The Decay Lifetime of Polarized Fermions in Flight

Based on the parity violation in Standard model, we study the dependence of lifetime on the helicity of an initial-state fermion in weak interactions. It is pointed out that if the initial fermions in the decays are longitudinally polarized, then the decay lifetime of left-handed polarized fermions is different from that of right-handed polarized fermions in flight with a same velocity in a same inertial system.Comment: 7 pages, Late

Giant Impact Induced Atmospheric Blow-Off

Previous calculations indicate that the Earth suffered impacts from objects up to Mars size. Such a giant impact may have produced a temporary ejecta-based ring that accreted to form the Moon. To simulate the surface waves from such events we approximated the cratering source as a buried pressurized sphere. For a 10^27 J impactor we calculated the resulting surface wave using the mode summation method of Sato et al.. For such an impact, the solid Earth free-surface velocity above, and antipodal to, the source achieves 2.6 and 1.9 km/s. Such large ground motions pump the atmosphere and result in upward particle motions which cause the atmosphere to be accelerated to excess of the escape velocity (11.2 km/s) at high altitudes. For a 1.3 × 10^32 J Moon-forming impact we calculate that ~50% of the Earth's atmosphere is accelerated to escape

Ellipsometry noise spectrum, suspension transfer function measurement and closed-loop control of the suspension system in the Q & A experiment

The Q & A experiment, aiming at the detection of vacuum birefringence predicted by quantum electrodynamics, consists mainly of a suspended 3.5 m Fabry-Perot cavity, a rotating permanent dipole magnet and an ellipsometer. The 2.3 T magnet can rotate up to 10 rev/s, introducing an ellipticity signal at twice the rotation frequency. The X-pendulum gives a good isolation ratio for seismic noise above its main resonant frequency 0.3 Hz. At present, the ellipsometry noise decreases with frequency, from 1*10^{-5} rad Hz^{-1/2} at 5 Hz, 2*10^{-6} rad Hz^{-1/2} at 20 Hz to 5*10^{-7} rad Hz^{-1/2} at 40 Hz. The shape of the noise spectrum indicates possible improvement can be made by further reducing the movement between the cavity mirrors. From the preliminary result of yaw motion alignment control, it can be seen that some peaks due to yaw motion of the cavity mirror was suppressed. In this paper, we first give a schematic view of the Q & A experiment, and then present the measurement of transfer function of the compound X-pendulum-double pendulum suspension. A closed-loop control was carried out to verify the validity of the measured transfer functions. The ellipsometry noise spectra with and without yaw alignment control and the newest improvement is presented.Comment: 7 pages, 5 figures, presented in 6th Edoardo Amaldi Conference on Gravitational Waves, June 2005, Okinawa Japan and submitted to Journal of Physics: Conference Series. Some modifications are made according to the referee's comments: mainly to explain the relation between the displacement of cavity mirror and the ellipticity noise spectru

Antiparticle in Light of Einstein-Podolsky-Rosen Paradox and Klein Paradox

The original version of Einstein-Podolsky-Rosen (EPR) paradox and the Klein paradox of Klein-Gordon (KG) equation are discussed to show the necessity of existence of antiparticle with its wavefunction being fixed unambiguously. No concept of "hole" is needed.Comment: 4 pages, 0 figures. Accepted by Chinese Phys. Let

Single Crystal Growth and Characterization of the Iron-Based Superconductor KFe2As2 Synthesized by KAs Flux Method

Centimeter sized platelet single crystals of KFe2As2 were grown using a self-flux method. An encapsulation technique using commercial stainless steel container allowed the stable crystal growth lasting for more than 2 weeks. Ternary K-Fe-As systems with various starting compositions were examined to determine the optimal growth conditions. Employment of KAs flux led to the growth of large single crystals with the typical size of as large as 15 mm x 10 mm x 0.4 mm. The grown crystals exhibit sharp superconducting transition at 3.4 K with the transition width 0.2 K, as well as the very large residual resistivity ratio exceeding 450, evidencing the good sample quality.Comment: 4 pages, 6 Postscript figure

A nonlocal eigenvalue problem and the stability of spikes for reaction-diffusion systems with fractional reaction rates

We consider a nonlocal eigenvalue problem which arises in the study of stability of spike solutions for reaction-diffusion systems with fractional reaction rates such as the Sel'kov model, the Gray-Scott system, the hypercycle Eigen and Schuster, angiogenesis, and the generalized Gierer-Meinhardt system. We give some sufficient and explicit conditions for stability by studying the corresponding nonlocal eigenvalue problem in a new range of parameters

Deregulation of power systems in Asia: Special consideration in developing countries

Power industry is undergoing restructuring throughout the world. The traditional vertically monopolistic structure has been deregulated and replaced by gencos, transcos and discos with competition introduced to gencos and discos in order to reach higher efficiency in electricity production and utilization. A lot of power markets have been established for the purpose. However for different countries, the principal objectives and considerations of power system deregulation are different. In this paper special considerations on power system deregulation of developing countries in Asia are discussed. Two regional power markets in China are used as examples. It is shown that for developing countries, the main objectives of power system deregulation are to attract various investments to power industry in order to meet the fast growth of electric demand caused by blooming economy and in the meantime to reduce government commitment and functions in power industry. Only this way, the power industry, as a significant infrastructure, can realize sustainable development at high efficiency. It is also shown that in the market environment, how to realize optimal system planning and reliable operation at acceptable electricity prices with qualifies service and how to transit to the market environment smoothly at lowest costs and lowest risks should be considered thoroughly. © 2005 IEEE.published_or_final_versio

Reversible Embedding to Covers Full of Boundaries

In reversible data embedding, to avoid overflow and underflow problem, before data embedding, boundary pixels are recorded as side information, which may be losslessly compressed. The existing algorithms often assume that a natural image has little boundary pixels so that the size of side information is small. Accordingly, a relatively high pure payload could be achieved. However, there actually may exist a lot of boundary pixels in a natural image, implying that, the size of side information could be very large. Therefore, when to directly use the existing algorithms, the pure embedding capacity may be not sufficient. In order to address this problem, in this paper, we present a new and efficient framework to reversible data embedding in images that have lots of boundary pixels. The core idea is to losslessly preprocess boundary pixels so that it can significantly reduce the side information. Experimental results have shown the superiority and applicability of our work