Photodiagnostics of turbulent flows using laser-induced fluorescence

An optical probe technique that will allow remote measurements of temperature (and density), along with their time dependent fluctuations, to be made in a supersonic turbulent wind tunnel flow was developed. Laser-induced fluorescence from nitric oxide which was seeded into the flowing gas medium (nitrogen) at low concentrations was used. The fluorescence emission intensity following laser excitation of the nitric oxide (NO) ground state rotational levels is then related to thermodynamic quantities of the bulk fluid

Self-phase-locked frequency-by-two divider OPO with a residual fractional frequency instability of 8.1O(-18)

We directly measure the phase difference between the subharmonic waves of a self-phase-locked frequency by-2-divider OPO using a phase-sensitive detector scheme. The relative frequency instability of frequency division by 2 is measured to be 8.10(-18

Two-photon excitation of nitric oxide fluorescence as a temperature indicator in unsteady gas-dynamic processes

A laser induced fluorescence technique, suitable for measuring fluctuating temperatures in cold turbulent flows containing very low concentrations of nitric oxide is described. Temperatures below 300 K may be resolved with signal to noise ratios greater than 50 to 1 using high peak power, tunable dye lasers. The method relies on the two photon excitation of selected ro-vibronic transitions. The analysis includes the effects of fluorescence quenching and shows the technique to be effective at all densities below ambient. Signal to noise ratio estimates are based on a preliminary measurement of the two photon absorptivity for a selected rotational transition in the NO gamma (0,0) band

The two-photon absorptivity of rotational transitions in the A2 Sigma hyperon + (v prime = O) - X-2 pion (v prime prime = O) gamma band of nitric oxide

A predominantly single-mode pulsed dye laser system giving a well characterized spatial and temporal output suitable for absolute two-photon absorptivity measurements was used to study the NO gamma(0,0) S11 + R21 (J double prime = 7-1/2) transition. Using a calibrated induced-fluorescence technique, an absorptivity parameter of 2.8 + or - 1.4 x 10 to the minus 51st power cm to the 6th power was obtained. Relative strengths of other rotational transitions in the gamma(0,0) band were also measured and shown to compare well with predicted values in all cases except the O12 (J double prime = 10-1/2) transition

Optical measurements of fluctuating temperatures in a supersonic turbulent flow using one- and two-photon, laser-induced fluorescence

A laser-induced fluorescence technique was developed that provides a practical means of nonintrusively measuring the instantaneous temperatures in low-temperature turbulent flows. The capabilities of the method are reviewed, and its application to a simple, two-dimensional, turbulent boundary-layer flow at Mach 2 is reported. Measurements of the average temperature distribution through the boundary layer and the magnitudes of temperature fluctuations about their average values are presented

Optical stark effect in the 2-photon spectrum of NO

A large optical Stark effect has been observed in the two-photon spectrum X(2)Pi yields A(2)Sigma(+)_ in NO. It is explained as a near-resonant process in which the upper state of the two-photon transition is perturbed by interactions with higher-lying electronic states coupled by the laser field. A theoretical analysis is presented along with coupling parameters determined from ab initio wave functions. The synthetic spectrum reproduces the major experimental features

Mid-infrared wavelength- and frequency-modulation spectroscopy with a pump-modulated singly-resonant optical parametric oscillator

We describe the implementation of the wavelength- and frequency-modulation spectroscopy techniques using a singly-resonant optical parametric oscillator (OPO) pumped by a fiber-amplified diode laser. Frequency modulation of the diode laser was transferred to the OPO¿s mid-infrared idler output, avoiding the need for external modulation devices. This approach thus provides a means of implementing these important techniques with powerful, widely tunable, mid-infrared sources while retaining the simple, flexible modulation properties of diode lasers