Origin of different deactivation of Pd/SnO₂ and Pd/GeO₂ catalysts in methanol dehydrogenation and reforming: A comparative study

Pd particles supported on SnO2 and GeO2 have been structurally investigated by X-ray diffraction, (High-Resolution) transmission and scanning electron microscopy after different reductive treatments to monitor the eventual formation of bimetallic phases and catalytically tested in methanol dehydrogenation/reforming. For both oxides this included a thin film sample with well-defined Pd particles and a powder catalyst prepared by incipient wetness impregnation. The hexagonal and the tetragonal polymorph were studied for powder GeO2. Pd2Ge formation was observed on all GeO2-supported catalysts, strongly depending on the specific sample used. Reduction of the thin film at 573 K resulted in full transformation into the bimetallic state. The partial solubility of hexagonal GeO2 in water and its thermal structural instability yielded Pd2Ge formation at 473 K, at the cost of a structurally inhomogeneous support and Ge metal formation at higher reduction temperatures. Pd on tetragonal GeO2 entered a state of strong metal–support interaction after reduction at 573–673 K, resulting in coalescing Pd2Ge particles on a sintered and re-crystallized support, apparently partially covering the bimetallic particles and decreasing the catalytic activity. Pd2Ge on amorphous thin film and hexagonal GeO2 converted methanol primarily via dehydrogenation to CO and H2. At 573 K, formation of Pd2Sn and also PdSn occurred on the Pd/SnO2 thin film. Pd3Sn2 (and to some extent Pd2Sn) were predominantly obtained on the respective powder catalyst. Strong deactivation with increasing reduction temperature was observed, likely not based on the classical strong metal–support interaction effect, but rather on a combination of missing active structural ensembles on Sn-enriched bimetallic phases and the formation of metallic β-Sn. Correlations to Pd and its bimetallics supported on ZnO, Ga2O3 and In2O3 were also discussed

The Physiology of Vasodilatation

Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/68237/2/10.1177_000331976101200602.pd

Heat capacity and phase equilibria of hollandite polymorph of KAlSi 3 O 8

The low-temperature heat capacity ( C p ) of KAlSi 3 O 8 with a hollandite structure was measured over the range of 5–303 K with a physical properties measurement system. The standard entropy of KAlSi 3 O 8 hollandite is 166.2±0.2 J mol −1  K −1 , including an 18.7 J mol −1  K −1 contribution from the configurational entropy due to disorder of Al and Si in the octahedral sites. The entropy of K 2 Si 4 O 9 with a wadeite structure (Si-wadeite) was also estimated to facilitate calculation of phase equilibria in the system K 2 O–Al 2 O 3 –SiO 2 . The calculated phase equilibria obtained using Perple_x are in general agreement with experimental studies. Calculated phase relations in the system K 2 O–Al 2 O 3 –SiO 2 confirm a substantial stability field for kyanite–stishovite/coesite–Si-wadeite intervening between KAlSi 3 O 8 hollandite and sanidine. The upper stability of kyanite is bounded by the reaction kyanite (Al 2 SiO 5 ) = corundum (Al 2 O 3 )  + stishovite (SiO 2 ), which is located at 13–14 GPa for 1,100–1,400 K. The entropy and enthalpy of formation for K-cymrite (KAlSi 3 O 8 ·H 2 O) were modified to better fit global best-fit compilations of thermodynamic data and experimental studies. Thermodynamic calculations were undertaken on the reaction of K-cymrite to KAlSi 3 O 8 hollandite +  H 2 O, which is located at 8.3–10.0 GPa for the temperature range 800–1,600 K, well inside the stability field of stishovite. The reaction of muscovite to KAlSi 3 O 8 hollandite + corundum + H 2 O is placed at 10.0–10.6 GPa for the temperature range 900–1,500 K, in reasonable agreement with some but not all experiments on this reaction.Peer Reviewedhttp://deepblue.lib.umich.edu/bitstream/2027.42/46910/1/269_2006_Article_63.pd