in towns and cities and usually conducted from the perspectives of universities rather than the communities with which they engage. The purpose of this paper is to investigate the community engagement role of universities in the rural areas of developing countries, and its potential for strengthening the voice of rural communities. The particular focus is on the provision of primary and secondary education. The paper is based on the assumption that in order for community members to have both the capacity and the confidence to engage in political discourse for improving educational capacity and quality, they need the opportunity to become involved and well-versed in the options available, beyond their own experience. Particular attention is given in the paper to community-based research (CBR). CBR is explored from the perspectives of community members and local leaders in the government-community partnerships which have responsibility for the provision of primary and secondary education in rural Tanzania. The historical and policy background of the partnerships, together with findings from two case studies, provide the context for the paper
- …