The enviornmental assessment of a contemporary coal mining system

A contemporary underground coal mine in eastern Kentucky was assessed in order to determine potential off-site and on-site environmental impacts associated with the mining system in the given environmental setting. A 4 section, continuous room and pillor mine plan was developed for an appropriate site in eastern Kentucky. Potential environmental impacts were identified, and mitigation costs determined. The major potential environmental impacts were determined to be: acid water drainage from the mine and refuse site, uneven subsidence of the surface as a result of mining activity, and alteration of ground water aquifers in the subsidence zone. In the specific case examined, the costs of environmental impact mitigation to levels prescribed by regulations would not exceed $1/ton of coal mined, and post mining land values would not be affected

Effects of temperature upon the collapse of a Bose-Einstein condensate in a gas with attractive interactions

We present a study of the effects of temperature upon the excitation frequencies of a Bose-Einstein condensate formed within a dilute gas with a weak attractive effective interaction between the atoms. We use the self-consistent Hartree-Fock Bogoliubov treatment within the Popov approximation and compare our results to previous zero temperature and Hartree-Fock calculations The metastability of the condensate is monitored by means of the $l=0$ excitation frequency. As the number of atoms in the condensate is increased, with $T$ held constant, this frequency goes to zero, signalling a phase transition to a dense collapsed state. The critical number for collapse is found to decrease as a function of temperature, the rate of decrease being greater than that obtained in previous Hartree-Fock calculations.Comment: 4 pages LaTeX, 3 eps figures. To appear as a letter in J. Phys.

Modeling the buckling and delamination of thin films

I study numerically the problem of delamination of a thin film elastically attached to a rigid substrate. A nominally flat elastic thin film is modeled using a two-dimensional triangular mesh. Both compression and bending rigidities are included to simulate compression and bending of the film. The film can buckle (i.e., abandon its flat configuration) when enough compressive strain is applied. The possible buckled configurations of a piece of film with stripe geometry are investigated as a function of the compressive strain. It is found that the stable configuration depends strongly on the applied strain and the Poisson ratio of the film. Next, the film is considered to be attached to a rigid substrate by springs that can break when the detaching force exceeds a threshold value, producing the partial delamination of the film. Delamination is induced by a mismatch of the relaxed configurations of film and substrate. The morphology of the delaminated film can be followed and compared with available experimental results as a function of model parameters. `Telephone-cord', polygonal, and `brain-like' patterns qualitatively similar to experimentally observed configurations are obtained in different parameter regions. The main control parameters that select the different patterns are the mismatch between film and substrate and the degree of in-plane relaxation within the unbuckled regions.Comment: 8 pages, 10 figure

A Gender Comparison of Economists' Publications

An ordered probit model is used to examine the impact of gender and the quality of the PhD g ranting in stitution o n the publication r ecord of m ale an d f emale economists who received t heir doctorate i n 1985. This analysis indicates th at men an d women have different publ ication pa tterns regardless of where t hey r eceived t heir P hD and t hat the quality of t he P hD granting institution has n o m easurable effect o n an individual's publication record.gender, ordered probit model, journal publications

Regional variation in digital cushion pressure in the forefeet of horses and elephants

In this study, we seek to understand how the digital cushion morphologies evident in horse and elephant feet influence internal and external foot pressures. Our novel use of invasive blood pressure monitoring equipment, combined with a pressure pad and force plate, enabled measurements of (ex vivo) digital cushion pressure under increasing axial loads in seven horse and six elephant forefeet. Linear mixed effects models (LMER) revealed that internal digital cushion pressures increase under load and differ depending on region; elephant feet experienced higher magnitudes of medial digital cushion pressure, whereas horse feet experienced higher magnitudes of centralised digital cushion pressure. Direct comparison of digital cushion pressure magnitudes in both species, at equivalent loads relative to body weight, revealed that medial and lateral pressures increased more rapidly with load in elephant limbs. Within the same approximate region, internal pressures exceeded external, palmar pressures (on the sole of the foot), supporting previous Finite Element (FE) predictions. High pressures and large variations in pressure may relate to the development of foot pathology, which is a major concern in horses and elephants in a captive/domestic environment

Confounding Issues in the Deadweight Loss of Gift-Giving

When a gift is given, someone other than the final consumer makes the consumption choice. Thus there is a possibility that the gift will not match the preferences of the receiver, i.e., the gift will represent a wise use of the money given the gift-giver's tastes but not necessarily a wise use of money given the recipient's tastes. In other words, gift giving can result in a deadweight loss. This paper addresses and clarifies the discrepancy between Waldfogel's (1993) finding of a deadweight loss from gift giving and Solnick and Hemenway's (1996) finding of a deadweight gain from gift giving. It also builds on some of the concerns raised by Ruffle and Tykocinski (2000).

3D hindlimb joint mobility of the stem-archosaur Euparkeria capensis with implications for postural evolution within Archosauria.

Triassic archosaurs and stem-archosaurs show a remarkable disparity in their ankle and pelvis morphologies. However, the implications of these different morphologies for specific functions are still poorly understood. Here, we present the first quantitative analysis into the locomotor abilities of a stem-archosaur applying 3D modelling techniques. μCT scans of multiple specimens of Euparkeria capensis enabled the reconstruction and three-dimensional articulation of the hindlimb. The joint mobility of the hindlimb was quantified in 3D to address previous qualitative hypotheses regarding the stance of Euparkeria. Our range of motion analysis implies the potential for an erect posture, consistent with the hip morphology, allowing the femur to be fully adducted to position the feet beneath the body. A fully sprawling pose appears unlikely but a wide range of hip abduction remained feasible-the hip appears quite mobile. The oblique mesotarsal ankle joint in Euparkeria implies, however, a more abducted hindlimb. This is consistent with a mosaic of ancestral and derived osteological characters in the hindlimb, and might suggest a moderately adducted posture for Euparkeria. Our results support a single origin of a pillar-erect hip morphology, ancestral to Eucrocopoda that preceded later development of a hinge-like ankle joint and a more erect hindlimb posture

Muscongus Bay, Marine Wildlife Inventory and Evaluation

Muscongus Bay, Marine Wildlife Inventory and Evaluation by Alan E. Hutchinson and Sandra J. Lovett Maine Department of Inland Fisheries and Wildlife Augusta, Maine, February, 1984. Contents: Preface / Acknowledgment / List of Tables / List of Figures / Introduction / Resource Inventory / Resource Evaluation / Resource Impact Assessment / Conclusions and Recommendations / References / Appendixhttps://digitalcommons.usm.maine.edu/me_collection/1144/thumbnail.jp