A facile route to a novel aza-crown ether incorporating three thiophene moieties

The preparation of the first of a novel type of large thiophene-containing aza-crown ether is reported. The macrocycle is synthesised by linking a 3,4-dialkoxythiophene moiety with two 3-hydroxythiophene units and ring closure is effected by reaction with piperazine via the Mannich reaction

Can virtual seminars be used cost‐effectively to enhance student learning?

This paper describes a virtual seminar initiative designed to investigate the extent to which computer‐mediated communication (CMC) can cost‐effectively strengthen staff‐student interaction and enhance student group discussion, and thereby improve collaborative learning. After setting the scene by means of a brief review of the discursive potential of CMC, the establishment of an asynchronous bulletin board system on three modules in the Department of Sociology at the University of Manchester using industry standard software is described. Detailed time diaries kept by all staff involved revealed that organizing and running the virtual seminars were very much less time‐consuming than running face‐to‐face seminars. However, analysis of the students’ access to and mage of the virtual seminars indicates that some of them were disadvantaged by CMC and that they favoured face‐to‐face contact with lecturers over virtual seminars. The latter should therefore be part of a portfolio of teaching techniques rather than the sole form of collaborative learning. The conclusion is that a significant obstacle to benefiting from CMC is the further demand on staff time that results from adding virtual seminars as a supplement to existing teaching practices. Even though these extra demands may be modest, effectively deploying the discursive potential of CMC to enhance student learning increases staff effort rather than reducing it, as many have hoped or promised it would

Understanding how kurtosis is transferred from input acceleration to stress response and it's influence on fatigue life

High cycle fatigue of metals typically occurs through long term exposure to time varying loads which, although modest in amplitude, give rise to microscopic cracks that can ultimately propagate to failure. The fatigue life of a component is primarily dependent on the stress amplitude response at critical failure locations. For most vibration tests, it is common to assume a Gaussian distribution of both the input acceleration and stress response. In real life, however, it is common to experience non-Gaussian acceleration input, and this can cause the response to be non-Gaussian. Examples of non-Gaussian loads include road irregularities such as potholes in the automotive world or turbulent boundary layer pressure fluctuations for the aerospace sector or more generally wind, wave or high amplitude acoustic loads. The paper first reviews some of the methods used to generate non-Gaussian excitation signals with a given power spectral density and kurtosis. The kurtosis of the response is examined once the signal is passed through a linear time invariant system. Finally an algorithm is presented that determines the output kurtosis based upon the input kurtosis, the input power spectral density and the frequency response function of the system. The algorithm is validated using numerical simulations. Direct applications of these results include improved fatigue life estimations and a method to accelerate shaker tests by generating high kurtosis, non-Gaussian drive signals

Growth and dislocation studies of β-HMX

Background: The defect structure of organic materials is important as it plays a major role in their crystal growth properties. It also can play a subcritical role in “hot-spot” detonation processes of energetics and one such energetic is cyclotetramethylene-tetranitramine, in the commonly used beta form (β-HMX). Results: The as-grown crystals grown by evaporation from acetone show prismatic, tabular and columnar habits, all with {011}, {110}, (010) and (101) faces. Etching on (010) surfaces revealed three different types of etch pits, two of which could be identified with either pure screw or pure edge dislocations, the third is shown to be an artifact of the twinning process that this material undergoes. Examination of the {011} and {110} surfaces show only one type of etch pit on each surface; however their natural asymmetry precludes the easy identification of their Burgers vector or dislocation type. Etching of cleaved {011} surfaces demonstrates that the etch pits can be associated with line dislocations. All dislocations appear randomly on the crystal surfaces and do not form alignments characteristic of mechanical deformation by dislocation slip. Conclusions: Crystals of β-HMX grown from acetone show good morphological agreement with that predicted by modelling, with three distinct crystal habits observed depending upon the supersaturation of the growth solution. Prismatic habit was favoured at low supersaturation, while tabular and columnar crystals were predominant at higher super saturations. The twin plane in β-HMX was identified as a (101) reflection plane. The low plasticity of β-HMX is shown by the lack of etch pit alignments corresponding to mechanically induced dislocation arrays. On untwinned {010} faces, two types of dislocations exist, pure edge dislocations with b = [010] and pure screw dislocations with b = [010]. On twinned (010) faces, a third dislocation type exists and it is proposed that these pits are associated with pure screw dislocations with b = [010]

Bedrock geology of DFDP-2B, central Alpine Fault, New Zealand

During the second phase of the Alpine Fault, Deep Fault Drilling Project (DFDP) in the Whataroa River, South Westland, New Zealand, bedrock was encountered in the DFDP-2B borehole from 238.5–893.2 m Measured Depth (MD). Continuous sampling and meso- to microscale characterisation of whole rock cuttings established that, in sequence, the borehole sampled amphibolite facies, Torlesse Composite Terrane-derived schists, protomylonites and mylonites, terminating 200–400 m above an Alpine Fault Principal Slip Zone (PSZ) with a maximum dip of 62°. The most diagnostic structural features of increasing PSZ proximity were the occurrence of shear bands and reduction in mean quartz grain sizes. A change in composition to greater mica:quartz + feldspar, most markedly below c. 700 m MD, is inferred to result from either heterogeneous sampling or a change in lithology related to alteration. Major oxide variations suggest the fault-proximal Alpine Fault alteration zone, as previously defined in DFDP-1 core, was not sampled

NCeSS Project : Data mining for social scientists

We will discuss the work being undertaken on the NCeSS data mining project, a one year project at the University of Manchester which began at the start of 2007, to develop data mining tools of value to the social science community. Our primary goal is to produce a suite of data mining codes, supported by a web interface, to allow social scientists to mine their datasets in a straightforward way and hence, gain new insights into their data. In order to fully define the requirements, we are looking at a range of typical datasets to find out what forms they take and the applications and algorithms that will be required. In this paper, we will describe a number of these datasets and will discuss how easily data mining techniques can be used to extract information from the data that would either not be possible or would be too time consuming by more standard methods

CNS inflammation other than multiple sclerosis: how likely is diagnosis?

The incidence, diagnostic landscape, and workload impact of CNS inflammatory diseases other than multiple sclerosis (MS) (CIDOMS) in a tertiary setting is unknown. We describe a retrospective case series of 64 patients identified over a 2-year period (2009–2010) at the Wessex Neurological Centre in the United Kingdom, accounting for 4% of all patients seen at the center. As expected, neurosarcoidosis and neuromyelitis optica (NMO) were the most common diagnoses reached (14% each); other diagnoses singly accounted for <10%. However, the likeliest diagnostic outcome (strikingly, in 25%) was nondiagnosis, despite intensive investigation and a mean follow-up period of 3 years. Undiagnosed patients with CIDOMS represented the largest workload of the neurology center