A Comparative Study on the Electromechanical Properties of 3D-Printed Rigid and Flexible Continuous Wire Polymer Composites for Structural Health Monitoring

In this study, the electromechanical properties of two different three-dimensional (3D) printed continuous wire polymer composites (CWPC) were characterized and compared. The two composite materials were copper wire polylactic acid (PLA) composite (rigid material) and copper wire polyurethane (PU) composite (flexible material). The electromechanical measurements were based on piezoresistive properties of the sensor at which the mechanical strain and the electrical resistance were correlated under a uniaxial loading condition. Both types of materials exhibited a direct linear relationship between the two quantities, indicating the ability of CWPC to be used for strain sensing applications. The gauge factor (GF) sensitivity was compared for the two types of materials. It was found that there is no statistical significance difference between the GF of PLA CWPC (1.36 ± 0.14) and PU CWPC (1.29 ± 0.07)); therefore, the sensing property depends mainly on the wire integrated into the 3D-printed structure rather than the matrix. Thus, different matrices can be used to fit different applications. An analytical model for GF showed agreement with the experimental results for both materials. PU CWPC showed significant improvement in both Young’s modulus (E) and ultimate tensile strength (UTS) (210.5 % and 31.86 %, respectively), compared with pure PU, while the change in Poisson’s ratio (ν) was insignificant. Young’s modulus of PLA CWPC was significantly increased by 80.3 % compared with PLA, while UTS and ν did not significantly change. The experimental mechanical properties showed good agreement with data from the analytical models. The outcome of this study focused on the manufacturing of 3D-printed functionalized structure for strain sensing applications with improved mechanical properties. The wide range of attained strain allowed their use in different applications based on the range of strain needed, such as rigid sports equipment and flexible wearable sensors.Natural Sciences and Engineering Research Council Canada (NSERC) RGPIN- 2018-0589

Fatigue behavior and electromechanical properties of additively manufactured continuous wire polymer composites for structural health monitoring

The fatigue behaviour of continuous wire polymer composite (CWPC) fabricated by fused filament fabrication was investigated. Four compositions were examined: polylactic acid (PLA), PLA with copper wire (Cu), thermoplastic polyurethane (TPU), and TPU with Cu wire. Residual properties were measured after different sets of number of cycles (102, 104, 105). CWPC electromechanical properties under fatigue test demonstrated reverse piezoresistivity behavior. A strain-controlled fatigue life analytical model was compared to the experimental results showing good agreement. This study demonstrates the applicability of FFF technique to print sensors with continuous integrated wire with tunable properties.The authors would like to thank the Natural Science and Research Council (NSERC) Canada [RGPIN- 2018-05899] for the funding support of this study