Dielectric mixtures -- electrical properties and modeling

In this paper, a review on dielectric mixtures and the importance of the numerical simulations of dielectric mixtures are presented. It stresses on the interfacial polarization observed in mixtures. It is shown that this polarization can yield different dielectric responses depending on the properties of the constituents and their concentrations. Open question on the subject are also introduced.Comment: 40 pages 12 figures, to be appear in IEEE Trans. on Dielectric

Highly structured graphene polyethylene nanocomposites

This research presents an overview of the properties of highly structured, low density polyethylene-graphene nanoplatelets (LDPE-GnP). The influence of nanofiller content, size and processing conditions on the material properties have been investigated. Therefore, rheological and thermal nanocomposite properties were investigated. So-called dry-coating method has been used in order to prepare masterbatches which were thereafter extruded by means of single screw extruder resulting in a strong anisotropy in the extruded samples. Graphene nanoplatelets were oriented in the extrusion direction for all shear rates and flow histories investigated, as confirmed by scanning electron microscopy. The rheological percolation was determined via nonlinear parameters to be around 11wt%. Thermal conductivity measurements revealed strong anisotropy with in-plane conductivity increasing with GnP content

Frequency Domain Measurements for Diagnosis of Power Transformers: Experiences from Australia, Malaysia, Sri Lanka and UK

This is the author accepted manuscript. The final version is available from CIGRE via the link in this recordPower transformers and their performance and reliability in electric power networks are important research issues of power systems. Much information has already been collected and reported; however, it is rare to report comparisons of transformer service performance under different geographical locations and working conditions. CIGRE Working Group A2.37 collected information on 964 transformer failures from 58 utilities and 21 countries covering the period from 1996 to 2009. The main failure modes included failures in windings, tap changers, bushings, insulation, and core. As estimated, based on available literature, nearly 50% of the failures could be related to transformer windings and insulation. This collective paper summarizes experiences from the use of diagnostic tools based on frequency domain measurements at different geographical regions of the world. It starts with a short introduction to response measurements in frequency domain for condition assessment of transformers; then theoretical backgrounds of the two widely used response measurements, namely Frequency Dielectric Spectroscopy (FDS) and Frequency Response Analysis (FRA), are presented. Afterward details of tested transformers and measurement procedures are described for which selected set of FDS and FRA measurement results are analysed for respectively elucidating their potential in assessment of moisture content, ageing degree and fault identi cation