Cloning and Functional Analysis of three Cold Regulated <em>CBF</em> Genes in the Overwintering Crucifer <em>Boechera stricta</em>

In this research, we isolated three CBF (C-repeat-Binding Factors) genes from two genotypes of Boechera stricta with contrasting freezing tolerance and characterized their structure and expression patterns in response to cold treatment. An amino acid sequence comparison revealed that the CBF genes in B. stricta showed high conservation in the AP2 domain and PKKP/RAGR motif like other cold adaptable Brassicaceae. The pairwise sequence alignment of the CBF genes isolated from two genotypes of B. stricta showed non-synonymous mutations in CBF 2 and 3. Gene expression analysis demonstrated that CBF genes in B. stricta have expression patterns similar to CBFs in A. thaliana in response to cold treatment, while differential expression at the molecular level in CBF and COR genes was presented between two genotypes of B. stricta. Our results suggest that signal transduction of three CBF genes can be one of the central pathways in the development of freezing tolerance in B. stricta

Magnetic interactions in transition metal doped ZnO : An abinitio study

We calculate the nature of magnetic interactions in transition-metal doped ZnO using the local spin density approximation and LSDA+\textit{U} method of density functional theory. We investigate the following four cases: (i) single transition metal ion types (Cr, Mn, Fe, Co, Ni and Cu) substituted at Zn sites, (ii) substitutional magnetic transition metal ions combined with additional Cu and Li dopants, (iii) substitutional magnetic transition metal ions combined with oxygen vacancies and (iv) pairs of magnetic ion types (Co and Fe, Co and Mn, etc.). Extensive convergence tests indicate that the calculated magnetic ground state is unusually sensitive to the k-point mesh and energy cut-off, the details of the geometry optimizations and the choice of the exchange-correlation functional. We find that ferromagnetic coupling is sometimes favorable for single type substitutional transition metal ions within the local spin density approximation. However, the nature of magnetic interactions changes when correlations on the transition-metal ion are treated within the more realistic LSDA + \textit{U} method, often disfavoring the ferromagnetic state. The magnetic configuration is sensitive to the detailed arrangement of the ions and the amount of lattice relaxation, except in the case of oxygen vacancies when an antiferromagnetic state is always favored.Comment: 11 pages, 17 figure

Revealing the role of local stress on the depolarization of BNT-BT-based relaxors

Canonical relaxors exhibit an electric-field-induced phase transition between a macroscopically nonpolar and polar phase that can be tuned from being stable at low temperature to being reversible at high temperature. The reversibility of this phase change determines the electromechanical performance and large strains can be achieved if the polar phase is intrinsically unstable. This paper is on the thermal depolarization characteristics of a BNT-BT-based multiphase relaxor ceramic observed through the transition temperature from field-induced polar to nonpolar state. It is shown that the progress of detexturization strongly depends on the crystallographic phase. In the more susceptible phase, it becomes significant about 40 °C below the macroscopically observed transition temperature. Additionally, the surface domain structure vanishes at lower temperatures than expected from both dielectric and structural measurements. The development of strong interfacial stresses aiding depolarization, and a mismatch in chemical pressure between surface and bulk, are discussed as the origins for the observed effects. Tailoring of interfacial stresses through chemical adaption of crystallographic phase fractions opens up a pathway to optimize the strain performance of actuator materials and can become a useful tool to stabilize metastable crystallographic phases as well as for property tuning in piezotronics, Mott insulators and multiferroics

Changes in inorganic aerosol compositions over the Yellow Sea area from impact of Chinese emissions mitigation

Substantial mitigation of air pollutants emissions has been performed since 2013 around Beijing, and changes in the atmospheric characteristics have been expected over the downstream area of Beijing. In this study, both WRF-Chem simulation and on-site measurements were utilized for the Baengnyeong (island) supersite, one of the representative regional background sites located in the Yellow Sea, the entrance area of the long-range transport process in Korea. The changes in the chemical compositions of inorganic aerosols were examined for spring-time during the Chinese emission mitigation period from 2014 to 2016. The measured ratio of ionic species to PM2.5 at the Baengnyeong supersite showed changes in aerosol inorganic chemical compositions from sulfate in 2014 to nitrate in 2015–2016. The modeling results also showed that nitrate was low in 2014 and significantly increased in 2015 and 2016, and the acidic aerosol condition had also changed toward a more neutralized status in both the simulation and the observations. The WRF-Chem modeling study further indicated that the sulfur was not neutralized in 2014. However, in 2015 and 2016, SO2 was more sufficiently neutralized as sulfur emissions were substantially reduced in China, while at the same time nitrate had begun to increase in such a ‘SO2–poor’ condition in Beijing area in China, and thus approaching more enhanced neutralization over the Yellow Sea area. The causes of the higher nitrate based on the modeled characteristics of the ammonia-sulfate-nitrate aerosol formation in response to the SO2 emissions reduction in China are also discussed in this paper

Surface Passivation of CdSe Quantum Dots in All Inorganic Amorphous Solid by Forming Cd1-xZnx Se Shell

CdSe quantum dots (QDs) doped glasses have been widely investigated for optical filters, LED color converter and other optical emitters. Unlike CdSe QDs in solution, it is difficult to passivate the surface defects of CdSe QDs in glass matrix, which strongly suppress its intrinsic emission. In this study, surface passivation of CdSe quantum dots (QDs) by Cd1-xZnx Se shell in silicate glass was reported. An increase in the Se/Cd ratio can lead to the partial passivation of the surface states and appearance of the intrinsic emission of CdSe QDs. Optimizing the heat-treatment condition promotes the incorporation of Zn into CdSe QDs and results in the quenching of the defect emission. Formation of CdSe/ Cd1-xZnx Se core/graded shell QDs is evidenced by the experimental results of TEM and Raman spectroscopy. Realization of the surface passivation and intrinsic emission of II-VI QDs may facilitate the wide applications of QDs doped all inorganic amorphous materials. ? The Author(s) 2017.114Ysciescopu

Water-Repellent TiO₂-Organic Dye-Based Air Filters for Efficient Visible-Light-Activated Photochemical Inactivation against Bioaerosols

Recently, bioaerosols, including the 2019 novel coronavirus, pose a serious threat to global public health. Herein, we introduce a visible-light-activated (VLA) antimicrobial air filter functionalized with titanium dioxide (TiO2)–crystal violet (CV) nanocomposites facilitating abandoned visible light from sunlight or indoor lights. The TiO2–CV based VLA antimicrobial air filters exhibit a potent inactivation rate of ∼99.98% and filtration efficiency of ∼99.9% against various bioaerosols. Under visible-light, the CV is involved in overall inactivation by inducing reactive oxygen species production both directly (CV itself) and indirectly (in combination with TiO2). Moreover, the susceptibility of the CV to humidity was significantly improved by forming a hydrophobic molecular layer on the TiO2 surface, highlighting its potential applicability in real environments such as exhaled or humid air. We believe this work can open a new avenue for designing and realizing practical antimicrobial technology using ubiquitous visible-light energy against the threat of infectious bioaerosols